ME 203 Final-Exam

,
I Ghulam lshaq Khan Institute of Engineering Sciences and

Technology, Topi-23460.
ME 203 - Circuits and Electronic Prepa red By: J)'.'L. \\~..x_

i--------
1~4,b)} U..-
~~
Devices
Reviewed BY: ~- 1Vl·fltt0\(!() ~'2--
Ins tructor: Dr. Abid Imran Approved By:]){? , ltAA-L(b ),~
Date: 22-01-2022 Final Exam Time: 2hr

e FALL 2021 Total: 60
INSTRUCTIONS
1. Thi s is a closed book and closed notes exam. To receive credit for a problem. yo u must -;how all
the working. Answers without working will be given ZERO credit.
' The use of cell phones or any other sources of communicati on are stri ctly r rnhi hited during
c:--:arn inations. Doing so is considered cheating.
3. Write your name and Reg. no. clearly on the answer sheet.
4 . There is no credit for the assumptions, schematics, governing equations
and units. However, marks will be deducted for not writing them
appropriately.
Marking:
--- T- - -- - - , I
I Q u cstion M arks Obta ined Total .\'Iarks !
- ' -_I I
- --7
IS
~- - '- ---
2
I --·-- - - - -
25
I
I
' I I - -- . _ 1
~ 3
-- ··- - - -- I 20
-·· - -
I
_I
I T otal 60
-----
Ghulam Ishaq Khan Institute of Engineering Sciences and
Technology, Topi-23460.
Faculty of Mechanical Engineering
ME 203 – Circuits and Electronic Prepared By:

Devices
Reviewed BY:
Instructor: Dr. Abid Imran Approved By:
Date: 22-01-2022 Final Exam Time: 2hr
FALL 2021 Total: 60
INSTRUCTIONS
1 . This is a closed book and closed notes exam. To receive credit for a problem, you must show all
the working. Answers without working will be given ZERO credit.
2. The use of cell phones or any other sources of communication are strictly prohibited during
examinations. Doing so is considered cheating.
3. Write your name and Reg. no. clearly on the answer sheet.
4. There is no credit for the assumptions, schematics, governing equations
and units. However, marks will be deducted for not writing them
appropriately.
Marking:
Question Marks Obtained Total Marks
1 15
2 25
3 20
Total 60
Page 1 of 3
Question #01
(a) For Boolean inputs A and B, prove that (𝐴 + 𝐴𝐵̅ ) = 𝐴 + 𝐵. (2)
(b) What are the conditions of BJT (Base Emitter Configuration) in terms of base current to work
in active and saturation modes? (2)
(c) Analyze the circuits in Figure 1 and draw & label the output. Use the practical model of diode.
(6)
Figure (1a) Figure (1b)
(d) For an RLC series circuit, consider the value of R as 100 Ω, L as 40 𝑚𝐻 and C as 100 𝜇𝐹.
will the response be overdamped, underdamped, or critically damped?
For the same 𝑅 and 𝐶 value, what would be the value of L to get the critically damped
1 1 𝐶
response of the system. 𝜔𝑛 = , 𝜉 = 2 𝑅√𝐿 . (5)
√𝐿𝐶
Question #02. (CLO2, PLO1, C4)
A B C X
0 0 0 0
0 0 1 1
0 1 0 1
0 1 1 0
1 0 0 1
1 0 1 0
1 1 0 1
1 1 1 0
(10)
(a) For given truth table, design a digital circuit using Karnaugh map. Outline all the steps clearly
and analyze the output.
(b) Simplify the following Boolean expression by using the Karnaugh map. Outline all the steps
and design a digital circuit of the simplified expression and analyze the output. (10)
𝐹 = 𝐴𝐵̅ 𝐶̅ + 𝐴𝐷 ̅ + 𝐴𝐵̅ 𝐶 + 𝐴̅𝐵̅ 𝐶𝐷

̅ + 𝐴̅𝐵̅ 𝐶̅ 𝐷
̅
(c) The signed numbers are given in table below. (5)
Binary number Form
11000101 sign magnitude
10111010 1’s complement
10111011 2’s complement
Find the decimal value of the given signed numbers and compare your results.
Question #03 (CLO3, PLO2, C4)

(a) A common base-emitter BJT circuit is shown in Figure 2. Analyze this circuit by using the load
lines and find the maximum peak of the base current 𝐼𝑏(𝑝𝑒𝑎𝑘) for linear amplification.
Page 2 of 3
Use 𝑉𝐵𝐵 = 10, 𝑉𝐶𝐶 = 24𝑉, 𝑅𝐶 = 800Ω, 𝑅𝐵 = 50𝑘Ω, 𝛽𝐷𝐶 = 100 (10)
(b) Now increase the value of 𝑅𝐵 by 20% and decrease the value of 𝑅𝐶 by 20%. Again, analyze this
circuit by using the load lines and find the maximum peak of the base current 𝐼𝑏(𝑝𝑒𝑎𝑘) for linear
amplification. Compare you results and comments. (10)
Fig. 2.
Page 3 of 3

ME 203 Final-Exam

Uploaded by

Copyright:

Available Formats

ME 203 Final-Exam

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

ME 203 Final-Exam

Uploaded by

Copyright:

Available Formats

,

I Ghulam lshaq Khan Institute of Engineering Sciences and

ME 203 - Circuits and Electronic Prepa red By: J)'.'L. \\~..x_

Ins tructor: Dr. Abid Imran Approved By:]){? , ltAA-L(b ),~

Date: 22-01-2022 Final Exam Time: 2hr

ME 203 – Circuits and Electronic Prepared By:

Instructor: Dr. Abid Imran Approved By:

Date: 22-01-2022 Final Exam Time: 2hr

FALL 2021 Total: 60

Figure (1a) Figure (1b)

Question #02. (CLO2, PLO1, C4)

𝐹 = 𝐴𝐵̅ 𝐶̅ + 𝐴𝐷 ̅ + 𝐴𝐵̅ 𝐶 + 𝐴̅𝐵̅ 𝐶𝐷

Question #03 (CLO3, PLO2, C4)

You might also like