A319 - A320 - A321 - LUS - (AMM) (27-23-51-000-002-A Removal of The Electronic Module of The Rudder Travel Li... )
A319 - A320 - A321 - LUS - (AMM) (27-23-51-000-002-A Removal of The Electronic Module of The Rudder Travel Li... )
A319 - A320 - A321 - LUS - (AMM) (27-23-51-000-002-A Removal of The Electronic Module of The Rudder Travel Li... )
Zone(s):325
Effective on: 001-999
WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR
NEAR:
• THE FLIGHT CONTROLS
• THE FLIGHT CONTROL SURFACES
• THE LANDING GEAR AND THE RELATED DOORS
• COMPONENTS THAT MOVE.
MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO
THE EQUIPMENT.
98D27207545000 3 PIN-RIGGING
C. Referenced Information
REFERENCE DESIGNATION
24-41-00-861-002-A Energize the Aircraft Electrical Circuits from the External Power
24-41-00-862-002-A De-energize the Aircraft Electrical Circuits Supplied from the External Power
24-41-00-862-002-A-01 De-energize the Aircraft Electrical Circuits Supplied from the APU
24-41-00-862-002-A-02 De-energize the Aircraft Electrical Circuits Supplied from the Engine 1(2)
29-00-00-864-001-A Put the Related Hydraulic System in the Depressurized Configuration before Maintenance Action
29-10-00-863-003-A Pressurize the Blue Hydraulic System with a Hydraulic Ground Power-Cart
29-10-00-863-003-A-01 Pressurize the Blue Hydraulic System with the Blue Electric Pump
Electronic Module
3. Job Set-up
SUBTASK 861-051-A
A. Energize the aircraft electrical circuits. Ref. 24-41-00-861-002-A Ref. 24-41-00-861-002-A-01 Ref. 24-41-00-861-002-A-02
SUBTASK 865-056-A
SUBTASK 860-053-A
WARNING: MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS SURFACES ARE
CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR
DAMAGE TO EQUIPMENT.
(1) Pressurize the Blue hydraulic system with the electric pump. Ref. 29-10-00-863-003-A Ref. 29-10-00-863-003-A-01
(3) Make sure that the RUD TRIM indicator on the panel 110VU of the center pedestal shows zero.
(4) Release the FLT CTL/FAC 1 pushbutton switch on the overhead panel 23VU and the OFF legend comes on.
(5) Release the FLT CTL/FAC 2 pushbutton switch on the overhead panel 24VU and the OFF legend comes on.
SUBTASK 865-054-A
D. Open, safety and tag the circuit breaker(s) that follow(s). Use the SAFETY CLIP - CIRCUIT BREAKER as necessary.
SUBTASK 860-052-A
(1) Make sure that the hydraulic systems are depressurized and put them in the maintenance configuration
Ref. 29-00-00-864-001-A
(2) De-energize the aircraft electrical circuits. Ref. 24-41-00-862-002-A Ref. 24-41-00-862-002-A-01
Ref. 24-41-00-862-002-A-02
(3) Put the WARNING NOTICE(S) in the flight compartment to tell persons not to operate the flight controls.
SUBTASK 010-051-A
F. Get Access
(1) Put the ACCESS PLATFORM 10M (33 FT) - ADJUSTABLE in position at zone 325.
(2) Open the access panels 325DL (accpan) and 325CL (accpan) or 325DR (accpan) and 325CR (accpan) at the trailing
edge of the vertical stabilizer.
SUBTASK 480-051-A
(1) Put a PIN-RIGGING (98D27207545000) (4) in the bellcrank assembly for the travel limitation unit (1).
(2) Put a PIN-RIGGING (98D27207545000) and a PIN-RIGGING (98D27207545000) (4) in each lever of the travel
limitation unit (1).
4. Procedure
SUBTASK 020-051-A
(1) Cut and remove the lockwire which safeties the captive bolts (3).
(3) Remove the electronic module (2) from the travel limitation unit (1).
Next Task
Z325 A
325DL(325DR)
A
325CL(325CR)
1
(4CC) B
4
C
TYPICAL IN
4 POSITIONS
3
N_MM_272351_4_ACM0_01_00
Electronic Module
Electronic Module (Sheet 1 of 1)
[Applicable to: 001-999]