Datasheet: C P V 5 3 7 5 Compactpci Host Slot Processor Board
Datasheet: C P V 5 3 7 5 Compactpci Host Slot Processor Board
Datasheet: C P V 5 3 7 5 Compactpci Host Slot Processor Board
C P V 5 3 75 C o m p a c t P C I H o s t S lo t P ro c e s s o r B o a r d
The CPV5375 provides a powerful and flexible CompactPCI host slot processor board with a Pentium III processor. This board is specifically designed for cost-sensitive, embedded applications where performance and a rich feature set are required. The CPV5375 is designed for telecommunications, industrial automation, medical, COTS and applications where leading edge technology is mandatory. The board has a demonstrated high MTBF and is coupled with software support for operating systems such as Linux and VxWorks. The CPV5375 provides an ideal time-to-market solution for CompactPCI host slot controller applications that are based on Pentium processors.
Soldered-on memory: to 512MB PCI Bridge and Memory Controller (North Bridge Intel 440GX) Memory mezzaine: to 512MB AGP Bus AGP Video
Accelerated 2D graphics with 4MB video memory Dual 10/100Mbit Ethernet Embedded features: two USB interfaces, two serial ports, bi-directional IEEE-1284 parallel I/O Supported by industry-standard operating systems such as Linux and VxWorks
PMC I/O
Optional on-board 2.5" EIDE hard drive (replaces one PMC site)
PMC I/O
Ethernet
ISA
SM Bus
Secondary IDE
Primary IDE J4
Ethernet 1 J5
Ethernet 2 J5
PMC 2 I/O J5
PMC 1 I/O J3
Printer J4
Mouse J5
Floppy J4
COM 1 J3
COM 2 J3
USB 0 J3
USB 1 J3
Video J4
KBD J5
CPCI J1/J2
COM
D035 050
CPV5370 Details
For embedded host applications, the CPV5375 fully supports the Pentium III BGA2 processor. The processor is combined with the Intel 440GX PCI chipset resulting in exceptional processing capability. The processor contains 32KB of internal Level 1 cache memory as well as 256KB of Level 2 cache, delivering rapid data access to complex applications. Dynamic execution and dual independent buses are additional performance advantages.
Memory
The CPV5375 is configured with up to 512MB of on-board PC100 compliant synchronous DRAM. Memory size is detected by the system BIOS. The board can support up to 1GB of DRAM by installing the CPMEZZ-256 memory expansion module. Refer to the Ordering Information section for additional information.
2D Accelerated Graphics
A 69030 HiQVideo accelerator with 4MB integrated memory provides eye-opening 2D accelerated graphics performance for human-machine interfaces and imaging applications. Resolutions up to 1600 x 1200 are supported.
Dual Ethernet
Two Intel 82559 Ethernet controllers provide redundant Ethernet ports for control and telecom applications. One or both of these controllers can be used as a diagnostic interface, allowing remote monitoring of system status (for example, voltage and temperature). One Ethernet RJ-45 connector is located on the front panel. Both Ethernet ports are routed to the rear I/O and available via the CPTM-01 transition module.
Hot Swap Compatible
The board hardware monitors the ENUM# signal and can be configured to generate an NMI or SMI in response to hot swap events. Event detection via I/O register polling is also possible.
Live Insertion and Removal
The CPV5375 can be inserted into or removed from a powered chassis without sustaining damage. In addition, a live insertion will cause a valid reset on the CompactPCI bus, thus ensuring an orderly bootup with correct device enumeration.
On-Board Peripherals
The CPV5375 has an extensive array of on-board I/O available from both the front and/or rear panel via the CPTM-01 transition board. Front panel I/O includes a knockout for two PMC sites, one RJ-45 connector for Ethernet and one RJ-45 connector for COM1. User I/O available at the rear of the board includes both Ethernet ports, secondary IDE, both PMC I/O, video, parallel, floppy, mouse/keyboard, COM1 and COM2, and USB0 and USB1.
CompactPCI Bus
Designed to the CompactPCI interface standard, the CPV5375 supports a 64-bit PCI interface on the J1 and J2 physical CompactPCI connectors. On-board devices connect directly to the local bus. Off-board CompactPCI bus accesses are supported through the Intel 21154 PCI-to PCI transparent bridge.
CPV5375
Specifications
SPECIFICATIONS Processor
700 MHz Pentium III BGA2 processor
Clock/Calendar
Real-time clock with replaceable battery backup
Cache
Level 1: Level 2:
Interrupts
16/16KB instruction/data 256KB Four CompactPCI level-sensitive interrupts, configurable to any interrupt vector for plug-and-play compatibility. Note: All ISA on-board interrupts are plug-and-play compliant.
Memory
Capacity: DRAM: Addressing: Data Path:
Ethernet
Up to 1GB PC100 compliant synchronous, 60 ns, parity or ECC mode Real and protected (32-bit) addressing supported 32-bit CPU/PCI bus
Controllers: Interface: PCI Local Bus DMA:
Graphics
Controller: Video Memory: Resolution:
CompactPCI Interface
Compliance: Connectors: Address/Data Lines: PCI Bus Clock: Controller: Signaling:
69030 HiQVideo 2D accelerated video 4MB on-chip SDRAM 1600 x 1200 max.; Quarter VGA 320 x 240, 320 x 200
PCI Specification Rev. 2.1 J1/J2 64 33 MHz Intel 21154 PCI-to-PCI interface bridge chip 5V compliant
One RJ-45 Note: Additional devices may be attached via transition module.
Supervisory
64 33 MHz 5V +3.3V, +5V, 12V; 7.5 watts maximum per PMC slot
Alarm Microcontroller (NS LM81): Watchdog Timer:
Two-level, software programmable; drives interrupt, NMI/system reset, or soft reset CPU and board temperature, backplane and CPU voltages, with status interrogated via NMI, SCI, selectable IRQ or Alarm Guarded, on front panel Power OK (green) and Hard Drive Activity (green) Primary EIDE and two PMC sites Both Ethernet ports, secondary IDE, both PMC I/O, video, printer, floppy, mouse/keyboard, COM1 and COM2, and USB0 and USB1
Two single-wide or one double-wide frontpanel I/O or J3 and J5 I/O Note: Due to high component density, uninsulated traces and vias are located in the CPV5375 I/O keepout area. If installed, PMC modules having conductive I/O connectors could contact these traces and vias. If full IEEE 1386.1 compliance is required, an insulating shield should be installed.
CPV5375 3
Power Requirements
(including drive option; using 512MB SDRAM)
700 MHz +5V: +3.3V: +12V: 12V:
Demonstrated MTBF
(based on a sample of eight boards in accelerated stress environment) Mean: 214,322 hours
95% Confidence: 121,141 hours (excluding on-board hard drive option)
Mechanical
6U, 4HP wide (233 mm x 160 mm x 20 mm), conforms to PICMG 2.0 CompactPCI (rev. 2.1) and PCI SIG 2.1 specifications
Safety
All printed wiring boards (PWBs) are manufactured with a flammability rating of 94V-0 by UL recognized manufacturers.
Environmental
(excluding on-board hard drive option) Operating
Temperature: Humidity (NC): Vibration:
Provides backplane I/O from J3, J4, and J5 on the CPV5375 Keyboard/mouse, dual Ethernet, video, COM2, and optional PIM module knockout COM1, USB0, USB1, secondary EIDE, floppy, PIM site, floppy, parallel, and CompactFlash
CPV5375
Ordering Information5
ORDERING INFORMATION5
Part Number
CPV5375-700-01 CPV5375-700-02 CPV5375-700-03 CPV5375-700-04 CPV5375-700-05 CPV5375-700-06
Description 700 MHz, 256MB SDRAM, two PMC sites 700 MHz, 256MB SDRAM, one PMC site, hard drive 700 MHz, 512MB SDRAM, two PMC sites 700 MHz, 512MB SDRAM, one PMC site, hard drive 700 MHz, 1GB SDRAM, two PMC sites 700 MHz, 1GB SDRAM, one PMC site, hard drive
Transition Module The CPV5375 uses an optional transition module for peripheral and network connections that are required at the rear of the chassis.
CPTM-01
Transition module with keyboard/mouse, dual Ethernet, video, COM2, and optional PIM module knockout
Memory Modules
CPMEZZ-256B CPMEZZ-256B-F CPMEZZ-256T CPMEZZ-256T-F
256MB memory mezzanine, bottom installation 256MB memory mezzanine, bottom installation by factory 256MB memory mezzanine, top installation 256MB memory mezzanine, top installation by factory
Documentation
CPV5370A/IH
CompactPCI CPV5375 Single Board Computer and CPTM-01Transition Module Installation and Reference Guide
Motorola offers PMC modules that complement and enhance the functionality of the CPV5375. Additional information is available at http://www.motorola.com/computer or by contacting a Motorola sales representative or authorized distributor.
NORTH AMERICA: Tempe, AZ 1 800 759 1107 or1 602 438 5720 EUROPE: Loughborough, UK +44 1509 634300 EAST MEDITERRANEAN: Tel Aviv, Israel +972 3 568 4388
ASIA: Shanghai, China +86 21 5292 5693 PACIFIC RIM: Tokyo, Japan +81 3 5424 3101 ASIA/PACIFIC: Hong Kong +852 2966 3210
www.motorola.com/computer
MOTOROLA and the Stylized M Logo are registered in the U.S. Patent and Trademark Office. CompactPCI and PICMG are registered trademarks of the PCI Industrial Computer Manufacturers Group. All other product or service names are the property of their respective owners. This datasheet identifies products, their specifications, and their characteristics, which may be suitable for certain applications. It does not constitute an offer to sell or a commitment of present or future availability, and should not be relied upon to state the terms and conditions, including warranties and disclaimers thereof, on which Motorola may sell products. A prospective buyer should exercise its own independent judgement to confirm the suitability of the products for particular applications. Motorola reserves the right to make changes, without notice, to any products or information herein which will, in its sole discretion, improve reliability, function, or design. Motorola does not assume any liability arising out of the application or use of any product or circuit described herein; neither does it convey any license under its patent or other intellectual property rights or under others. This disclaimer extends to any prospective buyer, and it includes Motorolas licensee, licensees transferees, and licensees customers and users. Availability of some of the products and services described herein may be restricted in some locations.
C5375-D3 07/04