Scribd Logo
Upload

Welcome to Scribd!

  • 194 views

    Lifting and Removing Using The Forklift or Telescopic Loader in Site

    Uploaded by

    AMIN
    This Job Safety Analysis identifies the tasks, hazards, and controls for unloading, loading, and placing cold weather materials and equipment using a telescopic loader. The tasks include mobilizing equipment, lifting piles and materials, moving equipment, and releasing loads. Potential hazards include adverse weather, trips and falls, mechanical failures, hits from falling or moving objects, and manual handling injuries. Controls include using permits, reviewing safety procedures, assigning competent workers, delineating work areas, inspecting equipment, following lifting and signaling procedures, wearing personal protective equipment, and implementing emergency response plans.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd

    Lifting and Removing Using The Forklift or Telescopic Loader in Site

    Uploaded by

    AMIN
    194 views3 pages
    This Job Safety Analysis identifies the tasks, hazards, and controls for unloading, loading, and placing cold weather materials and equipment using a telescopic loader. The tasks include mobilizing equipment, lifting piles and materials, moving equipment, and releasing loads. Potential hazards include adverse weather, trips and falls, mechanical failures, hits from falling or moving objects, and manual handling injuries. Controls include using permits, reviewing safety procedures, assigning competent workers, delineating work areas, inspecting equipment, following lifting and signaling procedures, wearing personal protective equipment, and implementing emergency response plans.

    Original Description:

    Lifting and Removing Using the Forklift or Telescopic Loader in Site

    Original Title

    Lifting and Removing Using the Forklift or Telescopic Loader in Site

    Copyright

    © © All Rights Reserved

    Available Formats

    DOCX, PDF, TXT or read online from Scribd

    Did you find this document useful?

    Is this content inappropriate?

    This Job Safety Analysis identifies the tasks, hazards, and controls for unloading, loading, and placing cold weather materials and equipment using a telescopic loader. The tasks include mobilizing equipment, lifting piles and materials, moving equipment, and releasing loads. Potential hazards include adverse weather, trips and falls, mechanical failures, hits from falling or moving objects, and manual handling injuries. Controls include using permits, reviewing safety procedures, assigning competent workers, delineating work areas, inspecting equipment, following lifting and signaling procedures, wearing personal protective equipment, and implementing emergency response plans.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd
    Download as docx, pdf, or txt
    194 views3 pages

    Lifting and Removing Using The Forklift or Telescopic Loader in Site

    Uploaded by

    AMIN
    This Job Safety Analysis identifies the tasks, hazards, and controls for unloading, loading, and placing cold weather materials and equipment using a telescopic loader. The tasks include mobilizing equipment, lifting piles and materials, moving equipment, and releasing loads. Potential hazards include adverse weather, trips and falls, mechanical failures, hits from falling or moving objects, and manual handling injuries. Controls include using permits, reviewing safety procedures, assigning competent workers, delineating work areas, inspecting equipment, following lifting and signaling procedures, wearing personal protective equipment, and implementing emergency response plans.

    Copyright:

    © All Rights Reserved
    Download as DOCX, PDF, TXT or read online from Scribd
    Download as docx, pdf, or txt
    of 3

    JOB SAFETY ANALYSIS

    Facility / Site: GORDHAB Location within Site: TATAOUINE Permit No: Permit Type: COLD Date:

    Task Description: Unloading, loading and placing of CW materials and equipments using telescopic loader

    REQUIRED REFERENCES JSA REVIEW


    Have the relevant Procedures, Standards, Guidelines,
    or Safe Work Practices been reviewed? Yes N/A
    Pending confirmation by the Task Leader of site conditions, I agree that the attached JSA identifies the
    significant Task Steps, Hazards, and Controls.

    JSA REVIEWER (Supervisor or Designate):


    RISK ASSESSMENT
    Must existing Procedures or Work Practices be
    Yes No Name / Signature: Company: SOCOBAT
    modified to perform this work?
    After mitigation, are there any hazards that continue to WORK SITE VERIFICATION
    present a potentially significant risk? (Scenario-Based Yes No
    Risk Assessment required)
    The Work Team has assessed the worksite conditions and confirms:
     The JSA addresses the applicable hazards and necessary controls.
    PPE REQUIRED DURING THIS TASK
     The Team has the appropriate resources (people and equipment) to do the job safely.
    HARD HAT SAFETY GLASSES
     Others that could be affected by the work have been informed.
    FACE SHIELD TASK LEADER:
    SAFETY SHOES / BOOTS
    GOGGLES

    Name / Signature: Company:


    FALL PROTECTION
    FALL RESTRAINT
    COMPLETE THE SECTION BELOW IF THIS JSA IS NOT PART OF A PERMIT PACK
    GLOVES:
    COTTON Work Team Declaration:
    LEATHER I acknowledge that I have reviewed the attached JSA, I understand my roles
    and responsibilities, and I will comply with the instructions for this task.
    IMPACT PROTECTION
    Name (print): Name (print):
    Dust mask OTHER (specify):
    Work clothes

    OTHER PPE (specify): High Vis Jacket


    TASK STEPS POTENTIAL HAZARDS HAZARDS CONTROLS HAZARD PORT
    (Number) (What could go wrong?) (How can harm be prevented?) MITIGATION STATES
    Mob of equipments Adverse weather conditions PTW/TBT ENI Emergency
    Trips/falls Adequate PPE /First aid response plan
    Accident Manual handling technique (medical treatment)
    ill-health-eye problem Speed limit
    severe injuries Secured load
    Beacon lights
    PIC to be on place
    Limit the area
    -Lifting PILES, CW materials or Failure of loading Barricaded work area ENI Emergency
    equipment (tower light, Cabine Mechanical failure Banks man to be present response plan
    generator, compressor, form Possible personnel injury Lifting procedure (medical treatment )
    work, reinforcement steel, Hurt and damage to the personal and or equipment A competent operator
    formwork……..) using the Non competent workers Good supervision
    forklift or telescopic Poor communication PTW/TBT
    Not clear vision Ensure good communication
    Falling objects Only competent workers
    Stuck with another equipment onsite Vitesse to be limited

    Equipment damage Adequate PPE ENI Emergency


    - Moving the equipment Falling hazards / Unbalanced load Barricaded work area response plan
    Mechanical failure Competent Banks man (medical treatment)
    Hit another equipment and or a worker Good communication

    - Release of CW materials or Damage to the equipment Only trained riggers to handle load. ENI Emergency
    equipment. possible personnel injury Keep hands away from nipping points response plan
    Slips /trips Adequate PPE (medical treatment)
    Manual handling Correct Manual Handling
    Muscle skeletal injuries House keeping
    Poor communication Tag line to be used
    Adverse weather condition: Bites Job rotation to be applied and share outdoors ENI Emergency
    Scorpions and snakes Poisonous insects activities between all workers response plan
    Slip, trips and fall Big and fresh quantity of water to be displayed (medical treatment)
    Dehydration Manual technique
    Heat struck Awareness session to workers to aware them
    Dizziness about hazards associated with poisonous insects
    Fatigue First aid kit and first aider should be available
    Working in extreme temperature Frequent breaks to be taken for recovery
    Workers should wear adequate coverall
    Time management culture among work force
    -End of the job and Slips trips and falls Perform good housekeeping ENI Emergency
    housekeeping Backpain Adequate PPE response plan
    Heavy load Manual handling techniques (medical treatment)

    Name Position Date Signed


    Prepared By
    Checked By HSSE Supervisor
    Approved By

    You might also like