EE-434 Power Electronics

Engr. Dr. Hadeed Ahmed Sher

Ghulam Ishaq Khan Institute of Engineering Sciences and Technology

Topi 23460, Pakistan
[email protected]

January 24, 2019

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 1 / 17
 Overview

1 Electronic switches
Transistor
MOSFET
Bipolar Junction Transistor (BJT)

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 2 / 17
 MOSFET
It is a voltage controlled majority carrier device. VGS > VGS(min) to
turn on the device.
The gate terminal is insulated from channel region using silicon oxide
(SiO2 ). this means input impedance (Zin ) is high so small gate power
is required.. It is also called insulated-gate FET or IGFET. It has two
types ; the depletion type and enhancement type.
Power MOSFET are of enhancement type rather than depletion type.
Typical ratings are 1500V and 600A at MHz range. Also available in
low voltage high current rating (60V,1000A SEMIKRON)

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 3 / 17
 MOSFET

MOSFET has a inherent built-in internal body diode. It may not have the
same switching speed as of MOSFET.
Connected between source and drain in anti-parallel direction.
MOSFET can block positive voltage and allow current to flow in negative
(diode) and positive(MOSFET) directions. So it is a two quadrant device.
MOSFET has junction capacitance between gate to source, gate to drain
and drain to source. The gate capacitance (source+drain) is called input
capacitance and it is usually in pf. It plays a significant role in turning on
a mosfet.

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 4 / 17
 MOSFET| How to neutralize the body diode

If a high switching diode is required

the effect of body diode (Db ) can be
neutralized by connecting a
diode(Dn ) in series with the drain.
Consequently the reverse current
requires the fast switching diode(Df )
connected in anti-parallel direction.

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 5 / 17
 MOSFET | Operating limits and safe operating areas
MOSFET has two voltage limits that should not be exceeded
VGS(max) and BVDSS .
Typical VGS(max) are 20-30V.
Note that even static charge can damage the mosfet.
Usually zener protection is provided to the MOSFET to avoid
exceeding VGS(max) .

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 6 / 17
 MOSFET | Losses

MOSFET has on state power losses given as

Pon = I2o RDS(on) (1)

The resistance RDS(on) increases with increase in junction temperature.

This means they have a positive temperature coefficient which is good for
parallel operation.
Therefore, the on-state losses will increase with temperature in most
power electronic applications.

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 7 / 17
 MOSFET | Paralleling of MOSFET
MOSFET’s positive temperature coefficient is good as it provides thermal
stabilization effect.

For same jucntion temperature if RDS(on) of T2 exceeds T1 , then T1 will

have higher current and therefore higher on state losses than T2 .
This will increase the junction temperature of T1 and therefore RDS(on) .
This will decrease the current and hence, there is a thermal stabilization
effect. . . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 8 / 17
 MOSFET | Gate connection of MOSFET

MOSFET’s gate input are highly capacitive with almost zero losses.
Off course stray inductance is always there.

This LC combination creates unwanted high frequency oscillations in

MOSFET.
A small resistance is usually used in series with the individual gate
connections to dampen these oscillations.
. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 9 / 17
 MOSFET | Safe operating area (SOA)
SOA of mosfet depends on maximum drain current IDM , the internal
junction temperature Tj and breakdown voltage BVDSS . gate input are
highly capacitive with almost zero losses.
Off course stray inductance is always there.

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 10 / 17
 MOSFET | Understanding the datasheet

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 11 / 17
 MOSFET | Understanding the datasheet

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 12 / 17
 MOSFET | Understanding the datasheet

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 13 / 17
 MOSFET | Understanding the datasheet

EAS represents the results of avalanche test which certifies the maximum
limit of a mosfet to absorb the energy trapped in an unclamped inductive
circuit.
The procedure is as follows
A DC source is connected to a mosfet drain to source with a series
inductance L connected with drain. The leakage drain current is measured
before and after the gate signal is applied. If the leakage drain current after
the gate pulse is removed exceeds the leakage current of drain before the
gate pulse is applied then the mosfet fails the text. If not, the dc voltage is
increased to increase the current. Usually the maximum current value as
well as inductance value is specified on the datasheet as shown above.
As a thumb rule, high current and small inductance makes a stressful test.
. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 14 / 17
 MOSFET | Understanding the datasheet

Method to neutralize the body diode has already been presented. Note
that for some applications,the designer may require a diode with superior
switching characteristics.

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 15 / 17
 Bipolar Junction Transistor (BJT)
It is an active single quadrant switch i.e., a current controlled device.
Ib > Ib(min)
Collector emitter saturation voltage is typically 1-2V for a power BJT.
Work as a fixed saturation voltage device and therefore offers low on
state losses compared to mosfet.
Power BJT suffer from low values of beta and therefore, Darlington
pair is often used
Not much used in modern PE applications. Because for low voltage
applications it is replaced by MOSFET and for high power it is
replaced by IGBT.

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 16 / 17
 Comparison of electronic switches

Device Quadrant Voltage Current Control Remarks

operation blocking flow
Diode 1 Reverse forward No
Thyristor 2 Both forward Yes
Mosfet 2 Positive Both Yes On
state
loss is
higher
than
BJT
BJT Yes
IGBT Yes

Table: Summary of power electronic semiconductors

. . . . . . . . . . . . . . . . . . . .
. . . . . . . . . . . . . . . . . . . .
Engr. Dr. Hadeed Ahmed Sher (FEE, GIKI) Week 03 Resources January 24, 2019 17 / 17