15W DC-DC Single Output Switching Power Supply P S D - 1 5 series

User’s Manual
■ Features :

Protections:Short circuit/Over load /Over voltage/
Polarity

Cooling by free air convection
100% full load burn-in test
Low cost
High reliability
2 year warranty

om
SPECIFICATION TPTC004
MODEL PSD-15A-05 PSD-15B-05 PSD-15C-05 PSD-15A-12 PSD-15B-12 PSD-15C-12 PSD-15A-24 PSD-15B-24 PSD-15C-24
DC VOLTAGE 5V 12V 24V
RATED CURRENT 3A 1.25A 0.6A

.c
CURRENT RANGE 0 ~ 3A 0 ~ 1.25A 0 ~ 0.6A
RATED POWER 15W 15W 14.4W
OUTPUT RIPPLE & NOISE (max.) Note.2 50mVp-p 100mVp-p 100mVp-p
VOLTAGE TOLERANCE Note.3 ±2.0% ±2.0% ±2.0%

INPUT
LINE REGULATION
LOAD REGULATION
SETUP, RISE, HOLD UP TIME
VOLTAGE RANGE
EFFICIENCY(Typ.)
±1.0%
±1.0%

74% 78%
ck ±1.0%
±1.0%
2.5s, 25ms, ----/12VDC/24VDC/48VDC at full load
A: 9.2 ~18VDC (12VDC) B:18 ~ 36VDC (24VDC)
78% 67%
C:36~72VDC(48VDC)
78% 78%
±0.5%
±0.5%

72% 78% 79%

DC CURRENT(Typ.) 1.9A/12VDC 0.9A/24VDC 0.45A/48VDC
he
105% ~150% rated output power
OVER LOAD
Protection type : hiccup mode ,recovery automatically after fault condition is removed
PROTECTION
5.75 ~ 6.75V 13.8~ 16.2V 27.6 ~ 32.4V
OVER VOLTAGE
Protection type : Shut off o/p voltage, clamping by zener diode
WORKING TEMP. -10 ~ +60℃ (Refer to "Derating Curve")
WORKING HUMIDITY
C

20 ~ 95% RH non-condensing
ENVIRONMENT STORAGE TEMP., HUMIDITY -20 ~ +85℃, 10 ~ 95% RH
TEMP. COEFFICIENT ±0.05%/℃ (0 ~ 50℃)
VIBRATION 10 ~ 500Hz, 2G 10min./1cycle, Period for 60min.each along X, Y, Z axes
SAFETY STANDARDS
ck

EAC TP TC 004 approved

WITHSTAND VOLTAGE I/P-O/P:2.0KVAC
SAFETY &
EMC ISOLATION RESISTANCE I/P-O/P:100M Ohms/500VDC / 25℃/ 70% RH
(Note 4) EMI CONDUCTION&RADIATION Compliance to BS EN/EN55032(CISPR32) CLASS B, EAC TP TC 020
EMS IMMUNITY Compliance to BS EN/EN61000-4-2,3,4,6,8,BS EN/EN55024, BS EN/EN61000-6-1,light industry level,criteria A,EAC TP TC 020
MTBF 740.4Khrs min. MIL-HDBK-217F(25℃)
o

OTHERS
DIMENSION 94*49*25mm (L*W*H)
PACKING 81g;120pcs/10.72Kg/0.9CUFT
St

NOTE 1.All parameters NOT specially mentioned are measured at normal input,rated load and 25 of ambient temperature.
2.Ripple & noise are measued at 20 MHz of bandwidth by using a 12inch twisted pair-wire termined with a 0.1uf & 47uf capacitor.
3.Tolerance:includes set up tolerance,line regulation and load regulation.
4.The power supply is considered a component which will be installed into a final equipment. All the EMC tests are been executed by mounting the unit on
a 230mm*230mm metal plate with 1mm of thickness. The final equipment must be re-confirmed that it still meets EMC directives. For guidance on how to
perform these EMC tests, please refer to “EMI testing of component power supplies.” (as available on http://www.meanwell.com)
5.The ambient temperature derating of 3.5℃/1000m with fanless models and of 5℃/1000m with fan models for operating altitude higher than 2000m(6500ft).
※ Product Liability Disclaimer：For detailed information, please refer to https://www.meanwell.com/serviceDisclaimer.aspx

File Name:PSD-15-SPEC 2021-09-15

 15W DC-DC Single Output Switching Power Supply P S D - 1 5 series
Mechanical Specification Unit:mm
94
3.5 87

4-3.5 Dia
Mounting Holes

26
1

4
2
CN2
1

om
49

42
4 4

2
3
CN1
7.5
3.5

.c
25
3 max.

DC Input Connector (CN1) : JST B3P-VH or equivalent

Pin No.
1
Assignment
-V
Mating Housing

JST VHR
Terminal

JST SVH-21T-P1.1
ck DC Output Connector (CN2) : JST B2P-VH or equivalent
Pin No.
1
Assignment
-V
Mating Housing
JST VHR
or equivalent
Terminal
JST SVH-21T-P1.1
or equivalent
2 No Pin or equivalent or equivalent 2 +V
he
3 +V

Block Diagram fosc : 100KHz

RECTIFIERS +V
EMI POWER
C

I/P SWITCHING &

FILTER -V
FILTER

PWM DETECTION
OLP
ck

CONTROL CIRCUIT

Output Derating
o

100
St

80

60
LOAD (%)

40

20

-10 0 10 20 30 40 50 60 (HORIZONTAL)
-10 45 55 (VERTICAL)

AMBIENT TEMPERATURE ( )

File Name:PSD-15-SPEC 2021-09-15