MSDS Oil Gold
MSDS Oil Gold
MSDS Oil Gold
1.2. Relevant identified uses of the substance or mixture and uses advised against
Korea + 82 2 3772-5655
2. HAZARDS IDENTIFICATION
GHS Classification
Version GHS
Page 2 / 9
3. COMPOSITION/INFORMATION ON INGREDIENTS
3.1. Mixture
Chemical Name CAS-No EC-No Weight %
1-Dodecane, trimer, Hydrogenated 68037-01-4 - 70.0 ~ 75.0
Decanoic acid, eater with 2-ethyl-2-
11138-60-6 - 4.0 ~ 8.5
(hydroxymethyl-1,3-propanediol octanoate)
Mixed Performance Additive Mixture - 12.0∼13.5
Viscosity Modifier Additive Mixture - 8.7∼11.3
Polymer, Esters of methacrylic acid and
Mixture - 0.01∼0.5
Mixed long chain alcohols
Polymerized dimethyl silicone fluid Mixture - 0.001∼0.1
Additional information Product containing mineral oil with less than 3% DMSO extract as measured by
IP 346
Eye contact Rinse thoroughly with plenty of water, also under the eyelids.
Skin contact Remove contaminated clothing and shoes. Wash skin with soap and water.
Wash contaminated clothing before reuse. High pressure jets may cause skin
damage. In this case, the casualty should be sent immediately to hospital.
4.2. Most important symptoms and effects, both acute and delayed
Not classified. High pressure injection of the products under the skin may have
Skin contact
very serious consequences even though no symptom or injury may be
apparent.
Inhalation Not classified. Inhalation of vapors in high concentration may cause irritation of
respiratory system.
Ingestion Not classified. Ingestion may cause gastrointestinal irritation, nausea, vomiting
and diarrhea.
4.3. Indication of immediate medical attention and special treatment needed, if necessary
Version GHS
Page 3 / 9
5. FIRE-FIGHTING MEASURES
Suitable extinguishing media CO2, dry chemical, dry sand, alcohol-resistant foam.
Special Hazard Incomplete combustion and thermolysis may produce gases of varying toxicity
such as carbon monoxide, carbon dioxide, various hydrocarbons, aldehydes
and soot. These maybe highly dangerous if inhaled in confined spaces or at
high concentration.
Special protective equipment for fire- Wear self-contained breathing apparatus and protective suit.
fighters
Other information Cool containers / tanks with water spray. Fire residues and contaminated fire
extinguishing water must be disposed of in accordance with local regulations.
General Information Do not touch or walk through spilled material. Contaminated surfaces will be
extremely slippery.
Use personal protective equipment. Ensure adequate ventilation. Remove all
sources of ignition.
General Information Do not allow material to contaminate ground water system. Try to prevent the
material from entering drains or water courses.
Local authorities should be advised if significant spillages cannot be contained.
Methods for containment Dam up. Contain spillage, and then collect with non-combustible absorbent
material, (e.g.sand, earth, diatomaceous earth, vermiculite) and place in
container for disposal according to local / national regulations (see section 13).
Keep in suitable, closed containers for disposal.
Advice on safe handling When using, do not eat, drink or smoke. For personal protection see section 8.
Use only in well-ventilated areas. Do not breathe vapors or spray mist. Avoid
contact with skin, eyes and clothing.
Prevention of fire and explosion Take precautionary measures against static discharges. Ground/bond
containers, tanks and transfer/receiving equipment.
Hygiene measures Ensure the application of strict rules of hygiene by the personnel exposed to the
risk of contact with the product. Regular cleaning of equipment, work area and
clothing is recommended. Wash hands before breaks and immediately after
handling the product. Do not use abrasives, solvents or fuels. Do not dry hands
with rags that have been contaminated with product. Do not put product
contaminated rags into workwear pockets.
Technical measures/Storage Keep away from food, drink and animal feedingstuffs. Keep in a bunded area.
conditions Keep container tightly closed. Keep preferably in the original container.
Otherwise reproduce all indication of the regulation label on the new container.
Do not remove the hazard labels of the containers (even if they are empty).
Design the installations in order to avoid accidental emissions of product (due to
seal breakage, for example) onto hot casings or electrical contacts. Protect from
frost, heat and sunlight. Protect from moisture.
Exposure limits oil mist : 10mg/m3, for 15 minutes; oil mist : 5mg/m3, for 8 hours
Engineering Measures Apply technical measures to comply with the occupational exposure limits.
When working in confined spaces (tanks, containers, etc.), ensure that there is
a supply of air suitable for breathing and wear the recommended equipment.
General Information
If the product is used in mixtures, it is recommended that you contact the appropriate
protective equipment suppliers. These recommendations apply to the product as supplied.
Respiratory protection When workers are facing concentrations above the exposure limit they must use
appropriate certified respirators. Respirator with combination filter for vapour/particulate
(EN 14387). The use of breathing apparatus must comply strictly with the manufacturer's
instructions and the regulations governing their choices and uses.
Eye Protection If splashes are likely to occur, wear:. Safety glasses with side-shields.
Skin and body protection Wear suitable protective clothing. Protective shoes or boots. Long sleeved clothing.
Version GHS
Page 5 / 9
Hand Protection Hydrocarbon-proof gloves. Fluorinated rubber. Nitrile rubber. Please observe the
instructions regarding permeability and breakthrough time which are provided by the
supplier of the gloves. Also take into consideration the specific local conditions under
which the product is used, such as the danger of cuts, abrasion. If used in solution, or
mixed with other substances, and under conditions which differ from EN 374, contact the
supplier of the EC approved gloves.
General Information The product should not be allowed to enter drains, water courses or the soil.
10.1. Reactivity
Conditions to Avoid Heat (temperatures above flash point), sparks, ignition points, flames, static electricity.
Skin contact . Not classified. High pressure injection of the products under the skin may have very
serious consequences even though no symptom or injury may be apparent.
. LD50 > 2000mg/kg (Rabbit, Dermal), Practically non-toxic.
Inhalation . Not classified. Inhalation of vapors in high concentration may cause irritation of
respiratory system.
Specific effects
Version GHS
Page 7 / 9
Other information
Other adverse effects Characteristic skin lesions (pimples) may develop following prolonged and repeated
exposures (contact with contaminated clothing).
12.1. Toxicity
Toxicity to daphnia and
Chemical Name Toxicity to algae Toxicity to fish
other aquatic invertebrates
1-Dodecene, EL50 > 1000mg/L EL50 > 1000mg/L LC50 > 750mg/L
homopolymer, (96hr, Selenastrum (48hr, Daphnia (96hr, Pimephales
Hydrogenated capricornutum) magna - OECD 202) promelas)
General Information
No information available.
Soil Given its physical and chemical characteristics, the product generally shows low soil
mobility.
Version GHS
Page 8 / 9
Waste from Residues / Unused Should not be released into the environment. Dispose of in accordance with the
Products European Directives on waste and hazardous waste. Dispose of in accordance with
local regulations.
Contaminated packaging Empty containers should be taken to an approved waste handling site for recycling or
disposal.
EWC Waste Disposal No. The following Waste Codes are only suggestions:. 13 01 10. According to the
European Waste Catalogue, Waste Codes are not product specific, but application
specific. Waste codes should be assigned by the user based on the application for
which the product was used.
15.1. Safety, health and environmental regulations/legislation specific for the substance
or
mixture
International Inventories
EINECS/ELINCS
TSCA
KECL
Legend
EINECS/ELINCS - European Inventory of Existing Commercial Chemical Substances/EU List of Notified Chemical Substances
TSCA - United States Toxic Substances Control Act Section 8(b) Inventory
KECL - Korean Existing and Evaluated Chemical Substances
Further information
15.2. Chemical Safety Assessment
Abbreviations, acronyms
Legend Section 8
+ Sensitizer * Skin designation
** Hazard Designation C: Carcinogen
M: Mutagen R: Toxic to reproduction
Version GHS
Page 9 / 9
This safety data sheet serves to complete but not to replace the technical product sheets. The information contained
herein is given in good faith and is accurate to the best of knowledge at the date indicated above.It is understood by
theuser that any use of the product for purposes other than those for which it was designed entails potential
risk.The
information given herein in no way dispenses the user from knowing and applying all provisions regulating his
activity.The user bears sole liability for the precautions required when using the product.The regulatory texts
indicated herein are intended to aid the user to fulfil his obligations. This list is not to be considered complete and
exhaustive.It is the user's responsibility to ensure that he is subject to no other obligations than those mentioned.
Version GHS