CURTIS E23 Pump

Download as pdf or txt
Download as pdf or txt
You are on page 1of 8

CAP930

REV F (APRIL 2012)

CA Series
TWO STAGE RECIPROCATING AIR COMPRESSOR

PARTS LIST
E23
_______________________________ _______________________________

Model Serial #

Please have your serial number ready when calling for service. The serial number is located on the
compressor nameplate.

For Customer Service, Technical Service, or to order replacement


parts, please contact your local distributer.
SAFETY PRECAUTIONS

The owner, lessor or operator of any compressor unit manufactured by FS Curtis, Inc. is hereby warned
that failure to observe all safety precautions may result in serious injury of personnel and/or damage to
property.

FS Curtis, Inc. neither states as fact, nor in any way implies that this list of safety precautions is an all-
inclusive list, the observance of which will prevent all damage to property or injury to personnel.

Every reasonable effort has been taken to ensure that complete and correct instructions have been
included in this manual. However, possible updates and changes may have occurred since this printing.
FS Curtis, Inc. reserves the right to change specifications, without incurring any obligation for equipment
previously or subsequently sold.

Compressors and/or units are assembled to comply with the customer’s purchase order and in
compliance with FS Curtis, Inc. specifications; alteration must not be made to the compressor or unit
without FS Curtis’ written approval.

DANGER!

Air used for breathing or food processing must meet O.S.H.A 29 C.F.R.
1910.134 or F.D.A. 21 C.F.R. 178.350 regulations. Failure to do so will
cause severe injury or death.
Use of FS Curtis Compressors to transfer toxic, radioactive, flammable, or explosive substances
is prohibited
Do not install the compressor in an area where there is a risk of exposure to explosive gases or
combustible dusts, such as flours, starches, coke, coal dust, etc. or in close proximity to corrosive
substances
Do not operate the compressor above or below its maximum rated RPM, consult technical data
for more information
Surface temperatures can exceed 400 °F, power off the unit and allow it to cool before touching
any surface of the compressor
ITEM DESCRIPTION QTY PART NUMBER
AIR STRAINER
1 Air Strainer Assembly 2 2601540010
2 Air Strainer Element (Not Shown) 2 2601540050

VALVE & UNLOADERS


3 Unloader Assembly 3 2601021441
4 Unloader Piston 3 2601021471
5 O-Ring (Unloader) 3 2111010004
6 Unloader Spring 3 2601021490
7 Unloader Cylinder 3 2601021450
8 Outlet Valve Push Cover (1st) 2 2601021510
9 Outlet Valve Push Cover Gasket (1st) 2 2601021531
10 Outlet Valve Spring (1st) 2 2601320030
11 Inlet & Outlet Valve Plate (1st) 4 2501310020
12 Inlet Valve Spring (1st) 2 2601310190
13 Inlet Valve Receiver (1st) 2 2601310170
14 Inlet Valve Snap Ring (1st) 2 2111030029
15 Outlet Valve Push Cover (2nd) 1 2601020280
16 Outlet Valve Push Cover Gasket (2nd) 1 2601020300
17 Outlet Valve Spring (2nd) 1 2601320390
18 Inlet & Outlet Valve Plate (2nd) 2 2501310010
19 Inlet Valve Spring (2nd) 2 2601311470
20 Inlet Valve Receiver (2nd) 1 2601310010
21 Inlet Valve Snap Ring (2nd) 1 2111030027

CYLINDERS HEAD
22 Cylinder Head Bolt (1st); M8 x L25, Gr 8.8 9 2102010189
23 Cylinder Head (1st) 2 2601021340
24 Head - Cylinder Gasket (1st) 2 2601021381
25 Cylinder Head Bolt (2nd); M6 x L25, Gr 8.8 4 2102010136
26 Cylinder Head (2nd) 1 2601029360
27 Cylinder & Head Gasket (2nd) 1 2601029380

CYLINDER, PISTON & RING


28 Compression Ring (1st) 4 2601021890
29 Oil Control Ring (1st) 2 2601035680
30 Piston (1st) 2 2601021883
31 Piston Pin (1st) 2 2601021940
32 Piston Pin Snap Ring (1st) 6 2601021930
33 Cylinder (1st) 2 2601021570
34 Cylinder Bolt (1st); M8 x L20, Gr 8.8 20 2102010180
35 Cylinder Bolt Copper Washer (1st); M8 20 2102040082
36 Cylinder - Case Gasket 3 2601021620
37 Compression Ring (2nd) 2 2601020810
38 Oil Control Ring (2nd) 2 2601020840
39 Piston Pin (2nd) 1 2601029480
40 Piston (2nd) 1 2601029450
41 Cylinder (2nd) 1 2601029400

CONNECTING ROD & OIL SPLASH DIPPER


42 Connecting Rod Assembly (1st) 2 2601021950
43 Oil Splash Dipper 2 2601025702
44 Oil Splash Dipper Bolt Spring Washer; M4 2 2102040129
45 Oil Splash Dipper Bolts; M4 x L10, Gr 8.8 3 2102011519
46 Connecting Rod Assembly (2nd) 1 2601025982
47 Oil Splash Dipper 1 2601029280

CRANKCASE & CRANKSHAFT


48 Breather Assembly (Rubber) 1 2601020730
49 Rear Bearing Cover 1 2601025620
50 Rear Bearing Cover Gasket 1 2601025650
51 Front & Rear Bearing 2 2110020102
52 Crankshaft 1 2601035560
53 V–Pulley Pin 1 2601021680
54 Front Oil Seal 1 2601025680
55 Screw-in Oil Level Glass 1 2601037952
56 O-ring (Oil Level Glass) 1 2111010210
57 Crankcase Oil Plug (1/4" PT) 1 2102020114
58 Crankcase 1 2601029430
59 Oil Fill Cap 1 2601020600
60 O-ring (Oil Fill Cap) 1 2111010012
61 Front Bearing Cover Gasket 1 2601025590
62 Front Bearing Cover 1 2601025560
63 Compressor Pulley 1 2601234241
64 Compressor Pulley Thrust Washer 1 2601230800
65 Compressor Pulley Spring washer; M8 1 2102040137

DISCHARGE PIPING
66 Outlet Piping Joint 1 2601491741
67 Discharge Piping Assembly 1 2601491770
68 Outlet Piping Joint 3 2601490751
69 Discharge Piping Assembly 1 2601491800

UNLOADER PIPING
70 Unloader Elbow 1 VA786
71 Unloader Tube Assembly 2 2601410270
72 Unloader Copper Tee 2 VA787
NOTES
FS Curtis
1905 Kienlen Ave., St. Louis, MO 63133
(800) 925-5431 FAX (314) 381-1439
EMAIL: [email protected]
Website: www.fscurtis.com

You might also like