Scribd Logo
Upload

Welcome to Scribd!

  • 55 views

    Root

    Uploaded by

    Rasha Ziyad
    This document is a configuration summary of a Cisco wireless device: - It configures the device hostname as "root", wireless network "WGB-TEST" using WPA2 authentication, and bridges traffic from wireless interfaces to the BVI1 interface. - The BVI1 interface receives its IP address via DHCP and has IPv6 enabled, while the wireless and Ethernet interfaces are configured for bridging traffic to wireless client devices.

    Copyright:

    © All Rights Reserved
    Download as TXT, PDF, TXT or read online from Scribd

    Root

    Uploaded by

    Rasha Ziyad
    55 views3 pages
    This document is a configuration summary of a Cisco wireless device: - It configures the device hostname as "root", wireless network "WGB-TEST" using WPA2 authentication, and bridges traffic from wireless interfaces to the BVI1 interface. - The BVI1 interface receives its IP address via DHCP and has IPv6 enabled, while the wireless and Ethernet interfaces are configured for bridging traffic to wireless client devices.

    Original Title

    root

    Copyright

    © © All Rights Reserved

    Available Formats

    TXT, PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    This document is a configuration summary of a Cisco wireless device: - It configures the device hostname as "root", wireless network "WGB-TEST" using WPA2 authentication, and bridges traffic from wireless interfaces to the BVI1 interface. - The BVI1 interface receives its IP address via DHCP and has IPv6 enabled, while the wireless and Ethernet interfaces are configured for bridging traffic to wireless client devices.

    Copyright:

    © All Rights Reserved
    Download as TXT, PDF, TXT or read online from Scribd
    Download as txt, pdf, or txt
    55 views3 pages

    Root

    Uploaded by

    Rasha Ziyad
    This document is a configuration summary of a Cisco wireless device: - It configures the device hostname as "root", wireless network "WGB-TEST" using WPA2 authentication, and bridges traffic from wireless interfaces to the BVI1 interface. - The BVI1 interface receives its IP address via DHCP and has IPv6 enabled, while the wireless and Ethernet interfaces are configured for bridging traffic to wireless client devices.

    Copyright:

    © All Rights Reserved
    Download as TXT, PDF, TXT or read online from Scribd
    Download as txt, pdf, or txt
    of 3

    root(config)#do show run

    Building configuration...

    Current configuration : 2338 bytes


    !
    ! Last configuration change at 04:22:41 UTC Mon Mar 1 1993
    version 15.3
    no service pad
    service timestamps debug datetime msec
    service timestamps log datetime msec
    service password-encryption
    !
    hostname root
    !
    !
    logging rate-limit console 9
    enable secret 5 $1$RW6Q$GQ6ogSGKLyggXcjwEuE8K/
    !
    no aaa new-model
    no ip source-route
    no ip cef
    !
    !
    !
    !
    dot11 pause-time 100
    dot11 syslog
    !
    dot11 ssid WGB-TEST
    vlan 20
    authentication open
    authentication key-management wpa version 2
    guest-mode
    wpa-psk ascii 7 11584B5643475D5B5C732A
    !
    !
    !
    no ipv6 cef
    !
    !
    username Cisco password 7 1531021F0725
    !
    !
    bridge irb
    !
    !
    !
    interface Dot11Radio0
    no ip address
    !
    encryption vlan 20 mode ciphers aes-ccm
    !
    ssid WGB-TEST
    !
    antenna gain 0
    station-role root
    infrastructure-client
    !
    interface Dot11Radio0.20
    encapsulation dot1Q 20 native
    bridge-group 1
    bridge-group 1 subscriber-loop-control
    bridge-group 1 spanning-disabled
    bridge-group 1 block-unknown-source
    no bridge-group 1 source-learning
    no bridge-group 1 unicast-flooding
    !
    interface Dot11Radio0.40
    encapsulation dot1Q 40
    bridge-group 40
    bridge-group 40 subscriber-loop-control
    bridge-group 40 spanning-disabled
    bridge-group 40 block-unknown-source
    no bridge-group 40 source-learning
    no bridge-group 40 unicast-flooding
    !
    interface Dot11Radio1
    no ip address
    shutdown
    antenna gain 0
    peakdetect
    no dfs band block
    channel dfs
    station-role root
    bridge-group 1
    bridge-group 1 subscriber-loop-control
    bridge-group 1 spanning-disabled
    bridge-group 1 block-unknown-source
    no bridge-group 1 source-learning
    no bridge-group 1 unicast-flooding
    !
    interface GigabitEthernet0
    no ip address
    duplex auto
    speed auto
    !
    interface GigabitEthernet0.20
    encapsulation dot1Q 20 native
    bridge-group 1
    bridge-group 1 spanning-disabled
    no bridge-group 1 source-learning
    !
    interface GigabitEthernet0.40
    encapsulation dot1Q 40
    bridge-group 40
    bridge-group 40 spanning-disabled
    no bridge-group 40 source-learning
    !
    interface BVI1
    mac-address 1cdf.0fb5.3974
    ip address dhcp
    ipv6 address dhcp
    ipv6 address autoconfig
    ipv6 enable
    !
    ip forward-protocol nd
    ip http server
    no ip http secure-server
    ip http help-path http://www.cisco.com/warp/public/779/smbiz/prodconfig/help/eag
    !
    !
    bridge 1 route ip
    !
    !
    !
    line con 0
    line vty 0 4
    login local
    transport input all
    !
    end

    You might also like