SPC 307 Sheet-4 Solution

SPC 307 - Aerodynamics
Sheet 4 - Solution
Dynamics of an incompressible, inviscid flow field
1. The velocity in a certain flow field is given by the equation

⃗ = 𝑥 𝑖̂ + 𝑥 2 𝑗̂ + 𝑦𝑧 𝑘̂
𝑉
Determine the expressions for the three rectangular components
of acceleration.
Dr./ Ahmed Nagib Elmekawy 1 of 10 SPC 307 - Sheet 4 Solution

2. The flow in the plane two-dimensional channel shown in Fif. 1. Gas
x- and y-components of velocity given by
𝑥 𝑦 2
𝑢 = 𝑢0 (1 + ) [1 − ( ) ]
𝑙 𝑌
𝑦3 𝑥 2 𝑦
𝑣 = 𝑢0 [ 2 (1 + ) − ]
𝑙𝑌0 𝑙 𝑙
Calculate the linear acceleration, rotation, vorticity, rate of

volumetric strain, and rate of shear deformation of the flow.
Fig. 1.
Left to the student.

3. If Determine an expression for the vorticity of the flow field
described by
⃗ = −𝑥𝑦 3 𝑖̂ + 𝑦 4 𝑗̂
𝑉
Is the flow irrotational?

4. The Equation of the x-velocity in fully developed laminar flow between
parallel plates is given by
1 𝛿𝑝
𝑢= ( ) (𝑦 2 − ℎ2 )
2𝜇 𝛿𝑥
The y-velocity is v=0. Determine the volumetric strain rate, the vorticity
and the rate of angular deformation. What is the shear stress at the
plate surface?

5. The stream function for an incompressible, two-dimensional flow
field is
𝛹 = 3𝑥 2 𝑦 + 𝑦
For this flow field, plot several streamlines.

This problem could be plotted by Matlab

6. A The stream function for a given two-dimensional flow field is
𝜙 = 𝑥 3 − 3x𝑦 2
Show that the continuity equation is satisfied and determine the

corresponding stream function.

7. The stream function for a given two-dimensional flow field is
5
𝛹 = 5𝑥 2 𝑦 − ( 𝑦 3 )
3
Determine the corresponding velocity potential.

8. The velocity potential for a certain inviscid flow field is
𝜙 = −(3𝑥 2 𝑦 − 𝑦 3 )
where 𝜙 has the units of ft2/s when x and y are in feet. Determine
the pressure difference (in psi) between the points (1,2) and (4,4),
where the coordinates are in feet, if the fluid is water and elevation
changes are negligible.

9. A The velocity potential for a certain inviscid, incompressible flow
field is given by the equation
2
𝜙 = 2𝑥 2 𝑦 − ( ) 𝑦 3
3
where 𝜙 has the units of m2/s when x and y are in meters.

Determine the pressure at the point x = 2 m, y = 2 m if the pressure
at x = 1 m, y = 1 m is 200 kPa. Elevation changes can be neglected,
and the fluid is water.

10. Consider the two-dimensional flow air flow around the corner shown in
in Fig. 2. The x- and y-direction velocities are
𝑣0 𝑥 𝑦
𝑢= sin ℎ ( ) cos ℎ ( )
𝑙 𝑙 𝑙
and
𝑣0 𝑥 𝑦
𝑢=− cos ℎ ( ) sin ℎ ( )
𝑙 𝑙 𝑙
respectively. Assume constant density, steady flow, negligible gravity and
inviscid flow. Find p(x,y).
Fig. 2.

11. The velocity potential
𝜙 = −𝑘(𝑥 2 − 𝑦 2 ) (𝑘 = constant)
may be used to represent the flow against an infinite plane boundary, as
illustrated in Fig. 3. For flow in the vicinity of a stagnation point, it is
frequently assumed that the pressure gradient along the surface is of the
form
𝛿𝑝
= 𝐴𝑥
𝛿𝑥
where A is a constant. Use the given velocity potential to show that
this is true.
Fig. 3.

12. The velocity potential for a given two-dimensional flow field is
5
𝜙 = ( ) 𝑥 3 − 2𝑥𝑦 2
3
Show that the continuity equation is satisfied and determine the

corresponding stream function.

13. One end of a pond has a shoreline that resembles a half-body as shown in Fig.
2. A vertical porous pipe is located near the end of the pond so that water can
be pumped out. When water is pumped at the rate of 0.02 m2/s (flow rate per
unit length), what will be the velocity at point A in Fig. 2? Hint: Consider the
flow inside a half-body. This flow is similar to the flow shown in Fig. 4.
Fig. 4.

14. Water flows over a flat surface at 4 ft/s, as shown in Fig. 5. A pump draws
off water through a narrow slit at a volume rate of 0.1 ft3/s per foot length
of the slit. Assume that the fluid is incompressible and inviscid and can be
represented by the combination of a uniform flow and a sink. Locate the
stagnation point on the wall (point A) and determine the equation for the
stagnation streamline. How far above the surface, H, must the fluid be so
that it does not get sucked into the slit?
Fig. 5.

15. A body having the general shape of a half-body is placed in a stream of
fluid. At a great distance upstream the velocity is U as shown in Fig. 6.
Show how a measurement of the differential pressure between the
stagnation point and point A can be used to predict the free-stream
velocity, U. Express the pressure differential in terms of U and fluid
density. Neglect body forces and assume that the fluid is nonviscous and
incompressible.
Fig. 6.

16. Water flows around a 6-ft-diameter bridge pier with a velocity of 12 ft/s.
Estimate the force (per unit length) that the water exerts on the pier.
Assume that the flow can be approximated as an ideal fluid flow around
the front half of the cylinder, but due to flow separation (see Video V6.8),
the average pressure on the rear half is constant and approximately equal
to 1⁄2 the pressure at point A (see Fig. 7).
Fig. 7.

17. A long porous pipe runs parallel to a horizontal plane surface as shown
in Fig. 8. The longitudinal axis of the pipe is perpendicular to the plane of
the paper. Water flows radially from the pipe at a rate of 0.5 p ft3/s per
foot of pipe. Determine the difference in pressure (in lb/ft2) between point
B and point A. The flow from the pipe may be approximated by a two-
dimensional source. Hint: To develop the stream function or velocity
potential for this type of flow, place (symmetrically) another equal source
on the other side of the wall. With this combination there is no flow across
the x axis, and this axis can be replaced with a solid boundary. This
technique is called the method of images.
Fig. 8.

18. Two sources, one of strength m and the other with strength 3m, are
located on the x axis as shown in Fig. P6.57. Determine the location of the
stagnation point in the flow produced by these sources.


SPC 307 Sheet-4 Solution

Uploaded by

Copyright:

Available Formats

SPC 307 Sheet-4 Solution

Uploaded by

Document Information

Original Description:

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

SPC 307 Sheet-4 Solution

Uploaded by

Copyright:

Available Formats

SPC 307 - Aerodynamics

1. The velocity in a certain flow field is given by the equation

Dr./ Ahmed Nagib Elmekawy 1 of 10 SPC 307 - Sheet 4 Solution

Calculate the linear acceleration, rotation, vorticity, rate of

Left to the student.

Dr./ Ahmed Nagib Elmekawy 2 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 3 of 10 SPC 307 - Sheet 4 Solution

Left to the student.

Dr./ Ahmed Nagib Elmekawy 4 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 5 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 6 of 10 SPC 307 - Sheet 4 Solution

Show that the continuity equation is satisfied and determine the

Dr./ Ahmed Nagib Elmekawy 7 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 8 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 9 of 10 SPC 307 - Sheet 4 Solution

where 𝜙 has the units of m2/s when x and y are in meters.

Dr./ Ahmed Nagib Elmekawy 10 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 11 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 12 of 10 SPC 307 - Sheet 4 Solution

Show that the continuity equation is satisfied and determine the

Dr./ Ahmed Nagib Elmekawy 13 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 14 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 15 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 18 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 19 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 21 of 10 SPC 307 - Sheet 4 Solution

Dr./ Ahmed Nagib Elmekawy 23 of 10 SPC 307 - Sheet 4 Solution

You might also like