Exp.1 Lab Manual (Peer To Peer Network)

Experiment 1
BUILDING A SIMPLE NETWORK: Peer to Peer
Name: ____________________________________ Section: _____________
Professor: ________________________________ Date: ________________
DURATION: 3 Hours
OBJECTIVES:
To determine the MAC and IP address of computer.

To design and built a simple peer to peer network.
To verify the connectivity using the ping command.
BACKGROUND:
The Media Access Control (MAC) address is unique identifier assigned to every
host and it is use for network interfaces for communications on the physical network
segment. MAC address is 48 bits wide or 6 bytes burned by manufacturer onto the
Network Interface Card (NIC). It is also known as Burned-In-Address (BIA), Ethernet
Hardware Address (EHA), hardware of physical address.
The IP address is similar to the address of a person. It is known as a logical

address because it is assigned logically based on where the host is located.
The IP address contains two parts; identifies the local network and individual
host. Both the physical MAC and logical IP addresses are required for a computer to
communicate on a hierarchical network.
For this experiment, two computers will be connected using cross-over cable.
Each host IP addresses and subnet mask will be configured to base on created simple
plan. Moreover, connections will be tested using ping command.
MATERIALS/EQUIPMENT:
Computer or Laptop with Internet Access

Ethernet Crossover Cable
Ethernet Straight-Through Cable
Prepared by: Engr. Emmanuel T. Longares, PECE 1ST SEM., SY 2015-2016 8

PROCEDURE:
Part 1: Determining the MAC Address of a Computer
Note: Make sure that your computer is connected to a network or internet.
a. Open the windows command prompt (CMD). This can be done by clicking the
Start button and at the search box, type cmd and click Enter. A window
command prompt shall appear as shown in Figure 2.1.
b. In the command prompt type ipconfig /all command.
Figure 2.1: Command Prompt
c. What are the MAC addresses of your computers?
Host1:
Wireless LAN adapter:_____________________
Ethernet adapter:_________________________
Bluetooth adapter:________________________
Host2:
Wireless LAN adapter:_____________________
Ethernet adapter:_________________________
Bluetooth adapter:________________________
d. What is the other name for the MAC address?

________________________________________________________________

e. Why a computer might have more than one MAC addresses?
________________________________________________________________
________________________________________________________________
________________________________________________________________
Part 2: Determining the IP Address of a Computer
a. In the command prompt, type ipconfig/all to know the IP address of your

computer.
IP address: _______________________________
b. What is the purpose of IP address of computer in the network?

________________________________________________________________
________________________________________________________________
________________________________________________________________
c. List down the other IP addresses appear in CMD window.

________________________________________________________________
________________________________________________________________
________________________________________________________________
Part 3: Building a Peer to Peer Network
a. Create a simple plan of your peer-to-peer network. Place your drawing in the box
provided below. Label PC1 with IP address of 192.168.2.1 and PC2 with IP
address of 192.168.2.2. Specify the type of cable youre going to use.

b. Click the Start > Control Panel > System and Security> System in each
computer. Identify their computer name and MAC addresses.
PC1:
Computer Name:________________________________________
Ethernet MAC Address : _______________________________
PC2:
Computer Name:________________________________________
Ethernet MAC Address : _______________________________
c. Click Ok to close the System Properties window.
d. Using a crossover Ethernet cable, connect the two laptops. As you insert the
cable, you should hear a click sound which indicates that the cable is properly
inserted into the port.
e. Check the connections in both computers. A light usually green or amber

indicates that physical connectivity has been established between the two NICs.
f. Check the computer names of each PCs. Note, each computer should have
unique name. Make adjustments as necessary.
g. Go to the Control Panel, double click the Network and Sharing Center icon.
Check in the Manage Network Connections if the LAN connection is
established.
h. Configure the logical addresses of two PCs so that they are able to communicate
using TCP/IP protocol. Kindly follow the instructions given in i to k.
i. In PC1, go to the Control Panel> Network and Internet> Network and Sharing
Center> Change adapter settings> and right click the Local Area
Connection. Click the properties and click continue.
j. Click the Internet Protocol Version 4 and click the Properties button. Click the
radio button of Use the following IP address and type the IP address of PC1
and click Ok.
k. Disable the firewall setting.
l. Do the same procedure i to k to the PC2 using the assigned IP address for PC2.
m. In the command prompt of PC1. Type ping 192.168.2.2 and click enter.
n. In the command prompt of PC2. Type ping 192.168.2.1 and click enter.
o. Does ping command successful in both PCs. Write your observation below.
________________________________________________________________
________________________________________________________________
________________________________________________________________
p. In the command prompt of PC2. Type ping 192.168.2.1 and click enter.
q. Write your observations below.
________________________________________________________________
________________________________________________________________
________________________________________________________________
r. Check your connectivity using Network and Sharing Center. Click View
computers and devices.
s. Do you see an icon of the other PC in your peer-to-peer network? What is the
computer name of other computer?
________________________________________________________________
________________________________________________________________
t. Try to access the shared files from other PC. Have you successfully download a
shared file from other PC? If not, enable your file sharing and disable your
password protect in
________________________________________________________________
________________________________________________________________
u. Replace the cable of peer-to-peer network using straight through cable.
v. Perform ping command in both PCs. Repeat the ping commands five times.
w. Does the connection successful in all trials? Explain briefly.
________________________________________________________________
________________________________________________________________
________________________________________________________________
________________________________________________________________

Exp.1 Lab Manual (Peer To Peer Network)

Uploaded by

Copyright:

Available Formats

Exp.1 Lab Manual (Peer To Peer Network)

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Exp.1 Lab Manual (Peer To Peer Network)

Uploaded by

Copyright:

Available Formats

Experiment 1

BUILDING A SIMPLE NETWORK: Peer to Peer

Name: ____________________________________ Section: _____________

Professor: ________________________________ Date: ________________

To determine the MAC and IP address of computer.

The IP address is similar to the address of a person. It is known as a logical

Computer or Laptop with Internet Access

Prepared by: Engr. Emmanuel T. Longares, PECE 1ST SEM., SY 2015-2016 8

Part 1: Determining the MAC Address of a Computer

Note: Make sure that your computer is connected to a network or internet.

b. In the command prompt type ipconfig /all command.

Figure 2.1: Command Prompt

c. What are the MAC addresses of your computers?

d. What is the other name for the MAC address?

Prepared by: Engr. Emmanuel T. Longares, PECE 1ST SEM., SY 2015-2016 9

Part 2: Determining the IP Address of a Computer

a. In the command prompt, type ipconfig/all to know the IP address of your

b. What is the purpose of IP address of computer in the network?

c. List down the other IP addresses appear in CMD window.

Part 3: Building a Peer to Peer Network

Prepared by: Engr. Emmanuel T. Longares, PECE 1ST SEM., SY 2015-2016 10

c. Click Ok to close the System Properties window.

e. Check the connections in both computers. A light usually green or amber

k. Disable the firewall setting.

u. Replace the cable of peer-to-peer network using straight through cable.

w. Does the connection successful in all trials? Explain briefly.

Prepared by: Engr. Emmanuel T. Longares, PECE 1ST SEM., SY 2015-2016 12

You might also like

Name: ________________________ Section: _

Professor: ________________ Date: