Ohs-Pr-09-19-F07 (A) Steel Wire Rope Inspection

Download as docx, pdf, or txt
Download as docx, pdf, or txt
You are on page 1of 1

LIFTING MACHINERY & EQUIPMENT

OHS-PR-09-19-F07 (A) STEEL WIRE ROPE INSPECTION

Operating Area: Department:


Project Name:
Contractor Name: Project Type: Contract No.:

WIRE ROPE SLING INSPECTION

Note: Do not “tick”. Write Ok or use the code of the specific deviation in the legend.. If the wire rope is defective, it must be
tagged “Rejected” and must be reported to the person responsible for action. If the wire rope is beyond repair it must be
destroyed and discarded.
OK – Acceptable, NOT - Not Acceptable, ELM– Equipment Lost or Missing, REP – Equipment
LEGEND
Being Repaired, N/A – Not Applicable
RAISE THE ISSUES THROUGH CORRECTION REPORT (BEFORE & AFTER PHOTO) FOR ACTION
TAKEN
WIRE ROPE HOOKS SHACKLES

saddle, Load pinWear on eye, clevis,


fittingsFitting splices, Securing of

Spread in throat opening


Drying out of lubrication

Cracked, nicked, chaffed


Fatigue: Square breaks

Maximum Mass Load


Wear on pin/threads
Mechanical Damage
Wear / Corrossion

General Condition
Kinks / deforming

Side bending
Departme Accept
S.
ID NO nt/ ed /
N
Location Rejecte
d

1
2
3
4
5
6
7
8
9
10
11
12
13
14
15

ID No (Fault) Comments

Inspector Name: __________________ Signature: ________________ Date: ___________

Site Manager Name: _______________ Signature: _________________ Date: ___________

OHS Forms  Procedure Reference Revision Number Revision Date Approved By


STEEL WIRE ROPE INSPECTION OHS-PR-09-19-F07(A) 0 MAY 2021 OHSMS

You might also like