Data Com 3 Prelim

Download as pdf or txt
Download as pdf or txt
You are on page 1of 4

is used to monitor and make configuration changes to a in-Band

network device over a network connection.


Management
Which PAgP mode mode places an interface in a passive PAgP auto
negotiating state in which the interface responds to the
PAgP packets that it receives, but does not initiate PAgP
negotiation?
What is an accurate description of redundancy? designing a network to
use multiple paths
between switches to
ensure there is no single
point of failure
When EtherChannel is implemented, multiple physical port channel
interfaces are bundled into which type of logical
connection?

m
er as
After the election of the root bridge has been completed, Each switch will analyze the

co
sum of all port costs to reach
how will switches find the best paths to the root bridge?

eH w
the root and use the path
with the lowest cost.

o.
rs e
What is the function of PoE pass-through? allows switches, phones,
ou urc
and wireless access points
to receive power over
existing Ethernet cables
o

from an upstream switch


aC s

Which STP port role is adopted by a switch port if there is no root port
vi y re

other port with a lower cost to the root bridge?


Which scalable method must be implemented in order to routing traffic internally to
ed d

provide inter-VLAN routing on a switched network with a Layer 3 switch device


more than 1000 VLANs?
ar stu

A network administrator configured an EtherChannel link The remaining two


with three interfaces between two switches. What is the interfaces continue to load
is

result if one of the three interfaces is down? balance traffic.


Th

A company has deployed four 48-port access layer switches 176


to a switch block. For redundancy each access layer switch
will connect to two distribution layer
sh

When a range of ports is being configured for EtherChannel, passive


which mode will configure LACP on a port only if the port
receives LACP packets from another device?
An administrator is investigating a failure on a trunk link Switches from other
between a Cisco switch and a switch from another vendor. vendors do not support
After a few show commands, the administrator notices that DTP.

This study source was downloaded by 100000815899376 from CourseHero.com on 11-22-2021 22:37:01 GMT -06:00

https://www.coursehero.com/file/109914306/data-com-3-prelimpdf/
the the switches are not negotiating a trunk. What is a
probable cause for this issue?
Which is the default STP operation mode on Cisco Catalyst PVST+
switches?
What is one way to correct a spanning tree failure? Manually remove
redundant links in the
switched network.
An administrator is troubleshooting a switch and wants to show spanning-tree
verify if it is a root bridge. What command can be used to
do this?
Which mode configuration setting would allow formation of SW1: on
an EtherChannel link between switches SW1 and SW2
SW2: on
without sending negotiation traffic?

m
are typically deployed in the core and distribution layers of Multilayer switches

er as
an organization's switched network.

co
What is a characteristic of out-of-band device management? It requires a terminal

eH w
emulation client.

o.
What is the purpose of VTP? It provides centralized
rs e management of VLANs in
ou urc
a multi-switch
environment.
o

Which sentence correctly describes the SVI inter-VLAN An SVI is needed for each
routing method? VLAN.
aC s
vi y re

When EtherChannel is configured, which mode will force an on


interface into a port channel without exchanging
aggregation protocol packets?
ed d

provides endpoints and users direct access to the network access layer
ar stu

of a switch refers to the number of ports available on a


single switch.
port density
Displays all secure MAC addresses configured on all switch show port-security
address
is

interfaces.
Which type of VLAN is identified by a VLAN ID between extended
Th

1006 and 4094 and not contained in updates of switches


participating in a VTP domain?
Displays all interfaces with IPv4 addressing information and
sh

show ip interface brief


interface and line protocols status.
A network administrator is analyzing the features that are GLBP allows load
balancing between routers
supported by different first-hop router redundancy
protocols. Which statement is a feature that is associated
with GLBP?

This study source was downloaded by 100000815899376 from CourseHero.com on 11-22-2021 22:37:01 GMT -06:00

https://www.coursehero.com/file/109914306/data-com-3-prelimpdf/
During the implementation of Spanning Tree Protocol, all All the switches send out
BPDUs advertising
switches are rebooted by the network administrator. What is
themselves as the root
the first step of the spanning-tree election process? bridge.

What is the term that is used for the area of a network that failure domain
is affected when a device or network service experiences
problems?
Which switchport mode puts the interface into permanent switchport mode access
nontrunking ?
Which PAgP mode forces the interface to channel without On
PAgP?
How much traffic is a 48-port gigabit switch capable of 48 Gb/s, by providing full
switching when operating at full wire speed? bandwidth to each port
allows the switch to deliver power to a device over the PoE

m
existing Ethernet cabling.

er as
Which type of router would an enterprise use to allow network edge routers

co
eH w
customers to access content anytime and anyplace,
regardless of whether they are at home or work?

o.
Which network design solution will best extend access layer implementing wireless
rs e
ou urc
connectivity to host devices? connectivity
What value determines the root bridge when all switches MAC address
connected by trunk links have default STP configurations?
o

Which switchport mode Puts the interface into permanent switchport mode trunk
aC s

trunking mode and negotiates to convert the neighboring


vi y re

link into a trunk link?


Which command will start the process to bundle two interface range
physical interfaces to create an EtherChannel group via GigabitEthernet 0/4 - 5
ed d

LACP?
ar stu

When PVST is running over a switched network, which port listening


state can participate in BPDU frame forwarding based on
BPDUs received, but does not forward data frames?
is

A network administrator enters the following command to make the Gi0/1 port a
Th

sequence on a Cisco 3560 switch. What is the purpose of routed port


these commands?
Which combination of DTP modes set on adjacent switches dynamic auto - dynamic
sh

will cause the link to become an access link instead of a auto


trunk link?
Which technology is required when switched networks are Spanning Tree Protocol
designed to include redundant links?

This study source was downloaded by 100000815899376 from CourseHero.com on 11-22-2021 22:37:01 GMT -06:00

https://www.coursehero.com/file/109914306/data-com-3-prelimpdf/
Displays information about the routed protocol that is show protocols
enabled, and the protocol status of interfaces.
is used for initial configuration or when a network Out-of-band management
connection is unavailable.
Which feature could be used in a network design to increase EtherChannel
the bandwidth by combining multiple physical links into a
single logical link?
A network administrator is analyzing the features that are HSRP uses active and
supported by different first-hop router redundancy standby routers.
protocols. Which statement describes a feature that is
associated with HSRP?
As the network administrator you have been asked to grouping multiple physical
implement EtherChannel on the corporate network. What ports to increase
does this configuration consist of? bandwidth between two

m
er as
switches

co
Which switchport mode makes the interface able to convert switchport mode dynamic

eH w
the link to a trunk link? auto

o.
define the processing capabilities of a switch by rating how forwarding rates
rs e
much data the switch can process per second.
ou urc
A PC is to access a web server on another network. Which multilayer switch with
inter-VLAN method will provide the highest bandwidth at routing enabled
Layer 3 and also provide a default gateway for the PC?
o
aC s
vi y re
ed d
ar stu
is
Th
sh

This study source was downloaded by 100000815899376 from CourseHero.com on 11-22-2021 22:37:01 GMT -06:00

https://www.coursehero.com/file/109914306/data-com-3-prelimpdf/
Powered by TCPDF (www.tcpdf.org)

You might also like