3M Super 33+ PDF

Scotch® Super 33+™
Vinyl Electrical Tape

Data Sheet October 2014
Description Scotch® Super 33+™ Vinyl Electrical Tape is a premium grade, 7 mil thick, all-weather
vinyl-insulating tape. It is designed to perform continuously in ambient temperatures up
to 105°C (220°F). The tape is conformable for cold weather application down to -18°C
(0°F). It has excellent resistance to abrasion, moisture, alkalies, acids, corrosion and
varying weather conditions (including ultraviolet exposure). The combination of elastic
backing and aggressive adhesive provides moisture-tight electrical and mechanical
protection with minimum bulk. Scotch® Super 33+™ Vinyl Electrical Tape is UL Listed
and is a Canadian Standards Association (CSA) Certified “Insulating Tape.”
 UL Listed; UL 510 Standard “Insulating Tape” (product category OANZ),

File E129200
 CSA Certification; Standard C22.2 No.197-M1983 “PVC Insulating Tape,”
File LR 48769
 Polyvinyl chloride (PVC) backing.
 Pressure-sensitive rubber based adhesive.
 Compatible with solid dielectric cable insulations.
 Compatible with rubber and synthetic splicing compounds, as well as epoxy and
polyurethane resins.
 Inhibits corrosion of electrical conductors.
 For indoor or outdoor applications.
Applications  Primary electrical insulation for all wire and cable splices rated up to 600 volts and
up to 105°C (220°F).
 Primary electrical insulation for 600 volt bus applications, and protective jacketing
for low and high voltage bus.
 Protective jacketing for high voltage cable splices and repairs.
 Harnessing of wires and cables.
Scotch® Super 33+™ Vinyl Electrical Tape is based on polyvinyl chloride (PVC) and/or
Specifications
its copolymers and has a rubber-based, pressure-sensitive adhesive. The tape shall be
7 mils thick, and be UL Listed and marked per UL Standard 510 as “Flame Retardant,
Cold and Sunlight Resistant.” The tape must be applicable at temperatures ranging from
0°F through 100°F (-18°C through 38°C) without loss of physical properties. The tape
shall be classified for use in both indoor and outdoor environments. The tape shall be
compatible with synthetic cable insulations, jackets and splicing compounds. The tape
will remain stable and will not telescope more than 0.1 inches when maintained at
temperatures below 120°F (50°C).
1 of 3
Scotch® Super 33+™ Vinyl Electrical Tape
Agency Approvals  UL Listed; UL 510 Standard “Insulating Tape” (product category OANZ),
& Self Certifications File E129200
 CSA Certification; Standard C22.2 No.197-M1983 “PVC Insulating Tape,”
File LR 48769
 Meets A-A-55809
For RoHS information, please visit www.3M.com/ROHS
Typical Properties Not for specifications. Values are typical, not to be considered minimum or maximum.
Properties measured at room temperature 73°F (23°C) unless otherwise stated.
Physical Properties Typical Value

US units (metric)
Temperature Rating - UL 510 176°F (80°C)
CSA - C22.2 No. 197-M1983
handling 0°F (-18°C)
continuous operation 221°F (105°C)
Color BLACK
Thickness 7 mils (0.177 mm)
Adhesion to Steel (ASTMD 1000)
72°F (22°C) 28 oz/in.
0°F (-18°C) 60 oz/in.
Adhesion to Backing (ASTMD 1000)
72°F (22°C) 28 oz/in.
0°F (-18°C) 60 oz/in.
Backing Strength (ASTMD 1000)
72°F (22°C) 15 lbs/in.
Ultimate Elongation (ASTMD 1000)
72°F (22°C) 250%.
0°F (-18°C) 100%
Flammability (Maximum)
UL 510 1 sec.
ASTM D-1000 4 sec.
Accelerated Aging (ASTM D-1000) 80%
Flagging (ASTM D-1000) <0.1 in.
Telescoping
24 Hours @ 120°F (50°C) <0.1 in
Typical Value
Electrical Property
US units
Voltage Rating - UL 510 600V
Dielectric Strength (ASTM D-1000)
Standard Condition 1,150 V/mil
V/mil High Humidity 90% of std.
Insulation Resistance (ASTM D-1000)
( High Humidity Method) >1x106 megohms
2 of 3
Scotch® Super 33+™ Vinyl Electrical Tape
Shelf Life & This product has a 5-year shelf life from date of manufacture when stored in a humidity
Storage controlled storage (10°C / 50°F to 27°C / 80 °F and <75% relative humidity).
Availability Scotch® Super 33+™ Vinyl Electrical Tape is available from your local 3M authorized
distributor in the following standard roll sizes:
3/4 in. x 66 ft.
3/4 in. x 52 ft.
3/4 in. x 20 ft.
Other lengths and widths are available by special request.
Please contact your local distributor; available from 3M.com/electrical [Where to Buy] or
call 1.800.245.3573.
Engineering/ Primary electrical insulation (branch wiring in wet or dry locations): All splices for 600 volt
Architectural wire rated 105°C (220°F) and below shall be insulated with a minimum of two half-lapped
Specification: layers of Scotch® Super 33+™ Vinyl Electrical Tape. All connectors having irregular
surfaces shall be padded with 3M™ Scotchfil™ Electrical Insulation Putty or Scotch®
Linerless Rubber Splicing Tape 130C prior to insulating with Scotch® Super 33+™ Vinyl
Electrical Tape.
Mechanical protection (outer jacketing): All rubber and thermoplastic insulating high
voltage power cable tape splices and repairs shall be overwrapped with at least two half-
lapped layers of Scotch® Super 33+™ Vinyl Electrical Tape.
Installation Scotch® Super 33+™ Vinyl Electrical Tape shall be applied in half-lapped layers with
Techniques: sufficient tension to produce a uniform wind (for most applications this tension will
reduce the tape’s width to approximately 5/8 of its original width). On pigtail splices, the
tape shall be wrapped beyond the end of the wires and then folded back, leaving a
protective cushion to resist cut-through. Wrap tape up-hill, taping from a smaller
diameter surface to a larger diameter surface. Apply the tape with no tension on the last
wrap to prevent flagging.
3M, Scotch, Scotchfil and Super 33+ are trademarks of 3M Company.
Important Notice All statements, technical information, and recommendations related to 3M’s products are based on information believed to
be reliable, but the accuracy or completeness is not guaranteed. Before using this product, you must evaluate it and
determine if it is suitable for your intended application. You assume all risks and liability associated with such use. Any
statements related to the product, which are not contained in 3M’s current publications, or any contrary statements
contained on your purchase order, shall have no force or effect unless expressly agreed upon, in writing, by an authorized
officer of 3M.
Warranty; Limited This product will be free from defects in material and manufacture at the time of purchase. 3M MAKES NO OTHER
Remedy; Limited WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF MERCHANTABILITY OR
Liability FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated above, your
exclusive remedy shall be, at 3M’s option, to replace or repair the 3M product or refund the purchase price of the 3M
product. Except where prohibited by law, 3M will not be liable for any indirect, special, incidental or
consequential loss or damage arising from this 3M product, regardless of the legal theory asserted.
3M
Electrical Markets Division
6801 River Place Blvd.
Austin, TX 78726-9000 Please recycle
800.245.3573 © 3M 2014 All rights reserved
FAX: 800.245.0329 78-8124-4841-9 Rev D
www.3M.com/electrical
3 of 3

3M Super 33+ PDF

Uploaded by

Copyright:

Available Formats

3M Super 33+ PDF

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

3M Super 33+ PDF

Uploaded by

Copyright:

Available Formats

Scotch® Super 33+™

Vinyl Electrical Tape

 UL Listed; UL 510 Standard “Insulating Tape” (product category OANZ),

For RoHS information, please visit www.3M.com/ROHS

Physical Properties Typical Value

3M, Scotch, Scotchfil and Super 33+ are trademarks of 3M Company.

You might also like