Well Plan Checklist: Guidance Notes Halliburton Management System

GUIDANCE NOTES
Well Plan Checklist HALLIBURTON MANAGEMENT

SYSTEM
REGION: FUNCTION/PSL: DOCUMENT NUMBER:
Global Halliburton Project Management GND-GL-HAL-HPM-1100
OWNER: APPROVED BY: JOB REVISION BY: REV. DATE: REV. NO: PAGE:
HPM Drilling Engineer Region Frank McIntosh Geiby George 04-JUN-08 1 1 of 10
Managers
Well Plan Checklist
Contents
1. PROGRAM OF WORK
2. REGULATORY AUTHORITY APPROVALS
3. INSTALLATION SAFETY CASE
4. FINANCIAL AUTHORITY
5. IDENTIFICATION & CONTROL OF HAZARDS
6. WELL DESIGN CONSIDERATIONS
7. SUPPORTING NOTES
Note
The check list uses drop down menus to enter responses. When using drop down menus under
forms, the document has to be locked and text changes are not possible. If text has to be added,
or the document changed, them the document must be unlocked first, changes made and then
locked again to use the drop down lists.
To unlock the document, select “toolbar” and choose “forms”. There is an icon, shaped like a
lock, at the right of this toolbar which locks and unlocks the document.
GUIDANCE NOTES

SYSTEM
Managers
1 PROGRAM OF WORK Yes / No / N/A
1.1 Have the final versions of the following documents been fully approved
and distributed:
- Well Planning Data Package (PDDP) Select
- Geological and Pressure Forecast Select
- Drilling Program Select
- Wall Chart Select
- Directional Plots Select
- Time/Depth Graphs Select
- Cost/Depth Graphs Select
- Site Survey Report Select
- Top Hole forecast & Shallow Gas Assessment Select
1.2 Have all draft versions of the above documents been withdrawn from the
Select
wellsite?
1.3 Does the program of work fully comply with both Lead contractor and
Select
client policies and standards?
If NO, have the necessary Change Requests been completed and
Select
approved?
Please reference all relevant Change Requests in Section 7.
1.4 Does the program of work fully accommodate all the well objectives
Select
given in the PDDP?
If NO, has any compromise in well objectives been discussed and agreed
Select
with the client?
Please describe any compromise in well objectives in Section 7.
1.5 If the well is of restricted status, have all tight hole procedures been
Select
followed?
GUIDANCE NOTES

SYSTEM
Managers
2 REGULATORY AUTHORITY APPROVALS Yes / No / N/A

2.1 Has Notification been submitted to the Relevant Government Approval
Group (RGAG) and acknowledgement been received not less than 21 Select
days prior to spud?
Does the Notification cover all planned operations and all reasonably
Select
foreseeable contingencies?
If NO, what further Notifications are required:
- plug back & sidetrack Select
- complete Select
- abandon/suspend Select
- other [please specify]: Select
Has the RGAG indicated any concerns with the work program? Select
2.2 Have formal applications been submitted for the well?

- Well G&G data submitted to the RGAG Select
- Environmetnal notices Select
- Approved chemicals list Select
- Move and permission to locate approvals Select
- Authorities (police, coastguard, Defence Select
- Select
2.3 Has written consent to the program of work been received from the
Select
RGAG?
Does the consent cover all planned operations? Select
If NO, what further consents are required:
- plug back & sidetrack Select
- complete Select
- abandon/suspend Select
- other [please specify]: Select
Are any conditions attached to the RGAG consent? Select
If YES, have all conditions been satisfied? Select
2.4 Has written consent to the location of the drilling unit been received from
Select
the RGAG?
Are any conditions attached to the RGAG consent? Select
If YES, have all conditions been satisfied?
Select
2.5 Has Notification of the use of POBM been submitted to RGAG? Select
Has a seabed survey been requested by RGAG? Select
2.6 Has PDDP been revised after submission of above and require
Select
resubmission?
2.7 Select
GUIDANCE NOTES

SYSTEM
Managers
3 INSTALLATION SAFETY CASE Yes / No / N/A

3.1 Have full details of the program of work, including the PDDP, geological
and pressure forecasts, been provided to the duty holder responsible for Select
the installation?
3.2 Has the duty holder verbally confirmed that the planned operations
Select
comply with the installation safety case?
4 FINANCIAL AUTHORITY Yes / No / N/A

4.1 Has the Drilling Cost Estimate been approved by all signatories? Select
4.2 Has the AFE been approved by all signatories? Select
5 IDENTIFICATION & CONTROL OF HAZARDS Yes / No / N/A

5.1 Have the following documents been reviewed to identify all potential
hazards:
- Well Planning Data Package (PDDP) Select
- Geological and Pressure Forecast Select
- Field/regional End of Well Reports Select
- Site Survey Select
- Shallow Gas Assessment Select
- Anti-Collision Scan Select
- Borehole Stability Study Select
- Oil Spill Contingency Plan Select
- Emergency Response Arrangements Select
GUIDANCE NOTES

SYSTEM
Managers
In the following sections, please indicate which potential hazards are relevant to the planned
work, and what action has been taken to mitigate the risk:

5.2 General Drilling Installation Hazards
a. Simultaneous operations Select

- SIMOPS procedures in place? Select
b. Combined operations Select

- interface documents & COMBOPS procedures in place? Select
c. Has a dropped objects study been carried out? Select
5.3 Floating Unit Hazards Select
a. Seabed obstructions Select

- mooring/rig positioning procedures in place? Select
- pipeline/cable owner informed? Select
b. Unsuitable anchoring conditions Select

- mooring analysis carried out? Select
c. Is the top hole section to be drilled riserless? Select

- if NO, has dispensation been granted? Select
d. Has a riser analysis been carried out? Select
e. If rig is on DP, is a drive off test planned? Select

GUIDANCE NOTES

SYSTEM
Managers

5.4 Jack-Up Unit Hazards Select
a. Seabed obstructions Select

- rig positioning procedures in place? Select
- pipeline/cable owner informed? Select
b. Rig location over a jacket Select

- rig positioning procedures in place? Select
c. Punch through Select

- punch through analysis carried out? Select
d. Scour
- monitoring program in place? Select
- contingency arrangements prepared? Select
If the conductor is not supported by jacket guides, has a conductor

Select
e. analysis been carried out?
f. Is the conductor shoe strength adequate for diverter operation? Select

GUIDANCE NOTES

SYSTEM
Managers

5.5 Subsurface Hazards
a. Shallow gas
- rig re-location outside the anomaly investigated? Select
- shallow gas procedures in place? Select
b. Overpressure and Depleted pressure

- hazard emphasised and fully described in work program? Select
c. Low kick tolerance (<50bbls) Select

- risks fully considered & demonstrated acceptable? Select
- request for dispensation from policy approved? Select
- hazard emphasised and fully described in work program? Select
d. Wellbore collision
- minimum allowable proximity stated in work instructions? Select
- adjacent well plugging requirements agreed & in place? Select
e. H2S
- H2S procedures in place? Select
- H2S kit organized? Select
- all well & rig materials suitable for sour service Select
f. Lost circulation
- well control consequences considered? Select
- contingency arrangements in place? Select
Are reservoir pressures sensitive to fluctuations in the

g. production/injection rate of nearby wells? Select
- if YES, have the OIM and Drilling Supervisor been informed, and
Select
suitable procedures established to safeguard well control?
GUIDANCE NOTES

SYSTEM
Managers

5.6 Other Hazards
program of work, and the measures taken to mitigate the risk.
Select
Select
Select
Select
Select
6 WELL DESIGN CONSIDERATIONS Yes / No / N/A
6.1 Has a formal casing string design been carried out & included Select
on the wellfile?
6.2 Is the casing program based on a field standard provided in the Well
Select
Design Manual
If YES, has it been confirmed that the specific well conditions fall within
Select
the design envelope?
6.3 Have the effects of casing wear been considered in the design? Select
6.4 in well conditions during field life? Select
6.5 Has the wellbore Survey Program been prepared in accordance with both
Select
Directional company and client standards?
6.6 Have the following simulations been carried out: Select

- torque/drag Select
- hole cleaning Select
- hydraulics Select
- swab/ surge Select
- jar placement Select
- centraliser placement Select
6.7 Have relevant stuck pipe avoidance procedures been included in the
Select
Drilling Program?
6.8 In the event that the well is suspended prior to completion, does the well
Select
design allow later abandonment by wellhead removal only?
GUIDANCE NOTES

SYSTEM
Managers
7 SUPPORTING NOTES
Item Ref. Remarks
GUIDANCE NOTES

SYSTEM
Managers
7 SUPPORTING NOTES
Item Ref. Remarks

Well Plan Checklist: Guidance Notes Halliburton Management System

Uploaded by

Copyright:

Available Formats

Well Plan Checklist: Guidance Notes Halliburton Management System

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Well Plan Checklist: Guidance Notes Halliburton Management System

Uploaded by

Copyright:

Available Formats

GUIDANCE NOTES

Well Plan Checklist HALLIBURTON MANAGEMENT