Part B & Part C Questions - Unit Wise: Ec8251 Circuit Analysis
Part B & Part C Questions - Unit Wise: Ec8251 Circuit Analysis
Part B & Part C Questions - Unit Wise: Ec8251 Circuit Analysis
om
1. Find the current flowing in the 40Ω Resistor, R3
.c
ul
2. For the a.c. network shown in Figure determine, using mesh-current analysis, (a) the mesh currents
I1 and I2 (b) the current flowing in the capacitor, and (c) the active power delivered by the 100∠0◦V
voltage source
pa
jin
.re
3. State incidence matrix and its properties. Also describe the relationship between KCL and incidence
w
matrix
4. Analyze the given electrical network and draw its topological graph, write its incidence matrix, tie-set
matrix, link current transformation equation and branch currents.
w
w
5. Find the current through each resistor of the circuit shown in fig, using nodal analysis
6. For the a.c. network shown in Figure, determine the current flowing in each branch using Kirchhoff’s
laws.
om
.c
7. Design Dual circuit for the given figure.
ul
pa
jin
Unit II
.re
1. For the circuit shown in Figure 5.23 calculate (a) the value of resistor Rx such that the total power
dissipated in the circuit is 2.5kW, and (b) the current flowing in each of the four resistors.
w
w
w
om
5. Explain the thevenin’s equivalent circuit for the network shown below
.c
ul
pa
Unit III
1. Discuss the bandwidth of a series RLC circuit as a function of resonant frequency.
2. Interpret the expression for the following: (i) Half power frequencies (ii) Selectivity (iii) Quality factor
and its effect on bandwidth.
jin
5. A coil of inductance 5 mH and resistance 10 Ω is connected in parallel with a 250 nF capacitor across
a 50 V variable-frequency supply. Determine (a) the resonant frequency, (b) the dynamic resistance,
(c) the current at resonance, and (d) the circuit Q-factor at resonance.
6. A series L–R–C circuit has a sinusoidal input voltage of maximum value 12 V. If inductance, L = 20 mH,
resistance, R = 80 Ω, and capacitance, C = 400 nF, determine (a) the resonant frequency, (b) the value
w
of the p.d. across the capacitor at the resonant frequency, (c) the frequency at which the p.d. across
the capacitor is a maximum, and (d) the value of the maximum voltage across the capacitor.
7. A series RLC circuit has R=10Ω, L=0.54H and C=40µF. The applied voltage is 100V. Find (i) resonant
w
frequency (ii) quality factor (iii) upper half power frequency (iv) lower half power frequency (v)
bandwidth (vi) voltage across inductance at resonance.
w
Unit IV
1. Explain in details about the step response of series RLC circuit.
2. A series RL circuit with initial current I0 in the inductor is connected to a dc voltage V at t = 0. Derive
the expression for instantaneous current through the Inductor for t>0.
3. Derive the expression for instantaneous current through the inductor for t>0. (or) A series RC circuit
with initial current I0 in the inductor is connected to a dc voltage V at t = 0.
4. A sinusoidal voltage of 10 sin 100 is connected in series with a switch and R= 10 ohms and L=0.1H.If
the switch is closed at t=0. Solve the transient current i(t).
5. (i)Describe natural response and transient response (ii) in the circuit shown in figure, identify the
time when the voltage across the capacitor becomes 25 V, after the switch is closed at t=0.
6. Formulate the expression for the current responses of RLC series circuit with sinusoidal excitation.
Assume that the circuits is working in critical damping condition
7. A series RL circuit With R=30 Ω, and L=15H has a constant voltage V=60v applied at t=0 as shown in
om
figure. Assess the current I, the voltage across resistor and the voltage across the inductor.
Unit V
1. Show that (i) Current through purely resistive circuit is in phase the applied voltage. (ii) Current
through pure inductance lags applied voltage by 90 o (iii) Current through pure capacitance leads
applied voltage by 90o.
2. Show that i) Current lags voltage in R-L series circuit ii) Current leads voltage in R-C series circuit
.c
3. Draw the phasor diagram for a series RLC circuit energized by a sinusoidal voltage showing the
relative position of current, component voltage and applied voltage for the following case a) When
XL > Xc b) When XL < Xc c) When XL = Xc.
ul
4. An alternating current i= 414 Sin (2π x 50 x t) A is passed through a series circuit of a resistance of
100 and an inductance of 0.31831 H. find the expression for the instantaneous values of voltage
across, a. The resistance , b. Inductance c. Capacitance
pa
5. The wave form of the voltage and current of a circuit are given by e= 120 Sin (314 t) i= 10 Sin (314 t
+ π∕6) Calculate the value of resistance, capacitance which is connected in series to form the circuit.
Also, Draw wave forms for current, voltage and phasor diagram. Calculate power consumed by the
circuit.
jin
Questions Are Expected for University Exams This May or may Not Be Asked for Exams
Please do not Copy (or) Republish This Questions, Students if You Find the Same Questions in Other
Sources, Kindly report us to [email protected]