WE2 Ece

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 2

CERTC - DAVAO WEEKLY EXAM 1 ELECS

Electronics Engineering
Instruction: Select the correct answer for each of the following
questions. Mark only one answer for each item by shading the box 13. A non-inductive resistance and a condenser are connected in series
corresponding to the letter of your choice on the answer sheet across 220 V, 60 cycle mains. They are adjusted so that the current
provided. is 8 amperes and the power absorbed is 250 watts, what is the
resistance?
Strictly no erasures allowed. Use pencil no. 1 only. a. 3.91 ohms* b. 4.67 ohms c. 5.12 ohms d. 6.10 ohms
NOTE: Whenever you come across a caret (^) sign, it means
exponentiation 14. What happens to total resistance in a circuit with parallel resistors if
one of them opens?
1. Permeability is the inverse equivalent of which electrical term?
A. Voltage C. Resistance*
A. It increases.* C. It remains the same.
B. Current D. Conductance
B. It halves. D. It decreases.

2. What are the effects of moving a closed wire loop through a 15. What is the total power loss if 2 kohm and 1 kohm parallel-
magnetic field? connected resistors have an IT of 3 mA?
A. A voltage is induced in the wire. A. 6 uW B. 36 uW C. 6 mW* D. 36 mW
B. A current is induced in the wire.
C. The polarity across the wire depends on the direction of motion. 16. Inductance is:
D. All of the above* A. directly proportional to the length of the coil
B. directly proportional to the number of turns on the coil*
3. What is the total capacitance? C. inversely proportional to the cross-sectional area of the coil
D. inversely proportional to the permeability

17. With 21 V applied, if R1 = 5 ohms, R2 = 35 ohms, and R3 = 14


ohms, what is the current of R2 if R1 is series connected with
parallel circuit R2 and R3?
A. 200 mA C. 600 mA
A. 1 F B. 12 F* C. 0.615 F D. 8 F B. 800 mA D. 400 mA*
4. When parallel resistors are of three different values, which has the 18. Two inductors, of inductance 25 mH and 40 mH respectively, are
greatest power loss? wound on a common ferromagnetic core, and are connected in
A. The smallest resistance* series with each other. The coupling coeffi cient, k, between them is
B. The largest resistance
0.8. When the current fl owing through the two coils is 0.25 A,
C. They have the same power loss.
D. Voltage and resistance values are needed. calculate the total energy stored when the coils are connected in
series aiding.
5. On a schematic, dashed lines between two vertical coils usually a. 1.25 mJ b. 1.58 mJ c. 3.6mJ* d. 4.9 mJ
mean the transformer has:
19. A toroid has a core of square cross section, 2500 mm2 in area,
A. an air core C. an iron core and a mean diameter of 250 mm. The core material is of relative
B. a nonmetallic core D. a ferrite core* permeability 1000. (a) Calculate the number of turns to be wound
on the core to obtain an inductyance of 1 H.
6. What is the secondary voltage in the given circuit? a. 200 b. 300 c. 400 d. 500*

20. A current is flowing through a conductor with non-uniform area of


cross-section. Then
A. current will be different at different cross-sections.
B. current will be the same at all the cross-sections.
C. current will be different but current density will be same at all the
A. 13.3 V rms in phase with the primary cross-sections
B. 120 V rms in phase with the primary D. current will be the same but current density will be different at
C. 13.3 V rms out of phase with the primary* different cross-sections. *
D. 120 V rms out of phase with the primary 21. If the diameter of a wire is doubled, the current carrying capacity of
the wire becomes
A. Half C. twice
7. If the primary power of an ideal transformer having a 2:1 voltage
B. four times * D. one-fourth
ratio is 100 W, the secondary power is
A. 100 W* B. 75 W C. 50 W D. 200 W 22. A 60W-100V tungsten lamp has a resistance of 20 ohms at air
temperature (0◦C). What is the rise in temperature of the filament
8. Which two values are plotted on a B-H curve graph?
under normal working conditions? The temperature coefficient of
A. reluctance and flux density
resistance of tungsten is 0.0052/◦C.
B. permeability and reluctance
C. magnetizing force and permeability a. 1192 C b. 1250 C c. 1332 C d. 1410 C*
D. flux density and magnetizing force*
23. An air capacitor with plates 1m2 and 0.01m apart is charged with
9. In a step-up transformer, the turn’s ratio is 1:2. A Leclanche cell 10^−6 C of electricity. Calculate the change in energy which results
(EMF 1.5 volts) is connected across the primary. The voltage when the capacitor is submerged in oil of relative permittivity 2.0.
across the secondary is a. increases by a factor of 2 c. increases by a factor of 4
a. 3.0 volts b. 0.75 volts c. Zero* d. 1.5 volts b.decreases by a factor of 2* d. decreases by a factor of 4

24. Find the energy which may be stored in capacitors of 2 and 4μF
10. The ratio of primary to is 9:4. If power input is P. What will be the
when taken in parallel when a potential difference of 100V is
ratio of power output to the power input?
available.
a. 4:9 b. 9:4 c. 5:4 d. 1:1*
a. .01 J b. .02 J c. .03 J* d. .04 J

11. A charge Q1of 0.20uC is 30cm from another charge Q2 of 3.0uF in 25. What are the effects of moving a closed wire loop through a
vacuum. Calculate the work needed to bring Q1 18 cm closer to Q2. magnetic field?
A. 0.132J B. 0.232J C. 0.079J D. 0.027J * A. A voltage is induced in the wire.
B. A current is induced in the wire.
12. Capacitances of 1μF, 3μF, 5μF and 6μF are connected in parallel to C. The polarity across the wire depends on the direction of motion.
a direct voltage supply of 100V. Determine the total charge. D. All of the above *
A. 0.3 mC B. 2.1 mC C. 1.5 mC * D. 1.3 mC

CERTC: MANILA-CEBU--DAVAO Contact Nos. 0932 328 8053/0921 513 3025/09321751218 Page 1
CERTC - DAVAO WEEKLY EXAM 1 ELECS
Electronics Engineering
GOD BLESS. . .

CERTC: MANILA-CEBU--DAVAO Contact Nos. 0932 328 8053/0921 513 3025/09321751218 Page 2

You might also like