CCNA Exploration2: Routing Protocols and Concepts - Chapter 6 Exam

CCNA Exploration2: Routing Protocols and
Concepts – Chapter 6 Exam

01. What two advantages does CIDR provide to a network? (Choose two.)
reduced routing table size
dynamic address assignment
automatic route redistribution
reduced routing update traffic
automatic summarization at classful boundaries
02. Refer to the exhibit. The network administrator wants to create a

subnet for the point-to-point connection between the two routers. Which subnetwork mask would
provide enough addresses for the point-to-point link with the least number of wasted addresses?
255.255.255.192
255.255.255.224
255.255.255.240
255.255.255.248
255.255.255.252
03. Refer to the exhibit. A network engineer is summarizing

the two groups of routes on router R1 shown in the exhibit. Which summarization will work for all
the subnets?
192.168.0.0/23
192.168.0.0/22
192.168.0.0/21
192.168.0.0/20
04. Which of the following are contained in the routing updates of classless routing protocols? (Choose
two.)
32-bit address
next hop router interface
subnet mask
unicast host address
Layer 2 address
05. Which of the following problems does VLSM help to alleviate?

the shortage of IP addresses
the difficulty of assigning static IP addresses to hosts in large enterprises
the complexity of implementing advanced routing protocols such as OSPF and EIGRP
the shortage of network administrators qualified in the use of RIP v1 and IGRP
06. What does VLSM allow a network administrator to do?

utilize one subnet mask throughout an autonomous system
utilize multiple subnet masks in the same IP address space
utilize IGRP as the routing protocol in an entire autonomous system
utilize multiple routing protocols within an autonomous system
07. Refer to the exhibit. What subnet

mask will be applied by router B when it receives a RIPv1 update for the network 172.16.1.0?
none
8
16
24
08. Refer to the exhibit. The network

administrator wants to minimize the number of entries in Router1’s routing table. What should the
administrator implement on the network?
VLSM
CIDR
private IP addresses
classful routing
09. A router has a summary route to network 192.168.32.0/20 installed in its routing table. What
range of networks are summarized by this route?
192.168.0.0 – 192.168.32.0/24
192.168.0.0 – 192.168.47.0/24
192.168.32.0 – 192.168.47.0/24
192.168.32.0 – 192.168.48.0/24
192.168.32.0 – 192.168.63.0/24
10. A network administrator is tasked with dividing up a class C network among the QA, Sales, and
Administration departments. The QA department is made up of 10 people, the Sales is made up of 28
people, and the Administration has 6. Which two subnets masks adequately address the QA and Sales
departments? (Choose two.)
255.255.255.252 for QA
255.255.255.224 for Sales
255.255.255.240 for QA
255.255.255.248 for QA
255.255.255.0 for Sales
11. In the network shown in the graphic, three bits were borrowed
from the host portion of a Class C address. How many valid host addresses will be unused on the
three point-to-point links combined if VLSM is not used?
3
4
12
36
84
180
12. A Class C address has been assigned for use in the

network shown in the graphic. Using VLSM, which bit mask should be used to provide for the
number of host addresses required on Router A, while wasting the fewest addresses?
/31
/30
/29
/28
/27
/26
13. An additional subnet is required for a

new Ethernet link between Router1 and Router2 as shown in the diagram. Which of the following
subnet addresses can be configured in this network to provide a maximum of 14 useable addresses for
this link while wasting the fewest addresses?
192.1.1.16/26
192.1.1.96/28
192.1.1.160/28
192.1.1.196/27
192.1.1.224/28
192.1.1.240/28
14. Which three interior routing protocols support VLSM? (Choose three.)
OSPF
RIP v1
RIP v2
EIGRP
BGP
STP
15. Refer to the exhibit. The number of required host addresses for
each subnet in a network is listed in the exhibit. This number includes the host address requirements
for all router ports and hosts on that subnet. After all device and router port address assignments are
determined, what will be the total number of unused host addresses available?
6
14
29
34
40
62
16. Refer to the exhibit. In the network that is shown, the

router interfaces are assigned the first address in each subnet. Which IP address would be usable for
a host on one of the LANs in this network?
192.168.1.5/30
192.168.2.17/28
192.168.2.63/27
192.168.2.130/25
17. Refer to the exhibit. Which address is a broadcast address for one
of the subnets that are shown in the exhibit?
192.168.4.3/29
192.168.4.15/29
192.168.4.65/26
192.168.4.255/24
18. Refer to the exhibit. A network

administrator needs to create two subnetworks from 10.0.0.0/8 for a router running RIPv2. The
Admin subnet requires 120 hosts and the Sales subnet requires 58 hosts. The network administrator
assigned 10.0.1.128/25 to the Admin subnet. The Sales subnet is given 10.0.1.192/26. What will be the
result of this addressing scheme?
Because RIPv2 does not support VLSM, the subnet masks will not be allowed.
The subnets will not have enough host addresses for the given network requirements.
The subnets overlap and will be rejected by the router.
The router will support the addressing scheme.
19. Refer to the exhibit. A

network technician enters the static route in R1 needed to reach network 10.1.1.0/24. A ping from R1
to Host B fails. The technician begins testing the network and has the following results:
1. pings from R1 to the S0/0/0 interface on R2....successful

2. pings from R1 to the Fa0/0 interface on R2....successful
3. pings from Host B to hosts on the 10.1.1.0/24 network....successful
4. pings from Host B to the Fa0/0 interface on R2....successful
5. pings from R2 to Host B....successful
What is the likely cause of the failure of the ping from R1 to Host B?
Host B has a defective Ethernet card.
The default gateway on Host B is not correctly set.
There is a Layer 2 problem between R2 and Host B.
R2 does not have routes back to networks connected to R1.
20. What is a supernet?

the network for a default route
a network that contains both private and public addresses
a set of discontiguous networks that are controlled by an ISP
a summarization of serveral IP classful networks into one IP address range

CCNA Exploration2: Routing Protocols and Concepts - Chapter 6 Exam

Uploaded by

Copyright:

Available Formats

CCNA Exploration2: Routing Protocols and Concepts - Chapter 6 Exam

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

CCNA Exploration2: Routing Protocols and Concepts - Chapter 6 Exam

Uploaded by

Copyright:

Available Formats

CCNA Exploration2: Routing Protocols and

Concepts – Chapter 6 Exam

02. Refer to the exhibit. The network administrator wants to create a

03. Refer to the exhibit. A network engineer is summarizing

05. Which of the following problems does VLSM help to alleviate?

06. What does VLSM allow a network administrator to do?

07. Refer to the exhibit. What subnet

08. Refer to the exhibit. The network

12. A Class C address has been assigned for use in the

13. An additional subnet is required for a

16. Refer to the exhibit. In the network that is shown, the

18. Refer to the exhibit. A network

19. Refer to the exhibit. A

1. pings from R1 to the S0/0/0 interface on R2....successful

20. What is a supernet?

You might also like