Code No: R21042 R10 SET - 1

II B. Tech I Semester, Supplementary Examinations, May 2013

NETWORK ANALYSIS
(Com. to ECE, EIE, ECC)
Time: 3 hours Max. Marks: 75
Answer any FIVE Questions
All Questions carry Equal Marks

om
~~~~~~~~~~~~~~~~~~~~~~~~~

.c
1. a) Write the classification of network elements?
b) Derive the expression for energy stored in an element of inductance L Henry carrying a

es
current i Amperes over a period of t second.

2. a) Define the terms Frequency, RMS value, and average value.

at
b) Two alternating currents represented by the equations i1=7 sin t and i2=10 sin ( t+ /3)
are fed into common conductor. Find the equation for resultant current and its RMS value.

3.
iv) Equivalent input impedance. pd
a) For the network shown in Figure 1, determine i) current I1, ii) current I2, iii) current I,
tu
as
kf
tu
.jn

b) For the AC network shown in Figure 2, using mesh-current analysis, find: i) the mesh
currents I1 and I2. ii) the current flowing in the capacitor
w

4. a) Derive the expression for coefficient of coupling K for two magnetically couple coils of
w

inductance L1 and L2 Henrys.

b) The current at resonance in a series LCR circuit is 100 A. If the applied voltage is 2 mV
w

at a frequency of 200 kHz, and the circuit inductance is 50 H, find: i) the circuit resistance,
and ii) the circuit capacitance.

1 of 2

|''|'||'|''|''|''''|
Code No: R21042 R10 SET - 1

5. a) Use Thevenins theorem to determine the current I flowing in the 4 resistor shown in
Figure.3. Find also the power dissipated in the 4 resistor.

om
.c
es
at
b) Find the value of the load resistor RL shown in Figure 4 that gives maximum power

pd
dissipation and determine the value of this power.
tu
6. Develop the z-parameter, and h-parameter equivalent circuits. Also express the z-parameters in
terms of y-parameters.
as

7. a) A 20 F capacitor is connected in series with a 50 k resistor and the circuit is connected to

a 20 V, dc supply. Determine
i) The initial value of the current flowing,
kf

ii) The time constant of the circuit,

iii) The value of the current one second after connection,
iv) The value of the capacitor voltage two seconds after connection
tu

b) In the series-parallel network shown in Figure 5. A 5 V step voltage is applied at the input
terminals. Determine an expression to show how current i varies with time.
.jn
w
w
w

8. a) Explain the design of low pass filter.

b) A filter section is to have characteristic impedance at zero frequency of 600 and a cutoff
frequency at 5 MHz. Design i) a low-pass T section filter, and ii) a low-pass section
filter to meet these requirements.

2 of 2

|''|'||'|''|''|''''|
Code No: R21042 R10 SET - 2

II B. Tech I Semester, Supplementary Examinations, May 2013

NETWORK ANALYSIS
(Com. to ECE, EIE, ECC)
Time: 3 hours Max. Marks: 75
Answer any FIVE Questions
All Questions carry Equal Marks

om
~~~~~~~~~~~~~~~~~~~~~~~~~

1. a) Define Electric Charge, Current, Potential difference, Power and Energy.

.c
b) Derive the expression for energy stored in an element of capacitance C Farads with a V
volts potential across the terminals over a period oft second.

es
2. a) An alternating current varying sinusoidally with a frequency of 50Hz has an RMS

at
value of 20A. Write down the equation of instantaneous value of current and find this value
at i) 0.0025 second ii) 0.0125 second after passing through a positive maximum value.
b) Explain principle of Duality. Prove that Series RLC circuit driven by a Voltage source is

3.
pd
Dual of Parallel RLC Circuits driven by current source.

a) Determine, for the network shown in Figure 1, i) total network admittance, ii) total
tu
network impedance, iii) the supply current I, iv) the network phase angle, and v)
currents I1, I2, I3and I4.
as
kf
tu
.jn

b) Determine the value of voltage VXY shown in the circuit of Figure 2

w
w
w

1of 2

|''|'||'|''|''|''''|
Code No: R21042 R10 SET - 2

4. a) Two magnetically coupled coils are having self inductances L1 and L2, Mutual
inductance M. Determine the equivalent inductance if they are connected in series aiding
condition
b) A coil of negligible resistance and inductance 100 mH is connected in series with a
capacitance of 2 F and a resistance of 10 across a 50 V, variable frequency supply.

om
Determine i) resonant frequency, ii) current at resonance, iii) voltages across coil
and capacitor at resonance, and iv) Q-factor of the circuit.

.c
5. a) Use Thevenins theorem to determine the current flowing in the 3 resistance of the
network shown in Figure 3.

es
b) Use superposition theorem to find currents in 10 ohms and 20 ohms resistances of Figure 4.

at
pd
tu
as

6. Develop the y-parameter, and Transmission-parameter equivalent circuits. Also express the y-
parameters in terms of transmission-parameters.
kf

7. a) A circuit consists of a resistor connected in series with a 0.5 F capacitor and has a time
constant of 12 ms. Determine i) value of the resistor, and ii) the capacitor voltage 7 ms
after connecting the circuit to a 10 V supply.
tu

b) For the circuit shown in Figure 5. Use Laplace Transform to derive expression for current.
Assume zero initial conditions when the switch is closed.
.jn
w
w
w

8. a) Explain the design of high pass filter.

b) A filter is required to pass all frequencies above 25 kHz and to have a nominal impedance of
600 . Design i) a high-pass T section filter and ii) a high-pass section filter to meet
these requirements.

2 of 2

|''|'||'|''|''|''''|
Code No: R21042 R10 SET - 3

II B. Tech I Semester, Supplementary Examinations, May 2013

NETWORK ANALYSIS
(Com. to ECE, EIE, ECC)
Time: 3 hours Max. Marks: 75
Answer any FIVE Questions
All Questions carry Equal Marks

om
~~~~~~~~~~~~~~~~~~~~~~~~

.c
1. a) Write the classification of energy sources.
b) Explain current division in a string of resistances connected in parallel.

es
2. a) An alternating voltage is given by v(t)=141.4 sin (314t). Find: i) Frequency ii) RMS value

at
iii) Average Value iv) The Instantaneous value of voltage when t is 3 msec.
b) Three alternating currents expressed by iA = 7.07 sin(314t ), i B = 1.2 sin (314 t / 4) and

pd
i C = 7.07 sin(314 t + / 3) are flowing in three branches of parallel circuit fed from single
phase ac supply. Find the expression for resultant current drawn by the circuit.
tu
3. a) In the network shown in Figure 1, the voltmeter across 4 ohms resistor indicates 24 V.
Determine the reading of the ammeter.
as
kf
tu
.jn

b) In the network of Figure 2, use nodal analysis to determine i) the voltage at nodes 1 and 2,
w

ii) The current in the j4 inductance, iii) the current in the 5 resistance, and iv) the
magnitude of the active power dissipated in the 2.5 resistance.
w

4. a) Two magnetically coupled coils are having self inductances L1 and L2, Mutual
w

inductance M. Determine the equivalent inductance if they are connected in Parallel aiding
condition.
b) A coil of resistance 25 and inductance 100 mH is connected in series with a capacitance
of 0.12 F across a 200 V, variable frequency supply. Calculate: i) resonant frequency, ii)
current at resonance and iii) factor by which voltage across the reactance is greater than the
supply voltage.

1 of 2

|''|'||'|''|''|''''|
Code No: R21042 R10 SET - 3

5. a) Use Nortons theorem to determine the current flowing in the 10 resistance for the circuit
shown in Figure 3.

om
.c
es
at
6.
pd
b) Use the superposition theorem to find the current in the 8 resistor of Figure 4.

Develop the h-parameter, and Transmission-parameter equivalent circuits. Also express the
tu
h-parameters in terms of Transmission -parameters.

7. a) The winding of an electromagnet has an inductance of 3 H and a resistance of 15 . When it

as

is connected to a 120 V, dc supply, calculate:

i) the steady state value of current flowing in the winding,
kf

ii) the time constant of the circuit,

iii) the value of the induced e.m.f. after 0.1 s,
iv) the time for the current to rise to 85% of its final value
tu

b) An LRC series circuit contains a coil of inductance 1 H and resistance 8 and a capacitor
of capacitance 50F. Assuming current i=0 at time t=0, determine i) the state of damping
.jn

in the circuit, and ii) an expression for the current when a step voltage of 10 V is applied to
the circuit.

8. a) A filter network consists of 8 sections in cascade having a nominal impedance of 1 k . If

w

the total delay time is 4s, determine the component values for each section if the filter is
i) a low-pass T network, and ii) a high-pass network.
w

b) Explain the design of Low pass m-derive section.

w

2 of 2

|''|'||'|''|''|''''|
Code No: R21042 R10 SET - 4

II B. Tech I Semester, Supplementary Examinations, May -2013

NETWORK ANALYSIS
(Com. to ECE, EIE, ECC)
Time: 3 hours Max. Marks: 75
Answer any FIVE Questions
All Questions carry Equal Marks

om
~~~~~~~~~~~~~~~~~~~~~~~~

1. a) Explain Kirchhoffs Laws?

.c
b) Explain voltage division across a string of Resistors connected in series.
c) Derive the expression for power dissipated in an element of R- , carrying a current I

es
Amps.

at
2. a) Define Average value, Form factor, Peak factor of an alternating quantity.
b) Define the terms branch, node, tree, planar, non-planar graph.
c) The instantaneous values of two alternating voltages are represented by 1030 0 V and

pd
16 30 0 V . Derive the expression for the instantaneous values of (i) the sum and (ii) the
difference of these voltages.
tu
3. a) For the parallel network shown in Figure 1, determine i) the equivalent circuit impedance,

ii) the supply current I, iii) the circuit phase angle, and iv) currents I1 and I2
as
kf
tu
.jn
w

b) For the network shown in Figure 2, use mesh-current analysis to determine the value of
current I and the active power output of the voltage source.
w

4. a) Two magnetically coupled coils are having self inductances L1 and L2, Mutual
w

inductance M. Determine the equivalent inductance if they are connected in series

opposition condition.
b) The current at resonance in a series LCR circuit is 0.2 mA. If the applied voltage is 250
mV at a frequency of 100 kHz and the circuit capacitance is 0.04 F, find the circuit
resistance and inductance.

1 of 2

|''|'||'|''|''|''''|
Code No: R21042 R10 SET - 4

5. a) Convert the circuit to the left of terminals AB in Figure 3, to an equivalent Thevenin circuit
by initially converting to a Norton equivalent circuit. Determine the current flowing in the
1.8 resistor.

om
.c
es
b) Determine the value of the load resistance RL shown in Figure 4, that gives maximum power

at
dissipation and find the value of the power consumed by load resistance.

6. Develop the z-parameter, and h-parameter equivalent circuits. Also express the z-parameters in

7.
terms of h-parameters.
pd
a) An inductor has a negligible resistance and an inductance of 200 mH and is connected in
tu
series with a 1 k resistor to a 24 V, dc supply. Determine the time constant of the circuit
and the steady-state value of the current flowing in the circuit.
Also find: i) the current flowing in the circuit at a time equal to one time constant,
as

ii) the voltage drop across the inductor at a time equal to two time constants and
iii) the voltage drop across the resistor after a time equal to three time constants.
b) Derive an equation for current i flowing through the 1 k resistor in Figure 5 using
kf

Laplace Transforms, when the switch is moved from x to y. Assume that the switch has
been in position x for some time.
tu
.jn
w
w

8. a) A filter section is to have a characteristic impedance at zero frequency of 500 and a cut-
off frequency of 1 kHz. Design i) a low-pass T section filter, and ii) a low-pass section
w

filter to meet these requirements.

b) Explain the design of high pass m-driven section.

2 of 2

|''|'||'|''|''|''''|