Powerful Protection

®®
Cicocure
Cicofloor WB
FS-50 Technical Data Sheet
Water Based Concrete Curing Compound
Solvent Free Epoxy Floor Coating issue 06/Jul.15

Description Properties
®
Cicocure WB is water based concrete curing Appearance white milky liquid
compound based on inorganic polymers. In Dry film appearance Clear, and white film
®
application, Cicocure WB creates a regular and Specific gravity @ 25oC 1.01±0.01
continuous film on the fresh concrete surface PH 6.3±0.3
preventing loss of the concrete inner hydration 2
Coverage, m /l (sprayed) 4-5
water, ensuring more efficient cement reaction,
improving durability and reducing shrinkage. Application Instructions
®
Cicocure WB is available in two grades, clear
The minimum application temperature is 5oC.
and white pigmented.
®
Cicocure WB should be stirred well before use
Uses to ensure even dispersion of the ingredients.
ƒ Large areas concreting like floorings, roof
decks, airports runways, rafts and highways. ®
Cicocure WB should be sprayed on the surface
ƒ Hot and dry climate concreting. of fresh concrete. Application should begin
ƒ Precast concrete industry immediately after the concrete is free from
ƒ Batch repair works. surface water. Do not apply if bleed water is
ƒ Low water content concrete, where high forming or present on the concrete surface.
compressive strength is required. Cross apply twice for adequate curing.
After spraying, no further application of water or
Advantages other material is necessary to ensure continued
ƒ Very effective in dry, windy or hot climate curing. The concrete surface should not be
concreting. disturbed until it has sufficient strength to bear
ƒ Minimizes potential for surface cracking & surface loads. The applied film should not be
shrinkage. walked on before it is fully dry and care should
ƒ Economical especially where water is rare or be taken to ensure that the film is not broken.
expensive.
ƒ Improves curing of concrete and provides ®
Cicocure WB may be applied on the surface of
more durability for it. newly hardened concrete immediately after
ƒ Safe, non-flammable, as it is water based. deshuttering. In such cases the concrete surface
ƒ Available in two grades, clear and white must be damp and not dry.
pigmented.
Handling Precautions
Standards Compliance Avoid close spraying with pressure on fresh
ASTM C 309, Type 1 class B concrete.
ASTM C 309, Type 2 class A
Removal and Over Coating
Packaging ®
Cicocure WB will be slowly removed by physical
20 liter pails and 210 liter drums abrasion in normal traffic or exposure to UV light.
Breakdown of the film commences after about 30
Shelf Life & Storage days. To ensure complete removal use high
12 months shelf life when stored in its original pressured steam, or brush the cured surface by
containers under shaded area in a temperature hand steel brush before applying any overlay
within the range of 5oC to 50 oC. finishing item to ensure a good bond to the
concrete (recommended).
 Cicocure®WB
Cicofloor®FS-50

Limitation Precautions
®
Cicocure WB should not be continuously stirred Health and Safety
®
in high shear pumps because this may cause a Cicocure WB is non-hazardous. However, it
breakdown of the emulsion. If continuous should not be swallowed or allowed to come into
recirculation is necessary, the sprayer should be contact with skin or eyes. Suitable protective
fitted with a low shear diaphragm pump goggles and gloves should be worn. In the case
of contact with eyes, rinse immediately with
Cleaning & Disposal plenty of water and seek medical advice. When
®
Spillages of Cicocure WB should be hosed contact with the skin is made, wash off
down with large quantities of water or absorbed immediately with soap and water. If swallowed,
onto fine sand and disposed of in accordance seek medical attention immediately, do not
with local legislation induce vomiting.

Technical Support
CIC provides on-site assistance and consulting
services on projects when requested. Technical
data sheets on other CIC products and guidance
on their use are available on request.

Warranty
CIC products are guaranteed against defective materials and manufacture and sold subject to CIC's standard terms and conditions of sale. Whilst CIC
endeavors to ensure that any advice, information or recommendation given is correct, the company cannot accept any liability either directly or indirectly
arising from the use of its products, since the company has no control over the application of its products. Information contained in this document is given
on the best current knowledge. CIC's policy is one of continuous improvement and the company reserves the right to change the company products
without prior notice.
Head Office: Jeddah Towers Building, Sharafeyah – P.O Box 7232, Jeddah 21462
(+96612) 653-2152 – 6514414 – 6531622 Fax (+96612) 651-9230
Factories: Plant 1: AlKhomra - Jeddah Telefax (+96612) 6365190
Plant 2 Jubail (+966013) 3404771 – 3404772 Fax (+966013) 3404770
Aal Taher Group
Branches: Jeddah (+966012) 6055657 Riyadh (+966011) 493 7635 Khobar (+966013) 8651349
Madina (+966014) 8390424 Makkah (+966012) 5482280 Yanbu (+966014) 3907539 Tabuk (+966014) 4275680
www.cictg.com