Nissan: Immo Emulator, For NATS 5 / 5.6 System

Download as pdf or txt
Download as pdf or txt
You are on page 1of 1

NISSAN

Immo emulator, for


NATS 5 / 5.6 system

Description:
For Nissan cars equipped with NATS 5 or NATS 5.6 systems.

How to install and align with ECU:


There are 3 methods possible:
Method 1: using diagnostic tool -
 install emulator in place of NATS unit: Line to
pin1, GND to pin4, +12 to pin7
 launch re-learn procedure using diagnostic tool. By
default PIN code is 5523.
Method 2: via ECU dump -
 write syncro bytes (MAC) into ECU dump directly. By default MAC is 3A4F.
Method 3: update emulator data to match ECU using configurator software and any K-Line
compatible adapter:
 place solder joint to short JUMPER,connect emulator to k-line adapter and power supply,
launch software,
 replace PIN and MAC with any valid values you wish (PIN is your choice, but MAC
must match value already stored into ECU), remove solder joint. Install emulator on car.

LED operation with jumper shorted (WORK mode, normal operation):


 One short blink – 1) on power-up 2) message received
 Four short blinks: ECU not authorized (wrong MAC ?),
 Long blink (LED is ON for 1 second): MAC accepted by ECU, engine start is allowed.
JUMPER
Connection diagram for configuration:

(c) RobinDAB '2017

You might also like