Manual Masina Spalat Rufe Incarcare Verticala Whirlpool

Download as pdf or txt
Download as pdf or txt
You are on page 1of 2

EN - TDLR 70230

Max. Load: 7 kg | Max. Spin Speed: 1200 rpm PROGRAMME CHART


A. Programme selector H J. “Lid open” indication
I
B. “Start/Pause” button L J This washing machine is equipped with
C. “Reset/Drain” button automatic safety functions which detect and
diagnose faults at an early stage and react
D. “Temperature” button M K appropriately:
E. “Start delay” button
G K. “Service” indication
F. Child lock button combination
L. “Water tap closed” indication
G. “Spin speed” button F
M. “Clean pump” indication
H. Detergent overdosage indication
A B C D E
I. Programme sequence indicator

Detergents and additives Options Max


Suggested spin
Type of wash / Notes Pre- Main Softener Colours Fresh Start delay Rapid Pre- Intensive Spin
Care Load wash wash speed
Programme Temperature 15° care wash rinse speed
Labels rpm
- Respect the manufacturer's recommendations on the care label
kg
Lightly to normally soiled robust laundry made of cotton, linen, artificial fibres and their
Mixed cold - 60°C 3.0 blends. – Yes i i i i – – i i max.
Effective one-hour programme. Make sure to wash only similar colours together in one wash load.
Normally to heavily soiled towels, underwear, table and bed linen etc. made of cotton and
Cotton cold - 95°C 7.0
linen.
i Yes i i i i i i i i max.

Normally soiled garments made of artificial fibres (like polyester, polyacryle, viscose etc.) or
Synthetics cold - 60°C 3.0
their blends with cotton.
i Yes i i i i i i i i max

Delicates cold - 40°C 1.5 Curtains and delicate clothing, dresses, skirts, shirts and blouses. i Yes i i i i – i – i 1000 1)
Woollens, labelled with the Woolmark and identified as machine washable, as well as textiles
Wool cold - 40°C 1.0
made of silk (keep to care label!), linen, wool and viscose marked as handwashable.
– Yes i i i i – – – i 1000 1)

Shortly worn clothing made of cotton, polyester, polyamide and blends with cotton.
Rapid 30’ cold - 30°C 3.0
Brief programme to refresh your laundry.
– Yes i i i i – – – i max.
Normally soiled cotton laundry.
At 40°C and 60°C standard cotton programme and most favourable programme in terms of combined water
Cotton 40 - 60°C 7.0
and energy consumption for washing cotton laundry.
– Yes i – i i – – i i max.
- Reference programme for the Energy Label.
Lightly soiled laundry made of synthetic fibres, or synthetics mixed with cotton garments.
AquaEco cold - 40°C 2.5 Saving programme with a very low water consumption. Use liquid detergent and the lowest recommended – Yes – i i i – – – i max.
amount for 2.5kg laundry. Do not use softener.
White and pastel shaded garments made of delicate fabrics.
Colours cold - 60°C 4.0 Gentle wash programme to avoid graying or yellowing of your laundry. Use heavy duty detergent, if necessary i Yes i i i i i i i i 1000 1)
also stain removers or bleaches on oxygen basis. Do not use liquid detergent.
Normally soiled cotton jeanswear and garments made of robust jeanslike material
Jeans cold - 60°C 4.0
such as trousers and jackets
i Yes i i i i i i i i 1000 1)
Normally soiled and sweaty sportswear made of cotton jersey or microfibers.
Sport cold - 30°C 3.0
Programme includes a prewash cycle - add detergent also to the prewash chamber. Do not use softener.
i Yes i i i i i i i i max.
Shirts and blouses made of cotton, linen, synthetic fibers or their blends.
Business cold - 40°C 1.5 Gentle programme for fine garments which have been used or which are only lightly soiled. Pre-treatment of i Yes i i i i – i – i 800 1)
stains recommended.
Rinse and intensive spin programme.
Rinse & Spin - - 7.0
Same as the last rinse and the final spin in the “Cotton” programme.
– – i – i i – – i i max.

Spin - - 7.0 In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. – – – – i i – – – i max.

i: optional / Yes : dosing required


1) For improved garment care, spin speed is restricted in these programmes. Whirlpool is a registered trademark of Whirlpool USA. W10820527
- the sensor technology adapts water, energy and programme duration to your wash load. “Intensive rinse” button CHILD LOCK BUTTONS
• More water is added and rinse cycle is prolonged.
CONSUMPTION DATA Power consumption in off-mode 0.11 W / in left-on mode 0.11 W You can lock the buttons of the control panel against
• This option is particularly suitable for areas with very
improper use (e.g. by children).
Tempe- Load Water Energy Approx. Programme Duration soft water, washing baby linen and helping people with
(hrs : min) • Press both of the child lock buttons simultaneously and
Programme rature without “Rapid” allergies.
(°C) (kg) (l) (kWh) without “Rapid” with “Rapid” hold them for at least 3 seconds. The key symbol on the
“Spin speed” button display lights up.
Mixed 40 3.0 45 0.43 1:00 – • Every programme has a predefined spin speed. • To unlock the buttons again: proceed in the same way.
Cotton 95 7.0 58* 2.00 2:35 2:00 • Press the button to set another spin speed.
Cotton 60 7.0 54 1.10 2:35 1:45 FAILURE INDICATIONS
• If spin speed “0” is selected, the final spinning is
Cotton 40 7.0 64 0.90 3:00 1:30
Synthetics 60 3.0 54* 0.89 2:15 0:59
cancelled but intermediate spin peaks remain during the In case of any failures or irregularities, consult the
Synthetics 40 3.0 50 0.56 2:15 0:59 rinse. The water is drained out only. “Troubleshooting Guide” in your Instructions for Use.
Delicates 40 1.5 50 0.55 0:45 –
START DELAY “Water tap closed” -
Wool 40 1.0 40 0.55 0:35 – No or not sufficient inlet water.
Rapid 30’ 30 3.0 42 0.25 0:30 – The “Start delay” button allows the user to run the
“Service” -
Aqua Eco 40 2.5 19 0.43 1:00 – machine at his convenience. Thus, it allows you to have
Colours 40 4.0 67 0.50 1:20 1:00 Failure or malfunction of an electrical component.
your laundry ready at a particular time and to profit from
Jeans 40 4.0 41 0.58 1:30 1:10 “Clean pump” -
more favourable energy rates during the night, for example.
Sport 30 3.0 50 0.45 2:05 1:14 Waste water is not pumped out.
• Do not use liquid detergent when activating this
Business 40 1.5 50 0.55 0:45 – Spin speed on display blinks: unbalance during spinning
eCotton** 60 7.0 48 0.90 4:00 – function.
eCotton** 60 3.5 34 0.75 2:50 – • Select programme, spin speed and options. PROGRAMME END
eCotton** 40 3.5 34 0.65 2:50 – • Press the “Start delay” button several times to select a • The “Lid open” indication lights up and the display shows
Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect delay time by 1 to 24 hours. “End”. After about a quarter of an hour, the washing
to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.Water and energy consumption refer to the
default setting of the programmes; selecting special options or modifying spin speed or temperature will change the consumption data. • Start the countdown of the “Start delay” by pressing machine will switch off completely to save energy.
The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Start/Pause”. the lamp over the “Start delay” button
“Troubleshooting Guide” in your Instructions for Use). 1. Turn the programme selector to the “O” position.
* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. blinks, and it goes off when the programme starts. 2. Close the water tap.
** Standard Cotton programme and basis for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature.
• Once having pressed the “Start/Pause” button, 3. Open lid and drum and unload the machine.
PREPARATION OF THE WASH CYCLE • Recommendable for lightly soiled laundry without stains. the countdown of the time delay begins. The time 4. Leave the lid open for some time to allow the interior of
• Make sure that your detergent is suitable for cold wash delay indication on the display disappears when the the machine to dry.
1. Load the washing machine, close the drum door and
temperatures (15-20°C). programme starts and is replaced by the remaining
check that it is closed properly. DETERGENT OVERDOSAGE INDICATION
• Not selectable for Cotton 70 - 95°C. programme time.
2. Pour in the detergent and any additives, as described
“Fresh care” button • After the “Start/Pause” button has been pressed, The symbol will light up at the end of the programme if
overleaf and in the instruction manual.
• Select this option if you cannot unload the laundry the number of hours preselected can be reduced by you used too much detergent. Use less detergent next
3. Close the lid.
soon after programme end, or if you tend to forget the pressing again the “Start delay” button. time. If the symbol lights up and the display shows “Fod”,
4. Turn the programme selector to the desired
laundry in your washing machine. It will help to keep To cancel the “Start delay” too much foam interrupted the wash process; refer to the
programme. The display shows the duration of the
your laundry fresh. ..before you press the “Start/Pause” button: “Troubleshooting Guide” in your Instructions for use.
selected programme (in hours and minutes), and
• The washing machine will start to tumble the laundry • Turn the programme selector to another position or
the indicator for the “Start/Pause” button flashes. CHANGE PROGRAMME AND/OR OPTIONS
periodically after programme end. press the “Reset/Drain” button.
The temperature and spin speed can be changed by AFTER PROGRAMME START
• The light of the “Fresh care” button will blink while this ..after having pressed the “Start/Pause” button:
pressing the “Temperature” and “Spin” buttons. If
function is active, and the display will show an animation. • Press the “Reset/Drain” button for at least 3 seconds. 1. Press the “Start/Pause” button to pause the
you do not start the programme soon after having
• The periodic tumbling will last up to approximately The start delay indicator light goes off. programme. The light blinks.
made your choice, the washing machine will switch
6 hours after the end of your wash programme, and 2. Select the new programme, temperature, any options
off automatically after about a quarter of an hour. PROGRAMME START
you can stop it at any time by pressing the “Fresh care” and another spin speed if you want.
Switch on the washing machine again by turning the Open the tap and press the “Start/Pause” button. The
button. It will last a while until you can open the door. 3. Press the “Start/Pause” button again. The new
programme selector back to “O” and then to the indication lamp next to the “Start/Pause” button lights up.
• After the “Fresh care” period has run out, the display programme continues at the same position where the
desired programme. The display shows the remaining programme time. Due
indicates “End”. previous programme was interrupted. Do not add
SELECT ANY DESIRED OPTION to variations in load and temperature of inlet water, the detergent for this programme.
“Rapid” button
remaining time is newly calculated in certain programme
When the combination of programme and additional • Enables quicker washing by shortening the programme CANCEL A RUNNING PROGRAMME
phases. If this is the case, an animation appears on the
option(s) is not possible, the indication lights switch off duration. BEFORE THE END
time display.
automatically. Unsuitable combinations of options are • Recommendable for small loads or only lightly soiled
deselected automatically. laundry. “LID OPEN” INDICATION The “Reset/Drain” button cancels a programme before
“Colours 15° ” button the end.
“Prewash” button Before starting and after end of a programme, the lamp
• Saves energy used for water heating while maintaining a • Press the “Reset/Drain” button for at least 3 seconds.
• Only for heavily soiled loads (for example sand, granular lights to show the the lid can be opened. As long as a wash
good wash result. The water is drained out; it may last a while until you can
dirt). Increases the cycle time by approximately 15 min. programme is running, the lid remains locked and must not
• Supports colour maintenance when washing coloured open the lid.
• Do not use liquid detergent for the main wash when be forced open. In case you have an urgent need to open
laundry. activating the Prewash option. it during a running programme, refer to “Cancel a running
programme before the end”.

You might also like