Fire-Fighting Systems For On-Deck Cargo Areas of Container Carriers
Fire-Fighting Systems For On-Deck Cargo Areas of Container Carriers
Fire-Fighting Systems For On-Deck Cargo Areas of Container Carriers
AUGUST 2016
Foreword
ii
ABS GUIDE FOR THE CLASS NOTATION FOR FIRE-FIGHTING SYSTEMS FOR ON-DECK CARGO AREAS OF CONTAINER CARRIERS . 2016
Table of Contents
SECTION 2
Introduction ............................................................................................ 1
1
Scope .................................................................................................. 1
3
Application .......................................................................................... 1
5
Definitions ........................................................................................... 1
5.1
Bay .................................................................................................. 1
5.3
5.5
5.7
5.9
5.11
Stack ............................................................................................... 1
5.13
Tier .................................................................................................. 1
5.15
7.1
7.3
3.1
General............................................................................................ 3
3.3
Capacity .......................................................................................... 3
3.5
Pressure .......................................................................................... 3
3.7
3.9
3.11
3.13
5.3
11
ABS GUIDE FOR THE CLASS NOTATION FOR FIRE-FIGHTING SYSTEMS FOR ON-DECK CARGO AREAS OF CONTAINER CARRIERS . 2016
iii
SECTION 3
3.3
iv
1.1
1.3
ABS GUIDE FOR THE CLASS NOTATION FOR FIRE-FIGHTING SYSTEMS FOR ON-DECK CARGO AREAS OF CONTAINER CARRIERS . 2016
Section 1: Introduction
SECTION
Introduction
Application
Container Carriers provided with an arrangement of a fire-fighting piping system and additional fire-fighting
equipment in compliance with Section 2 of this Guide will be eligible for the notation FOC. A vessel also in
compliance with the enhanced requirements of Section 3 of this Guide will be eligible for the notation FOC+.
Definitions
5.1
Bay
A Bay is an athwartship block of containers associated with a hatch or hatch cover containing multiple
stacks extending longitudinally between two adjacent lashing bridges or lashing stations.
5.3
Container Carrier
A Container Carrier is a seagoing vessel specifically designed, constructed, and equipped with the appropriate
facilities to carry cargo containers. These containers are stowed in cargo spaces (i.e., in cargo holds below
deck) and on hatches and cargo areas located on the weather deck. A fully cellular type carries only containers
with cell-guides under deck and the necessary fittings and equipment on deck.
5.5
Dangerous Goods
Dangerous Goods are the substances, materials, and articles covered by the International Maritime Dangerous
Goods Code (IMDG Code).
5.7
5.9
5.11
Stack
Stack is a single vertical row of containers containing one or more tiers. Also referred to as a row.
5.13
Tier
Tier is an indication of the vertical position of a container in a stack. The first tier is the lowest or bottommost position in the stack.
5.15
ABS GUIDE FOR THE CLASS NOTATION FOR FIRE-FIGHTING SYSTEMS FOR ON-DECK CARGO AREAS OF CONTAINER CARRIERS . 2016
Section
Introduction
7.1
7.3
Type, size, pressure rating, material and standards of any fittings, valves, and fire hydrants
ii)
Detailed specifications including operating flow rates, pressures, spray patterns and throw distance
of all types of mobile water monitors (see 2/5.3) and water mist lances
iii)
Detailed specifications including operating flow rates and pressure rating of the water mist lances
and analysis/testing results or other information validating that the water mist lance is of a type
capable of penetrating a standard container (see Subsection 2/9)
iv)
Flow rate and pressure analysis of the fire protection piping system during operations at the most
hydraulically remote location
v)
Operating procedures for the fire protection system of the on-deck cargo area. As a minimum,
these procedures are to include:
The storage location, handling and operation instructions of the mobile water monitors, hoses,
fittings, and fixing hardware.
Arrangements showing the locations and attachment methods of the mobile water monitors
for each bay
Storage location, handling and operation instructions of the water mist lance
Manufacturers operating manual for the mobile water monitors which includes information
on the safe operations of the monitors
ii)
Diagrammatic plans of the piping system for the water-spray system of 3/3.1. These plans are to
be accompanied by lists of material giving:
Size, wall thickness, maximum working pressure, material and standards of all pipes
Type, size, pressure rating, material and standards of any fittings, valves, and spray nozzles
Flow rate and pressure analysis of the piping system for hatch cover.
ABS GUIDE FOR THE CLASS NOTATION FOR FIRE-FIGHTING SYSTEMS FOR ON-DECK CARGO AREAS OF CONTAINER CARRIERS . 2016
SECTION
FOC Notation
3.1
General
Every vessel is to be provided with pumps, water service pipes, and hydrants complying with the provisions
of this Subsection, as applicable.
3.3
Fire main system required by 4-7-3/1 of the Steel Vessel Rules, supplying four (4) hoses on the
weather deck at the pressure identified in 2/3.5 below, equally divided between both sides,
ii)
A flow rate of water through the required number of monitors equivalent to 2.0 l/min/m2 times the
maximum projected area of the combined faces of the largest bay (forward and aft) that could be
engaged in a fire,
iii)
iv)
Any additional water arrangements required by 4-7-2/7.3 of the Steel Vessel Rules for dry cargo
spaces intended to carry dangerous goods,
v)
Any other fixed fire-fighting systems served by the fire pumps that could be expected to operate at
the same time, and
vi)
If applicable, the fixed water-spray system for hatch covers, see 3/3.1.
The bilging of the cargo holds is to be independent of the cargo area fire main system. Dewatering of the
cargo holds by eductors supplied from the fire pumps may be used provided the available capacity is
adequate to simultaneously supply all required firefighting services as well as the eductors of any two
adjacent holds.
3.5
ii)
During all possible operating scenarios, the maximum pressure at any hydrant is not to exceed that at which
the effective control of a fire hose can be demonstrated.
ABS GUIDE FOR THE CLASS NOTATION FOR FIRE-FIGHTING SYSTEMS FOR ON-DECK CARGO AREAS OF CONTAINER CARRIERS . 2016
Section
3.7
FOC Notation
3.9
The number and position of hydrants in the cargo area are to comply with the following:
i)
ii)
There are to be a sufficient number of hydrants immediately forward and aft of each container
bay to supply the total required number of monitors; each from a separate hydrant and at
least half the required number through a single 15 m (50 ft) length of fire hose.
iii)
The locations of the hydrants are to allow the monitors to be evenly distributed along the
width of the spaces between the container bays, to the extent practicable;
iv)
At least one hydrant is to be located immediately outboard on each side of the space between
the container bays. Where a lashing bridge is fitted, these hydrants are to be located on the
top of the lashing bridge. The jet of water from a mobile water monitor connected to these
hydrants is to be capable of reaching inboard at least the thirds the breadth of the vessel.
3.9.2
Arrangements are to be provided to cool the hoses and hydrants that will be located between the
container bays from the effects of the heat of the fire, unless otherwise determined to be suitable
for prolonged exposure under such conditions.
3.11
Application of Water on Container Bays Forward and Aft of Bay Engaged in a Fire
(1 August 2016)
The system is to provide for the simultaneous operation of all required monitors evenly distributed
between the forward and aft of any bay that could be engaged in a fire at the required capacity and pressure
in addition to any other system identified in 2/3.3.
3.13
ABS GUIDE FOR THE CLASS NOTATION FOR FIRE-FIGHTING SYSTEMS FOR ON-DECK CARGO AREAS OF CONTAINER CARRIERS . 2016
Section
FOC Notation
5.1
5.3
ii)
Vessels with a breadth between 30 m (98 ft) and up to 45 m (147.6 ft) carrying containers on the
weather deck are to be provided with at least six (6) mobile water monitors.
iii)
Vessels with a breadth between 45 m (147.5 ft) and up to 60 m (197 ft) carrying containers on the
weather deck are to be provided with at least eight (8) mobile water monitors.
iv)
Vessels with a breadth more than 60 m (197 ft) carrying containers on the weather deck are to be
provided with at least ten (10) mobile water monitors.
ii)
Equipped with a coupling allowing connection to the vessels fire hydrants via a fire hose. The
coupling and hose are to be sized for the proper flow and pressure performance of the monitor.
iii)
The minimum capacity is to be 60 m3/hr (1,000 liters/min, 265 gpm) at the pressure necessary to
reach the top tier of the containers on deck (see 2/5.3v below).
iv)
Capable of a minimum horizontal throw of 40 m (131 ft) at an inlet pressure of 0.4 N/mm2
(4.1 kgf/cm2, 58 psi), when discharging at a horizontal elevation of 30-35.
v)
Capable of a minimum vertical throw sufficient to reach the top of the highest tier of containers
when discharging at an elevation of not more than 75.
vi)
Allows swiveling of the discharge nozzle for adjusting the throw direction of the water in both the
horizontal and vertical planes, while in continuous operation. The vertical swivel range is to be 0
to 90. If lubrication is required, external lubrication fittings are to be provided for the swivel joints.
vii)
The discharge nozzle is to be of a dual-purpose spray/jet type incorporating a shutoff and capable
of discharging an effective water spray between container bays in the event of a container fire in
the on-deck cargo area.
viii)
The design configuration is to minimize nozzle thrust reaction, and is to permit unattended operation
once the monitor is placed in position.
ix)
Provide means to ensure a secure/safe fixing to the vessels weather deck, lashing bridge, or other
applicable structure.
x)
Provide a carrying handle or other means for ease of transport. Monitors weighing more than
23 kg (50 lbs) are to be fitted with wheels.
xi)
Where monitors are to be used on a lashing bridge, arrangements such as davits or hoists are to be
provided on the port and starboard sides of each lashing bridge to raise and lower the monitors.
The mobile water monitors, all necessary hoses, fittings, and required fixing hardware are to be kept ready
for use in a location outside the cargo space area and accessible in the event of a fire in the cargo spaces.
Efficient drainage of water from deck surfaces is to be provided when the mobile water monitors are in
operation.
ABS GUIDE FOR THE CLASS NOTATION FOR FIRE-FIGHTING SYSTEMS FOR ON-DECK CARGO AREAS OF CONTAINER CARRIERS . 2016
Section
FOC Notation
11
ABS GUIDE FOR THE CLASS NOTATION FOR FIRE-FIGHTING SYSTEMS FOR ON-DECK CARGO AREAS OF CONTAINER CARRIERS . 2016
SECTION
General
Vessels are to comply with the requirements of Section 2 and Subsections 3/3 and 3/5.
3.1
All hatch cover areas are protected by spray nozzles incorporated into the hatch covers.
ii)
The spray nozzles are to be appropriately distributed in the hatch cover area and arranged so as to
uniformly discharge water onto the top of the hatch cover area.
iii)
Nozzles are to be grouped into separate sections, and each section is to contain the nozzles necessary
to cover the hatch cover area for a cargo bay. Each section of nozzles is to be capable of being
isolated by one stop valve only. The stop valve in each section is to be readily accessible.
iv)
The nozzles and supply piping are to be suitably protected from mechanical damage that could
occur due to the handling or operation of the hatch covers or containers.
v)
Where the nozzles and supply piping are fixed on the hatch cover, quick connect arrangements are
to be provided to connect the supply piping on the hatch covers to the fixed supply piping on deck.
vi)
The total pumping capacity is to be provided by at least two independently driven pumps. The
pumps and the piping system are to be capable of maintaining the necessary pressure to provide a
continuous output of water sufficient for the coverage of the hatch cover area for the largest cargo
bay at the application rate specified in 3/3.1vii).
With any one pump inoperable, the availability of water is at least 50 percent of the total capacity
with adequate spray patterns on a hatch cover area.
If pumps for other fire protection systems are used, they are provided with sufficient capacity to
provide pressure and volume for adequate operation of the other fire protection systems and the
water-spray system, simultaneously. See 2/3.3.
3.3
vii)
Nozzles are placed and spaced in a suitable pattern to maintain an average application rate of not
less than 5 liters/min/m2 (0.12 gpm/ft2) over the hatch cover area.
viii)
All piping, valves, and nozzles are suitably protected from damage and corrosion.
ix)
x)
Efficient drainage of water from deck surfaces is provided when the water-spray system is in operation.
Novel Concepts
In lieu of 3/3.1, special consideration will be given to novel concepts such as mechanical or structural means
to direct the flow of water from monitors onto the hatch cover area. Any novel concept is to comply with
the application rate of 3/3.1vi) and the drainage of 3/3.1ix).
ABS GUIDE FOR THE CLASS NOTATION FOR FIRE-FIGHTING SYSTEMS FOR ON-DECK CARGO AREAS OF CONTAINER CARRIERS . 2016
SECTION
FOC Notation
1.1
ii)
iii)
iv)
It is to be demonstrated to the satisfaction of the attending Surveyor that the total capacity of the on deck
fire protection system is sufficient to provide the required pressure and volume for the simultaneous operation
of:
1.3
i)
The fire main system supplying four (4) hoses for the on-deck cargo area equally divided between
both sides,
ii)
For a bay determined by the Surveyor, all required water monitors and that each monitors water jet
reaches the vertical distance equivalent to the top tier of containers
iii)
iv)
Any other fixed fire-fighting system served by the fire pumps, and
v)
vi)
Verify that sufficient spare charges are available for each breathing apparatus to comply with
Subsection 2/11, in addition to those required by 4-7-3/15.5.1(b) of the Steel Vessel Rules.
Annual Surveys
At each Annual Survey, in addition to surveys of hull, machinery, and equipment otherwise required by the
Rules, the fire-fighting equipment to be verified in operating condition is to include the following:
i)
ii)
iii)
If applicable, the fixed water-spray system for the protection of the hatch cover area.
iv)
Verify that sufficient spare charges are available for each breathing apparatus to comply with
Subsection 2/11, in addition to those required by 4-7-3/15.5.1(b) of the Steel Vessel Rules.
ABS GUIDE FOR THE CLASS NOTATION FOR FIRE-FIGHTING SYSTEMS FOR ON-DECK CARGO AREAS OF CONTAINER CARRIERS . 2016