F5 101

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 7

https://www.freecram.net/question/F5.101.v2021-03-17.

q84/a-load-balancer-receives-a-tcp-syn-
packet-from-a-client-and-immediately-sends-the-packet-on-to-a-server

Review famous status codes such as 404,200,301,500

Review the below my memory based questions if you don’t have time to check the above dump as it
is not free I think

Question Meaning My Answer Comments

Email is not Curl -l smtp://IP or Host In the answers there is telnet port 143 which is
working, you want for IMAP, and I flipped between the two answers.
to check SMTP The provided answer is correct
Working on the
email server

the web server Curl


www.example.co http://www.example.co
m points to IP m
10.x.x.x is
Or curl the ip, I don’t
unavailable. Some
remember
new installation
happened in the
network, what is
the best way to
test the web
server

the web server Traceroute the IP or


www.example.co www.example.com
m points to IP
10.x.x.x is
unavailable. New
deployment of
firewall, how to
see where the
data is lost

the web server Dig www.example.com


www.example.co
m points to IP
10.x.x.x is
unavailable. New
migration of DNS
happened in the
network

LTM, network I answered: because


mapper shows the they are disabled
nodes in the pool
are red, but when
you click them
they are green,
why?

UNI for a vendor 2^24 = 16,777,216


is ABCDEF, how
many MACs can
they produce

New vlan for 25 Create new vlan with /29


users mask

LACP abbreviation Link Aggregation Control


Protocol

Protocol used to SNMP


monitor plah plah

How to create I think it is something for I may answered this wrong, I flipped between
snapshot for F5 Qkview /sys save ucs support and generate snapshot
support cli

There is a Switch
topology shows
firewall, router,
switch, which of
them is
forwarding traffic
without the layer
3 address

If snat is enabled, Choose the IP address of


and it shows you a the source in the
packet in the capture, which is the
capture from IP to ADC IP
the server, what
client is for server
side

You are accessing Default gateway MAC:


a server through 0003
ADC from station
with MAC: 0001,
the server behind
the ADC with MAC
0002, and your
default gateway
mac is 0003, what
is the destination
mac of the packet
travels from the
workstation,

It shows you a Because It is just


table for the accessed from the
opened ports on a loopback interface
linux machine,
127.0.0.1:80

0.0.0.0:22

10.1.10.10:23

Plah plah

Why is the user


cannot access the
web server even
he is sure that the
web service is
working

From where to Systemà archives


restore a backup
on F5

SNAT is enabled, ADC


what represents
the client for the
server

What is the best SSL VPN


to connect users
securely to your
corporate
resources

You need to SSL VPN


connect users to
your corporate
resources through
web browser
The role of Confidentiality
encryption in VPN

Certificate should I choose Intermediate I think it is wrong, may be CA Certificate, please


be installed on Certificate double check
client’s web
browser

What is the I chose the answer :” to


benefit of TLS/SSL secure the connection
when access https over the network”
server

How the data is Packet


sent in the layer3
OSI model

How data is sent Datagram


in the data link

To enable the Sync-standby


standby to becime
active when active
fails, what is the
mode

From where to Support.f5.com


download the
image

If you want to do Engineering hotfix or


some urgent patch
patches on f5
without the need
to upgrade, what
is your only
workaround

If the support guy End of firmware support


tells you to
upgrade your
firmware, what F5
policy can prevent
you to say no

To check data CRC


errors within the
links

Two vlans and Tagging the two vlans


native vlan from and untagging the native
the switch to F5, vlan
which uses dot1q

A new VLAN configure a tagged VLAN


segment has been
added to the
network. Only the
existing
connected
interface may be
used. What
should the BIG-IP
Administrator do
to allow traffic to
both the existing
and the new
VLAN?

What ADC is using I answered: “ Packet


so that it could be forwarding Architecture”
fast in delivering
packet

In which scenario I chose cookie


is a packet persistence
forwarding
architecture
sufficient ?

(I don’t remember
the question
exactly)

Why ADC packet Reduce latency I just remember the answer


architecture (I
don’t remember
the question
exactly)

Command to Command will be


created a vlan something like
tagged to
interface
Create …. Add {tagged}
plah plah

Add self IP with Create …. Allow none


no management
on it cli
Best way to see Network map
the mapping of
the virtual server
and pools

There is question
about clientssl
and serverssl
certificate

Where is mac Traffic group


masquerading
configured

Loopback ipv6 ::1

How to reduce tcp I chose to send larger


connections to windows
ADC

4-5 questions I don’t remember the


about status answers just review
codes like them quickly

401

500

301

And plah plah

What does HTTP Internal server error I answered bad gateway which ay wrong
status code 500 (from new dumps)
mean?

Which IP subnet 192. 168. 0. 11/30


mask can be used
to send traffic to
all network
nodes?

ARP table shows I choose firewall blocking Means firewall on the server
incomplete for
specific server

A BIG IP Hearth checks for nodes Found on dumps on internet I will share the link
administrator and pool members
https://www.freecram.net/question/
recently reset
F5.101.v2021-03-17.q84/a-big-ip-administrator-
statistics for
interfaces 1. 1 and recently-reset-statistics-for-interfaces-1-1-and-1-
1. 2. The 2-the-administrator-notices
administrator
notices that traffic
appears on a data
plane interface
without receiving
any client
requests All nodes
and pools have
monitoring
enabled, and all
routes are locally
defined on the
device All
management
traffic is sent over
the mgmt
interface. What is
the nature of this
traffic?

Which command dig


should a BIG-IP
Administrator use
to resolve the
domain www.
F5.com?

You issue ifconfig Half duplex the correct


and see many answer I guess as I ay
collisions answered it wrong

A load balancer packet forwarding


receives a TCP architecture
SYN packet from a
client and
immediately
sends the packet
on to a server.
This is an example
of which type of
solution?

You might also like