Scribd Logo
Upload

Welcome to Scribd!

  • 130 views

    STEIGER Raba K598

    Uploaded by

    totcsab
    STEIGER Raba K598 manual

    Copyright:

    © All Rights Reserved
    Download as PDF or read online from Scribd

    STEIGER Raba K598

    Uploaded by

    totcsab
    130 views7 pages
    STEIGER Raba K598 manual

    Copyright

    © © All Rights Reserved

    Available Formats

    PDF or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    STEIGER Raba K598 manual

    Copyright:

    © All Rights Reserved
    Download as PDF or read online from Scribd
    Download as pdf
    130 views7 pages

    STEIGER Raba K598

    Uploaded by

    totcsab
    STEIGER Raba K598 manual

    Copyright:

    © All Rights Reserved
    Download as PDF or read online from Scribd
    Download as pdf
    of 7
    STEIGER/RABA AXLE Differential Cutaway Illustration cca3. STEIGER/RABA AXLE Disassembly Of Differential Section Stop 16 Diain all oil from axle as outlined at beginning of Hub disassembly pp. CC-7. IMPORTANT: /f breakage of metal partictes are found ‘in differential area drain all off from entire axle. Flush with fuer olf and remove ali contamination. Fill with fresh oil. Follow steps 1 through 5 to disassemble hubs and pull left and right axle shafts from differential section, A Figure 16 Step 17 Remove bolts from differential housing holder and axle housing. Place chain lift in place in threaded holes on opposite sides of the differential housing, Figure 17 NOTE: Check the backlash of the ring gear and pinion before disassembly of the differential assembly. Backlash should be reset the same if the original gears are replaced. (See figure 17 ey Sy Figure 18 ‘Step 18Remove the cotter pin from the pinion shaft ‘nut. Remove the castle nut from the pinion shaft. Step 19 Pull the drive yoke from pinion shaft. (see figure 18) Step 20Remove the seal plate from the pinion shaft. (see figure 18) cog ——————+ a ‘Support 4 sleeve a ‘Support Figure 19 Step 21 Press out the pinion shaft from the bearing holder. NOTE: Keep the spacer ring and spacer sleeve in one assembly for reassembly. Use the same spacer ring and ‘spacer sleeve for trial reassembly. Atter trial test of preload on the pinion bearings change the spacer ‘loaves as necessary to set correct prefoad. [See steps 38 to 41, differential reassembly. | Step 22 Press out the bearing cups from the bearing holder. This is necessary only when new bearings are being installed. NOTE: 1/ pinion bevel gear is damaged or worn, tt must be replaced with a new ring and pinion gear. Both gears ‘must have the same “wear in” pattern, Disassembly Of Ring Gear/ Differential Housing Figure 20 STEIGER/RABA AXLE NOTE: Mark the adjusting nuts at each side of the differential for position. This is necessary to position the differential upon reassembly, it the same gear set is being reused. |See figure 271 ‘Step 23Remova the lock plate from each adjuster nut ‘and mark the nut and housing with a center punch or chisel for position. (see figure 20) Mark lock slot and note thread engagement position

    You might also like