JETIR1607020

July 2016, Volume 3, Issue 7 JETIR (ISSN-2349-5162)
BIOGAS SCRUBBING WITH WATER AND

CHEMICAL SCRUBBER AND EVALUATE
TECHNOLOGICAL PERFORMANCE
Biogas scrubbing technology
1
Ankit patel, 2Hardik panchal, 3Maulik shah, 4Chirag patel, 5Pankaj Ahir
1, 2, 3, 4, 5
Mechanical Engg.
1,2,3,4
Student ITM universe, Vadodara, India
5
Assistant Professor ITM universe, Vadodara, India
Abstract— The alternative energy sources are the best option to overcome the difficulties of energy crisis and greenhouse gas emission.
The bio mass is one of the source of alternative energy and the outcome of which after biological degradation is biogas. Biogas contains
three undesirable components – carbon dioxide (CO2), hydrogen sulphide (H2S) and water vapour components. The problem with the
high amounts of carbon dioxide is dilution of methane. If the biogas is to be stored, a large amount of space would be wasted on storing
carbon dioxide. Similarly, if it was to be piped to another location, energy would be wasted in pumping the carbon dioxide. Most
importantly, the water reacts with the hydrogen sulphide in the biogas, and creates a very corrosive acid. There is a great need to make
biogas transportable. This can be done by compressing the gas in cylinders which is possible only after removing its C02, H2S and water
vapor components.
The objective of project work is to purify biogas by removing H2S and CO2 content through water and chemical scrubbing technologies.
Index Terms— Biogas production, Biogas purification, Chemical scrubbing, Water scrubbing
I. INTRODUCTION (HEADING 1)
Today the situation of energy in the world, whether in newly created or industrialized countries, is regularly discussed in political,
economic and technical terms. The sources of energy like coal, natural gas, crude oil and nuclear energy are becoming meager. Bio-energy is
deriving more and more significance in fields of research and development. Burning of fossil fuels creates waste materials, mostly emissions
to the environment as combustion fuel gases, dust and some ash. These waste materials have hazardous effects to the nature and some also
has global impact. So, now other sources of fuel should be searched out which can be most useful and eco-friendly. Gaseous fuels are the
example of such sources of fuel. Gas fuels are more flammable. For good combustion, it forms a homogeneous mixture with air. Thus it will
create less pollution.
II. BIOGAS
Biogas is an enchanting source of energy for rural areas. Biogas can be obtained from cow dung, other animal waste and also from plants
all of which are renewable and available in the countryside. Also called „„Gobar gas‟‟, it is produced by bacteria, which break down organic
material under oxygen less conditions. This process is also called „„anaerobic digestion‟‟. The content of biogas, based on the feeding
material and the method to digest it and mostly lies in the range : 50-70% methane (CH4), 25-50% carbon dioxide (CO2), l-5% hydrogen H2,
0.3-3% N2 and other minor impurities, especially hydrogen sulphide (H 2S). A biogas can behave as a promised alternative fuel by changing
considerable amount of fossil fuels.
III. WORKING
EXPERIMENTAL SETUP
METHODOLOGY
In the present work, first of all biogas plant will be developed from PVC tank either by using cow dung or kitchen waste.
Afterwards, the gas which is generated will be stored in automobile tube and later on scrubbing process will be done to purify biogas.
CHEMICAL SCRUBBING
Fig. 3D model of chemical scrubbing technology
JETIR1607020 Journal of Emerging Technologies and Innovative Research (JETIR) www.jetir.org 95

In this kind of scrubbing the gas will pass through the tank which is filled with mixture of Calcium Oxide and water (CaO +H 2O). So by
chemical reaction carbon dioxide will be removed and then the gas will pass through metal chip (Fe) to remove Hydrogen sulfide and finally
the gas will pass through wood powder, which absorbs moisture from the biogas.
CHEMICAL REACTIONS
CaO + H2O + CO2 = CaCO3
Fe + H2S = FeS + H2
WATERSCRUBBING
Fig. 3D model of water scrubbing technology
In the water scrubbing, water at high pressure is sprinkled in the pipe where it will mix with biogas and so the water & carbon dioxide
(CO2) will react. So carbon dioxide will be finally removed. The rest of the process to remove H 2S and moisture will be same as chemical
scrubbing.
IV. LIST OF COMPONENTS

1) PVC tank with 1000 LITRES capacity.
2) Calcium Oxide (CaO)
3) Metal chips
4) Wood powder
5) Submersible pump
6) Automobile tube
7) PVC pipe for Water scrubbing
V. CONCLUSION
By doing chemical and water scrubbing of “RAW BIOGAS”, pure methane will be obtained which lies in a range of 85-90 %(CH4). The
Obtained pure methane can be compressed and bottled in a cylinder which can be transported to the places wher biogas plant is difficult to
Implement (In urban areas) and can be used for different purposes. The scrubbed biogas can also be used as CNG gas by pressurizing the
Biogas at around 140 bar.
The usage of scrubbed biogas will reduce the usage of fossile fules, which further eliminates the emissions of NOx, COx and hydrocarbons.
Hence hazardous effect of such pollutant will be reduced and it results in eco-friendly environment.
VI. ACKNOWLEDGMENT
The completion of this dissertation phase would not have taken place without the contribution of many key people.. A special thanks to
our Head of Department Prof. MINESH PATEL Their guidance, advice and wisdom throughout this work are also greatly appreciated.
Finally, special thanks to our family and colleagues who provided constant support and encouragement during this work;
.
REFERENCES
[1] Karve .A.D. (2007), Compact biogas plant, a low cost digester for biogas from wastestarch. http://www.arti-india.org.
[2] Karve of Pune A.D (2006). Compact biogas plant compact low-cost digester fromwaste starch. www.bioenergylists.org.
[3] S.S. Kapdi, “Biogas scrubbing, compression and storage: perspective and prospectus in Indian context Centre for Rural
Development and Technology”, Indian Institute of Technology, New Delhi, India (2004).

[4] E.Porpatham, A. Ramesh and B. Nagalingam, “Investigation on the effect of concentration of methane in biogas when used as a fuel
for a spark ignition engine”, Fuel, vol.87, pp.1651–1659, (2008).
[5] Saiful Bari, “Effect of carbon dioxide on the performance of biogas/diesel dual-fuel engine” School of Mechanical Engineering,
University Sains, Malaysia, pp.1007-1010,(1996).
[6] E.Porpatham, A. Ramesh and B. Nagalingam, “Effect of compression ratio on the performance and combustion of a biogas fuelled
spark ignition engine”, Fuel, vol.95, pp.247-256 (2012).
[7] S.OrhanAkansu, NafizKahraman and Bilge Ceper, “Experimental study on a spark ignition engine fuelled by methane–hydrogen
mixtures”, International Journal of Hydrogen Energy 32, pp.4279 – 4284 (2007).
[8] European commission, Energy for future, Renewable sources of energy white paper for a community strategy and action
plan,com,Brussels(1997)

JETIR1607020

Uploaded by

Copyright:

Available Formats

JETIR1607020

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

JETIR1607020

Uploaded by

Copyright:

Available Formats

July 2016, Volume 3, Issue 7 JETIR (ISSN-2349-5162)

BIOGAS SCRUBBING WITH WATER AND

Fig. 3D model of chemical scrubbing technology

JETIR1607020 Journal of Emerging Technologies and Innovative Research (JETIR) www.jetir.org 95

CaO + H2O + CO2 = CaCO3

Fig. 3D model of water scrubbing technology

IV. LIST OF COMPONENTS

JETIR1607020 Journal of Emerging Technologies and Innovative Research (JETIR) www.jetir.org 96

JETIR1607020 Journal of Emerging Technologies and Innovative Research (JETIR) www.jetir.org 97

You might also like