Audison Bit One - Sheet Technical

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

www.audison.

eu

Signal Interface Processor

Power Supply
11 15 VDC
0.45 A
< 0.5 mA
< 1.8 mA
7 15 VDC (1.3 mA)
12 VDC (130 mA)

Voltage
Idling current
Switched off without DRC
Switched off with DRC
Remote IN voltage
Remote OUT voltage

Signal Stage
Distortion - THD @ 1 kHz, 1 V RMS Output
0.002 %
Bandwidth
4.5 21k Hz
S/N Ratio @ A weighted
102 dBA
Channel Separation (@1 kHz)
77 dB
Input sensitivity (Low Level)
0.3 5 V RMS
Input sensitivity (High Level)
1.2 20 V RMS
Max Output Levels
4 V RMS
Input impedance (Low Level)
20 k
Input impedance (High Level)
5 k

Input Stage
Low Level (Pre In)
Ch 1 Ch 6, AUX1 L/R, AUX2 L/R
High Level (Speaker In)
Ch 1 Ch 8, Phone In
Coaxial and Optical
S/PDIF Max 48kHz / 24 bit, PCM

Output
Analog Pre Out
Digital Out 48kHz - 24 bit AD Link

Ch 1 Ch 8
Ch 1 Ch 8

Crossover
Type

Mode

12 / 24 / 36 / 48 dB Linkwitz
6 / 12 / 18 / 24 / 30 / 36 / 42 / 48 dB Butterworth
Full / Hi-Pass / Low Pass / Band Pass

Equalizer
Type
Gain

31 Band, ISO 1/3 Oct, 20 Hz 20k Hz


12 dB

Time Alignment
Delay

0 22 ms in 0,02 ms steps
(748 cm / 294.5 in.)

Size
W x H x D (mm / in.) 225 x 32,3 x 150 / 8.85 x 1.27 x 5.90
Weight (kg / lb.)
1,345 / 2.965

Audio DSP and converters


32-BIT floating point Analog Devices Sharc (Clock speed: 266MHz) Digital Signal Processing
chip and Wolfson A/D D/A converters working in PCM at 48kHz with 24 Bit resolution.
Tuning functions can be heard in real time due to processing speed.
Audio Inputs
8 independent high-level channels (with automatic summing capability) or 6 independent
analog low-level channels;
2 analog low-level stereo auxiliary inputs;
1 optical digital input;
1 electric coaxial digital input;
1 high-level momentary audio interrupt input (with Mute IN) for use with mobile phone or
navigation systems.
Audio Outputs
8 independent low-level analog channels featuring adjustable level and 1 AD Link output
(8 independent digital audio channels through a single CAT 5.S LAN cable for use with AD Link
provided amplifiers).
Digital Control System
1 USB /B (2.0) connector for PC connection;
2 AC Link control bus connectors for DRC and AC Link amplifiers.
Configuration
Guided procedure that, thanks to a wide range of set names, provides the ability to assign
each component to the bit One connections and automatically coordinate their functioning.
Turn-on Controls
ART automatic remote turn on/off circuit;
Through the car ignition key with memory function;
Through the DRC;
Automatically through the hands-free phone kit.
In/Out Volume
Input sensitivity automatically adjusted for the main inputs (with supplied Test CD and DVD);
Manual input sensitivity adjustment for auxiliary inputs;
Independent level control for each output channel for system fine tuning (-40 0 dB).
Dynamic Equalizer
System automatically self-adjusts through an equalization between low and high listening
levels that can be set by the user and controlled by the DRC.
De-equalization and calibration
Automatic de-equalization of signal fed into the high-level inputs (with supplied Test CD or
DVD) and levels calibration.
Equalizers
One 31-band graphic equalizer (1/3Oct.; 12dB) for each one of the 4 auxiliary input;
One 31-band graphic equalizer (1/3 Oct.; 12dB) for each one of the 8 output channels.
Crossover Filter
Filter typology: Selectable; Hi-pass, Lo-pass, Bandpass, Full Range;
Cut-off frequency: 70 steps available from 10 Hz to 20 kHz;
Cut-off slope: Selectable; 6 to 48 dB/Oct.;
Alignments: Selectable; Linkwitz or Butterworth;
Mute: Selectable for each output (On/Off);
Phase: Selectable for each output (0/180).
Signal channels reconstruction
It can reconstruct a stereo signal from a multi-channel signal. In addition it can reconstruct a
centre channel and subwoofer channels from a stereo input alone.
Time Alignment
Guided procedure for the speaker distance data entry with an automated calculation of proper
delay times for each channel for accurate time alignment set-up. System also provides for
manual fine tuning of delay (0 22 ms max).
Auto Restart
Automatic turn Off/On, if the DSP locks up.
DRC Master Volume control, Subwoofer Volume control, Balance control, Fader control, Input
selection, Memory selection, Dynamic Equalizer On/Off, Adjustable display brightness, Access
to digital features of Audison TH amps if connected.
Memory
4 presets separately managed and recalled by the DRC Remote Control.
Bit One software
Windows (Win 2000, XP, Vista, 7) based software with Standard and Expert operating modes;
Screen resolution: 1024 x 768 px min.

Elettromedia - 62018 Potenza Picena (MC) Italy - T +39 0733 870 870 - F +39 0733 870 880 - www.elettromedia.it
10

All specifications subject to change without notice_13.A

bit One.1 Version

Elettromedia - 62018 Potenza Picena (MC) Italy - T +39 0733 870 870 - F +39 0733 870 880 - www.elettromedia.it

11

mute

Multichannel Source
Analog Preamplified Signal

All specifications subject to change without notice_13.A

LOW LEVEL SOURCE


STEREO (FRONT + REAR)
OR MULTICHANNEL

HANDS-FREE
CELLULAR PHONES
KIT CONNECTION

OEM
Amplifier

MAX INPUTS:
8 amplified
channels

Phone signal

OEM Amplified Source

Internal Amplified Source

HIGH LEVEL SOURCE


STEREO (FRONT + REAR)
OR MULTICHANNEL

OUTPUT TO A NON-TH AMPLIFIERS SYSTEM (PRE)

Other
amplifier

Rear

Stereo Source
Analog Preamplified Signal

Sub Cen

Front

Auxiliary Stereo
Preamplified Source

Other
amplifier
AD Link
Digital Signal
AC Link
Function Control

AD Link
AC Link
provided
amplifier

Ground

Stereo Source
Digital Signal

Remote OUT

Battery

Ground

Other
amplifier

Auxiliary Stereo
Preamplified Source

Remote IN

Remote IN

Remote IN

Fuse Holder
(Not supplied)

DRC - Digital Remote Control CONNECTION

OUTPUT TO AN AMPLIFIERS SYSTEM (AD LINK + AC LINK)

AD Link
AC Link
provided
amplifier

www.audison.eu

You might also like