RF Basics: Radio Propagatio: Wireless
RF Basics: Radio Propagatio: Wireless
RF Basics: Radio Propagatio: Wireless
It is fitting in a book about wireless communication to look at the phenomena that lets us transfer information from one point to another without any
physical mediumthe propagation of radio waves. If you want to design an efficient radio communication system, even for operation over relatively
short distances, you should understand the behavior of the wireless channel in the various surroundings where this communication is to take place.
While the use of "brute force" increasing transmission powercould overcome inordinate path losses, limitations imposed on design by required
battery life, or by regulatory authorities, make it imperative to develop and deploy short-range radio systems using solutions that a knowledge of radio
propagation can give.
The overall behavior of radio waves is described by Maxwell's equations. In 1873, the British physicist James Clerk Maxwell published his Treatise on
Electricity and Magnetism in which he presented a set of equations that describe the nature of electromagnetic fields in terms of space and time.
Heinrich Rudolph Hertz performed experiments to confirm Maxwell's theory, which led to the development of wireless telegraph and radio. Maxwell's
equations form the basis for describing the propagation of radio waves in space, as well as the nature of varying electric and magnetic fields in
conducting and insulating materials, and the flow of waves in waveguides.
From them, you can derive the skin effect equation and the electric and magnetic field relationships very close to antennas of all kinds. A number of
computer programs on the market, based on the solution of Maxwell's equations, help in the design of antennas, anticipate electromagnetic radiation
problems from circuit board layouts, calculate the effectiveness of shielding, and perform accurate simulation of ultra-high-frequency and microwave
circuits. While you don't have to be an expert in Maxwell's equations to use these programs (you do in order to write them!), having some familiarity
with the equations may take the mystery out of the operation of the software and give an appreciation for its range of application and limitations.
Mechanisms of Radio Wave Propagation
Radio waves can propagate from transmitter to receiver in four ways: through ground waves, sky waves, free space waves, and open field waves.
Ground waves exist only for vertical polarization, produced by vertical antennas, when the transmitting and receiving antennas are close to the surface
of the earth. The transmitted radiation induces currents in the earth, and the waves travel over the earth's surface, being attenuated according to the
energy absorbed by the conducting earth. The reason that horizontal antennas are not effective for ground wave propagation is that the horizontal
electric field that they create is short circuited by the earth.
Ground wave propagation is dominant only at relatively low frequencies, up to a few MHz, so it needn't concern us here. Sky wave propagation is
dependent on reflection from the ionosphere, a region of rarified air high above the earth's surface that is ionized by sunlight (primarily ultraviolet
radiation).
The ionosphere is responsible for long-distance communication in the high-frequency bands between 3 and 30 MHz. It is very dependent on time of
day, season, longitude on the earth, and the multiyear cyclic production of sunspots on the sun. It makes possible long-range communication using
very low power transmitters. Most short-range communication applications that we deal with in this chapter use VHF, UHF, and microwave bands,
generally above 40 MHz. There are times when ionospheric reflection occurs at the low end of this range, and then sky wave propagation can be
responsible for interference from signals originating hundreds of kilometers away. However, in general, sky wave propagation does not affect the shortrange radio applications that we are interested in.
The most important propagation mechanism for short-range communication on the VHF and UHF bands is that which occurs in an open field, where
the received signal is a vector sum of a direct line-of-sight signal and a signal from the same source that is reflected off the earth. Later we discuss the
relationship between signal strength and range in line-of-sight and open field topographies.
The range of line-of-sight signals, when there are no reflections from the earth or ionosphere, is a function of the dispersion of the waves from the
transmitter antenna. In this free-space case the signal strength decreases in inverse proportion to the distance away from the transmitter antenna.
When the radiated power is known, the field strength is given by equation (5.1):
where Pt is the transmitted power, Gt is the antenna gain, and d is the distance. When Pt is in watts and d is in meters, E is volts/meter. To find the
power at the receiver (Pr) when the power into the transmitter antenna is known, use (5.2):
Gt and Gr are the transmitter and receiver antenna gains, and is the wavelength.
Range can be calculated on this basis at high UHF and microwave frequencies when high-gain antennas are used, located many wavelengths above
the ground. Signal strength between the earth and a satellite, and between satellites, also follows the inverse distance law, but this case isn't in the
category of short-range communication! At microwave frequencies, signal strength is also reduced by atmospheric absorption caused by water vapor
and other gases that constitute the air.
Open Field Propagation
Although the formulas in the previous section are useful in some circumstances, the actual range of a VHF or UHF signal is affected by reflections from
the ground and surrounding objects. The path lengths of the reflected signals differ from that of the line-of-sight signal, so the receiver sees a combined
signal with components having different amplitudes and phases.
The reflection causes a phase reversal. A reflected signal having a path length exceeding the line-of-sight distance by exactly the signal wavelength or
a multiple of it will almost cancel completely the desired signal ("almost" because its amplitude will be slightly less than the direct signal amplitude). On
the other hand, if the path length of the reflected signal differs exactly by an odd multiple of half the wavelength, the total signal will be strengthened by
"almost" two times the free space direct signal.
In an open field with fl at terrain there will be no reflections except the unavoidable one from the ground. It is instructive and useful to examine in depth
the field strength versus distance in this case. The mathematical details are given in the Mathcad worksheet "Open Field Range."
In Figure 5.1 we see transmitter and receiver antennas separated by distance dand situated at heights h1 and h2. Using trigonometry, we can find the
line of sight and reflected signal path lengths d 1 and d2. Just as in optics, the angle of incidence equals the angle of reflection . We get the relative
strength of the direct signal and reflected signal using the inverse path length relationship. If the ground were a perfect mirror, the relative reflected
signal strength would exactly equal the inverse of d2. In this case, the reflected signal phase would shift 180 degrees at the point of reflection.
However, the ground is not a perfect reflector. Its characteristics as a reflector depend on its conductivity, permittivity, the polarization of the signal, and
its angle of incidence.
where h1 and h2 are the transmitting and receiving antenna heights above ground and is the wavelength, all in the same units as the distance d m. In
plotting Figure 5.2, we assumed horizontal polarization. Both antenna heights, h 1 and h2, are 3 meters. When vertical polarization is used, the extreme
local variations of signal strengths up to around 50 meters are reduced because the ground reflection coefficient is less at larger reflection angles.
However, for both polarizations, the inverse square law comes into effect at approximately the same distance. This distance in Figure 5.2 where is 1
meter is, from equation (5.3): dm _ (12 _ 3 _ 3)/ _ 108 meters. In Figure 5.2 we see that this is approximately the distance where the open-field field
strength falls below the free-space field strength.
Part 2 will cover Multipath Phenomena
Part 3 will cover Diversity Techniques
References
Gibson, J. D. (ed.), The Mobile Communications Handbook, CRC Press, Inc., 1996.
Rappaport, T. S., Wireless Communications, Principles and Practice, Prentice Hall, Upper Saddle River, NJ, 1996.
Spix, G. J., "Maxwell's Electromagnetic Field Equations," unpublished tutorial, copyright 1995 (http://www.connectos.com/spix/rd/gj/nme/maxwell.htm).