Product Brief

SDFE-4/2/1
Symmetric DSL Front End, 4/2/1
Channel
SDFE-4, PEF 24624 E
SDFE-2, PEF 22624 E
SDFE-1, PEF 21624 E

The SDFE-4/2/1 are the latest members of Infineon’s 2 nd generation Loop Interface
SOCRATES ® family of SHDSL transceivers designed for pure TDM ■ Line probing according ITU-T G.991.2
applications. (2004)
The SDFE-4/2/1 features full compliance with the ETSI TS 101524 ■ Flexible setting of PSD shaping
and the ITU G.991.2 (G.SHDSL/G.SHDSL.bis) standards. Advanced ■ Highly sophisticated TC-PAM line coding
system functionality and cost saving features continue to provide ■ Programmable framer
significant low BOM advantages in the SOCRATES tradition. ■ Supported TDM clocks: 1.544 MHz,
These features, in combination with an unprecedented power 2.048 MHz, 2.312 MHz, 4.096 MHz,
consumption of approximately 500 mW per channel, and a very 8.192 MHz, 16.384 MHz
small footprint, make the SDFE-4/2 excellent solutions for remote
powered repeater designs.
EOC
■ 4/2/1 integrated HDLC controllers for EOC
Applications handling (one per channel)
■ ISDN primary rate access replacement ■ 128-byte FIFO for transmit and receive
■ SHDSL repeater/regenerator direction per channel
■ Digital Loop Carrier (DLC) Systems
■ Extended range full and fractional E1/T1
■ RITL and WLL systems Customer Interface
■ Wireless infrastructure ■ Universal TDM interface
■ SDH and SONET termination ■ Bit-serial interface
■ TU-12 transport
■ Leased line services
Modes
■ PBX trunk lines
■ Line termination unit LTU (STU-C)
■ Network termination unit NTU (STU-R)
Features ■ Regenerator unit COT/RT (SRU-C/R)
■ Fully integrated 4/2/1 channel transceiver solution, including DSP,
microcontroller, analog front end (AFE), line driver and memory,
Physical Characteristics
in a single integrated chip
■ Support of payload data rates from 144 kbit/s up to 6.392 kbit/s ■ Only two power supplies: 3.3 V, 1.8 V
with 8 kbit/s granularity (exceeding G.SHDSL.bis) ■ Power consumption approximately 500 mW
■ M-pair functionality integrated per channel
■ Temperature range -40°C to +85°C
■ Tunable hybrid for optimal loop adaptation and reach
■ Package P-LBGA-324 (19 mm x 19 mm)
■ Only a few external passive components required
■ SDFE-4/2/1 are pin and software compatible

w w w. i n f i n e o n . c o m / p r o d u c ts

Wireline Communications

N e v e r s t o p t h i n k i n g .
This Data sheet can be found on https://www.jotrin.com
 Product Brief
SDFE 4/2/1 PHY Block Diagram

Serial
Host
I/F LD
µC DSP AFE
Hybrid

LD
TDM
DSP AFE
Hybrid
TDM M-Pair
Framer Unit
LD
DSP AFE
Hybrid

LD
DSP AFE
Hybrid

Ordering Information
SDFE-4/2/1
Product Sales Code Product Description Package
PEF24624E SDFE-4 4-Channel Symmetric DSL Front End P-LBGA-324
PEF22624E SDFE-2 2-Channel Symmetric DSL Front End P-LBGA-324
PEF21624E SDFE-1 1-Channel Symmetric DSL Front End P-LBGA-324

E1/T1 Replacement
Application Example
4x 4x
E1/T1/J1 PCM SHDSL

QuadFALC SDFE-4
(PEF 22554) (PEF 24624)

Board
Controller

How to reach us: Attention please! Warnings

http://www.infineon.com The information herein is given to describe certain components Due to technical requirements components may contain danger-
and shall not be considered as a guarantee of characteristics. ous substances. For information on the types in question please
Published by
Terms of delivery and rights to technical change reserved. contact your nearest Infineon Technologies Office.
Infineon Technologies AG,
We hereby disclaim any and all warranties, including but not Infineon Technologies Components may only be used in life-
St.-Martin-Strasse 53,
limited to warranties of non-infringement, regarding circuits, support devices or systems with the express written approval of
81669 München
descriptions and charts stated herein. Infineon Technologies, if a failure of such components can rea-
© Infineon Technologies AG 2004. sonably be expected to cause the failure of that life-support de-
All Rights Reserved. Information vice or system, or to affect the safety or effectiveness of that de-
For further information on technology, delivery terms vice or system. Life support devices or systems are intended to
and conditions and prices please contact your nearest be implanted in the human body, or to support and/or maintain
Template: pb_tmplt.fm/4 Infineon Technologies Office. and sustain and/or protect human life. If they fail, it is reasonable
to assume that the health of the user or other persons may be
endangered.

Ordering No. B115-H8424-X-X-7600

Printed in Germany
Published by Infineon Technologies AG PS 06041. nb