Technical Specs 2-Pager

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

HSP650-S12A

650 Watt DC-DC Power Module


400 x 41 × 130mm

Features:

 -48VDC Input (36 -75Vin Range)


 53.5VDC Output (42-58Vout Range)
 Front Panel On/OFF Switch & LED Indicators
 3.3VSB / 500mA Standby Power
 I2C, RS485 and Analog Status & Control
 OCP / OVP / OTP Protection Circuits
 International Safety Approvals
 2 Year Warranty

INPUT SPECIFICATIONS GENERAL SPECIFICATIONS


Input Voltage Range -36 ~ -75 VDC Input Range Operating Temp -33°C to 65°C (full load)
Input Current 60A Max Temp Derating Derate Linearly from 55-65°C to 80% Load
Efficiency ≥92 % at 40Vin, 53.5Vout, 50% Load Storage Temp -40°C to 70°C
Polarity Protection Reverse Input shall not damage the unit Operating Humidity 10%-95%RH(non-condensing)
UnderVoltage Protection -29 ~ -35 VDC (Recover -31 ~ -36 VDC) Storage Humidity 5%-95% RH(non-condensing)
Altitude < 5000m
OUTPUT SPECIFICATIONS Cooling Internal Ball Bearing Fans
Output Voltage 53.5VDC Nominal, 42 ~ 58VDC adjustment range Vibration 5-9Hz,3.5mm, 9-200Hz:1g, 3 axes, 5 times
Output Current 42 Aamps max continuous Impact 11mS/5g; 6directions; 3 times each
Output Power 2200 Watts (derate to 1800 Watts 36-40Vin Range) Drop Test <10Kg 0.10m;10~25Kg 0.0-75m;25~50Kg 0.05m;≥50Kg
0.025m
Over Voltage Protection 28.2-60 VDC (Latched)
MTBF >25k Hours at 25°C / full load
Over Current Protection 45-59 Amps (Auto-recover)
Short Circuit Protection Load resistance <0.5 ohm; current limiting to 10s,
Regulation ±1% Load / ±1% Line Safety and Emission Standards:

Ripple Noise < 200mV • Safety Approvals - TUV,CE,UL,CCC


Transient Response ±5%, recovery in ≤200µs, F=1KHz,Vin=48V,di/dt = • Emissions - EN55022 , Class B
1.5A/1μs, Rate of load 25%, 20000μF in parallel • SURGE - L-L: ±1/2KV ,B criterion L-PE:±2/4KV ,R; IEC61000-4-5
• EFT - 1KV on DC 5KHz repetition, A criterion ,IEC61000-4-4
Turn-On Delay 3 - 8 secs • DIP - EN 61000-4-29
• ESD - IEC61000-4-2, contact ±8KV,air ±15KV B criterion; at signal port,±2KV R criterion
• CS - LEVEL 3 Criterion A, IEC61000-4-6
• RS - LEVEL 3 Criterion A, IEC61000-4-3
STATUS / CONTROL • EFT - ±2KV,LEVEL 3 Criterion B,IEC61000-4-4
• Surge - DM:±2KV,CM:±4KV Criterion B
Current Share Single Wire
• DIP - IEC61000-4-29 appliance
DC Fail Included
RS485 Included
3.3VSB Rated 500mA
PS Present Included (short pin)
Enable Included
I2C Interface Included

www.netbit.com Consult NetBit ® for engineering specifications


DD352M65-1M1
3500 Watt Boost Converter
250.5 x 111.6 x 66.0mm

Pin No. P1 P2 P3 P4 C6 A4 B4 C4 D6
Assignment 48V+ 48V+ 48V- 48V- PS-enable Addr2 Addr1 Addr0 AGND
Pin No. A6 B6 C2 A2 B2 A3 B3 D2 A1
Assignment Share+ Share- DCfail PS485+ PS485- 3.3V SGND PS-present Null
Pin No. B1 C1 D1 C3 D3 D4 A5 B5 C5
Assignment Null Null Null Null Null Null Null Null Null

www.netbit.com Consult NetBit ® for engineering specifications

You might also like