Nanfang Smart Water Co.,Ltd’s Post

Our hot water circulation shielded pump features NPT 1 inch (25.4 mm) inlet/outlet. Extraly equipped with a common NPT3/4(19.05 mm) inch adapter. Voltage/Frequency: 110-120V, 60Hz. Rated power: 93/67/46 W. Max pressure: 145 psi (10 bar),the hot water circulation shielded pump with three-speed control. Flow: 36/29/20 LPM (9.5/7.66/5.28 GPM). Max head: 6m (20ft). Low-noise operation.

Johnson Pump Bilge Alert High Water Alarm - 12V Sensor [72303]

--No power connection required --Automatic ignition by two D batteries --Instantaneous water heater --Heat-resistant metal housing --Start at low water pressure --Overheating protection --Come with the shower head and shower hose

The water heater micro switch is a very important safety accessory in the water heater water and gas linkage device, or called water valve linkage. When water flows in the inlet pipe, the micro switch will close. After the circuit is turned on, the hot water flows out normally.

The water heater micro switch is a very important safety accessory in the water heater water and gas linkage device, or called water valve linkage.   When water flows in the inlet pipe, the micro switch will close. After the circuit is turned on, the hot water flows out normally.

Checking pump amperages is one of the tools we use to check on the condition of pump. #watertreatment #wastewatertreatment

Did you know that a relief valve can prevent costly damage to your water network? Quick opening and controlled closure minimise system disturbances and downtime.  Watch the Model 106 RPS Relief Valve in action. Learn more about how the Singer relief valve works #reliefvalve #plumbing #fluidmechanics #pressuremeasurement #hygradewater

1. easy to install 2. can replace old one 3. high pressure water 4. multi function

What is loadbreak switch? The load switch is a switching appliance between the circuit breaker and the isolating switch. It has a simple arc extinguishing device and can cut off the rated load current and a certain overload current, but it cannot cut off the short-circuit current. Generally, a simple arc extinguishing device is installed, but its structure is relatively simple. The picture shows a compressed air type high-voltage load switch. Its working process is: when opening, under the action of the opening spring, the main shaft rotates clockwise. On the one hand, the piston moves upward through the crank slider mechanism to compress the gas; on the other hand, On the one hand, through a transmission system composed of two sets of four-link mechanisms, the main gate knife is opened first, and then the arc extinguishing knife is pushed to open the arc contact, and the compressed air in the cylinder blows out the arc through the nozzle. #LoadbreakSwitch #Switchgear #SwitchCabinet #ElectricalEquipment

Tank level switch installation obstructions: Avoid placing the switch near inlets, outlets, agitators, or heating elements to prevent false readings.