CVVPX308.10R3 Product Specification

CVVPX308.
10R3
6-port sector antenna, 2x 790–960 and 4x 1710–2690 MHz, 65°

HPBW, 3x RET with manual override.
Integrated Internal Remote Electrical Tilt (RET), with independent control of electrical tilt
with manual override on all arrays
OBSOLETE
This product was discontinued on: March 27, 2020
General Specifications
Antenna Type Sector
Band Multiband
Grounding Type RF connector inner conductor and body grounded to reflector and
mounting bracket
Performance Note Outdoor usage
Radome Material ASA, UV stabilized
Radiator Material Low loss circuit board
Reflector Material Aluminum
RF Connector Interface 7-16 DIN Female
RF Connector Location Bottom
RF Connector Quantity, high band 4
RF Connector Quantity, low band 2
RF Connector Quantity, total 6
Remote Electrical Tilt (RET) Information, General

RET Interface 8-pin DIN Female | 8-pin DIN Male
RET Interface, quantity 3 female | 3 male
Dimensions
Width 354 mm | 13.937 in
Length 2025 mm | 79.724 in
210 mm | 8.268 in Page 1 of 4
©2020 CommScope, Inc. All rights reserved. All trademarks identified by ® or ™ are registered trademarks,
respectively, of CommScope. All specifications are subject to change without notice. See www.commscope.com for the
most current information. Revised: September 18, 2020
CVVPX308.10R3
Depth 210 mm | 8.268 in
Array Layout
Electrical Specifications
Impedance 50 ohm
Operating Frequency Band 1710 – 2690 MHz | 790 – 960 MHz
Polarization ±45°
Remote Electrical Tilt (RET) Information, Electrical

Protocol 3GPP/AISG 2.0 (Single RET)
Power Consumption, idle state, maximum 2W
Power Consumption, normal conditions, maximum 13 W
Input Voltage 10–30 Vdc
Internal RET High band (2) | Low band (1)
Electrical Specifications
Frequency Band, MHz 790–890 890–960 1710–1920 1920–2180 2300–2690
Gain, dBi 15.5 15.9 16.5 17.1 17.8
Beamwidth, Horizontal, 65 64 61 60 62.6
degrees
Beamwidth, Vertical, degrees 11.2 10.3 8.3 7.4 5.9
Beam Tilt, degrees 0–10 0–10 0–10 0–10 0–10
Page 2 of 4
CVVPX308.10R3
USLS (First Lobe), dB 18 18 18 18 18
Front-to-Back Ratio at 180°, 27 28 30 35 33
dB
Isolation, Cross Polarization, 25 25 25 25 25
dB
Isolation, Inter-band, dB 30 30 30 30 30
VSWR | Return loss, dB 1.43 | 15.0 1.43 | 15.0 1.5 | 14.0 1.5 | 14.0 1.5 | 14.0
PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150

Input Power per Port, 300 300 250 250 250
maximum, watts
Electrical Specifications, BASTA

Frequency Band, MHz 790–890 890–960 1710–1920 1920–2180 2300–2690
Gain by all Beam Tilts, 15.3 15.7 16.2 16.7 17.4
average, dBi
Gain by all Beam Tilts ±0.3 ±0.2 ±0.4 ±0.3 ±0.5
Tolerance, dB
Gain by Beam Tilt, average, 0 ° | 15.4 0 ° | 15.7 0 ° | 16.3 0 ° | 16.7 0 ° | 17.6
dBi 5 ° | 15.3 5 ° | 15.7 5 ° | 16.2 5 ° | 16.7 5 ° | 17.5
10 ° | 15.2 10 ° | 15.6 10 ° | 16.3 10 ° | 16.7 10 ° | 17.1
Beamwidth, Horizontal ±1.4 ±1.3 ±2.5 ±2.1 ±6.1

Tolerance, degrees
Beamwidth, Vertical ±0.6 ±0.3 ±0.5 ±0.6 ±0.5
Tolerance, degrees
USLS, beampeak to 20° above 18 18 18 18 18
beampeak, dB
Front-to-Back Total Power at 25 26 23 25 27
180° ± 30°, dB
CPR at Boresight, dB 17 15 21 20 17
CPR at Sector, dB 9 9 7 5 7
Mechanical Specifications
Wind Loading at Velocity, frontal 207.3 lbf @ 150 km/h | 904.0 N @ 150 km/h
Wind Loading at Velocity, lateral 348.0 N @ 150 km/h | 78.2 lbf @ 150 km/h
Wind Loading at Velocity, rear 208.8 lbf @ 150 km/h | 929.0 N @ 150 km/h
Wind Speed, maximum 241 km/h | 149.75 mph
Packaging and Weights

Width, packed 420 mm | 16.535 in
320 mm | 12.598 in Page 3 of 4
CVVPX308.10R3
Depth, packed 320 mm | 12.598 in
Length, packed 2210 mm | 87.008 in
Net Weight, without mounting kit 26.1 kg | 57.541 lb
Weight, gross 43 kg | 94.799 lb
Regulatory Compliance/Certifications
Agency Classification
CE Compliant with the relevant CE product directives
CHINA-ROHS Below maximum concentration value
ISO 9001:2015 Designed, manufactured and/or distributed under this quality management system
REACH-SVHC Compliant as per SVHC revision on www.commscope.com/ProductCompliance
ROHS Compliant
Included Products
T-029-GL-E — Adjustable Tilt Pipe Mounting Kit for 2.0"-4.5" (60-115mm) OD round members for panel antennas. Includes 2 clamp sets.
* Footnotes
Performance Note Severe environmental conditions may degrade optimum performance
Page 4 of 4

CVVPX308.10R3 Product Specification

Uploaded by

Copyright:

Available Formats

CVVPX308.10R3 Product Specification

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

CVVPX308.10R3 Product Specification

Uploaded by

Copyright:

Available Formats

CVVPX308.

6-port sector antenna, 2x 790–960 and 4x 1710–2690 MHz, 65°

Performance Note Outdoor usage

Radome Material ASA, UV stabilized

Radiator Material Low loss circuit board

Reflector Material Aluminum

RF Connector Interface 7-16 DIN Female

RF Connector Location Bottom

RF Connector Quantity, high band 4

RF Connector Quantity, low band 2

RF Connector Quantity, total 6

Remote Electrical Tilt (RET) Information, General

RET Interface, quantity 3 female | 3 male

Length 2025 mm | 79.724 in

210 mm | 8.268 in Page 1 of 4

Operating Frequency Band 1710 – 2690 MHz | 790 – 960 MHz

Remote Electrical Tilt (RET) Information, Electrical

Power Consumption, idle state, maximum 2W

Power Consumption, normal conditions, maximum 13 W

Input Voltage 10–30 Vdc

Internal RET High band (2) | Low band (1)

PIM, 3rd Order, 2 x 20 W, dBc -150 -150 -150 -150 -150

Electrical Specifications, BASTA

Beamwidth, Horizontal ±1.4 ±1.3 ±2.5 ±2.1 ±6.1

Wind Speed, maximum 241 km/h | 149.75 mph

Packaging and Weights

320 mm | 12.598 in Page 3 of 4

Length, packed 2210 mm | 87.008 in

Net Weight, without mounting kit 26.1 kg | 57.541 lb

Weight, gross 43 kg | 94.799 lb

You might also like