TSB WK PDF

Download as pdf or txt
Download as pdf or txt
You are on page 1of 4

NUMBER:

GROUP:
DATE:

21-016-05
Transmission
September 01, 2005

This bulletin is supplied as technical information only and is not an authorization for repair. No part of this publication may be reproduced, stored in a retrieval system,
or transmitted, in any form or by any means, electronic, mechanical, photocopying, or otherwise, without written permission of DaimlerChrysler Corporation.

THIS BULLETIN IS BEING PROVIDED IN ADVANCE. DO NOT ORDER PARTS OR


PERFORM ANY ACTIONS RELATED TO THIS BULLETIN UNTIL SEPTEMBER 09,
2005.
SUBJECT:
RFE Transmission - Delayed Engagement After An Extended Off Period
OVERVIEW:
This bulletin involves verifying the build date of the transmission, and if necessary,
replacement of the transmission cooler return filter inside the transmission.
MODELS:
2005 - 2006

(DR)

Ram Truck

2005 - 2006

(HB)

Durango

2005 - 2006

(KJ)

Liberty / Cherokee

2005 - 2006

(ND)

Dakota

2005 - 2006

(WK / WH)

Grand Cherokee

2006

(XK)

Commander

NOTE: This bulletin applies to vehicles equipped with the a 45RFE or a 545RFE
automatic transmission (sales code DG4 or DGQ respectively).
SYMPTOM/CONDITION:
The customer may experience an initial delayed shift engagement following an extended
off (not running) period of time, generally after being parked overnight. The initial shift
engagement may feel like a delay or slip when a transmission gear (reverse or drive) is
first selected after engine start.
The customer may also experience a MIL illumination. Investigation may determine that
the MIL is due to one or more of the following Diagnostic Trouble Codes (DTC's):
P0868 - Line Pressure Low. This DTC will be the most frequently occurring DTC for
the delayed shift condition.
P0731 - Gear Ratio Error In 1st.
P0736 - Gear Ratio Error In Reverse.
P0841 - LR Pressure Switch Rationality.

21-016-05

-2-

P0876 - UD Pressure Switch Rationality.


P0944 - Loss Of Hydraulic Pump Prime.
The condition may be caused by a suspect cooler return filter with a part number of
04799662AB. The suspect cooler return filter may allow transmission fluid to drain back
out of the torque converter when the engine is not running.
DIAGNOSIS:
1. Turn the ignition to the OFF position.
2. Raise the vehicle on a suitable lift.

Fig. 1 TRANS IDENTIFICATION NUMBER


1 - TRANSMISSION IDENTIFICATION (SERIAL AND PART) NUMBER - 20 DIGIT

3. Inspect for the transmission build date (Julian date) (Fig. 1). The transmission build
date can be determined by inspection of the 20 digit transmission identification number
(DDDYxxxxxPpartnumber). The transmission identification number is stamped on the
left side (driver side) of the transmission oil pan flange. The first four (4) digits of the
transmission identification number are the transmission build date, in Julian date
format. An example of a transmission identification number would be :
101510492P52119684AA. The first three digits ( 101 ) of the identification number
equal the day of the year, in this case 101 equals April 11. The fourth digit ( 5 ) of the
identification number equals the calendar year, in this case 5 equals 2005. So 1015
equals April 11, 2005.
4. Determine if the vehicle's transmission was built on or between one of the two sets of
Julian date build ranges listed below:
a. Julian date 0425 (February 11, 2005) to Julian date 0455 (February 15, 2005). 0425
to 0455.
b. Julian date 1015 (April 11, 2005) to Julian date 2345 (August 22, 2005). 1015 to
2345.

-3-

21-016-05

5. If the vehicle has the above condition, and if the transmission Julian build date is on or
between the range of dates listed above, perform the Repair Procedure.
PARTS REQUIRED:
NOTE: The correct cooler return filter will not be available until September 09, 2005.
Qty.

Part No.

Description

04799662

Filter, Cooler Return

05013457AA

Fluid, Automatic Transmission, MS-9602


ATF+4, Quart

05010884AA

Mopar ATF-RTV

NOTE: DO NOT use a replacement cooler return filter with a part number of
04799662AB. This filter is suspect of causing the above condition. The filter
part number is stenciled on the side of the filter case.
SPECIAL TOOLS/EQUIPMENT REQUIRED:
8321

Oil Filter Wrench

REPAIR PROCEDURE:

Fig. 2 Transmission Filters - 4X4 Shown


1 - PRIMARY OIL FILTER
2 - COOLER RETURN FILTER
3 - COOLER RETURN FILTER BYPASS VALVE
4 - VALVE BODY

21-016-05

-4-

NOTE: All cooler return filters with the AB suffix (04799662AB) are suspect. The
above condition may be corrected by replacing a suspect AB filter with a
new cooler return filter whose part number is 04799662 (with no suffix or with
a suffix that is other than the AB level).
NOTE: A replacement 04799662 cooler return filter may come packaged with a
separate threaded adapter stud. The threaded adapter stud is used to attach
the cooler return filter to the transmission. Inspect the stud and note end
without threads. Install the stud end without the threads into the cooler
return filter and tighten the stud-to-filter connection to 18.6 Nm (165 in. lbs.).
Once the threaded adapter stud has been installed to the cooler return filter,
install the assembled cooler return filter to the transmission and tighten the
filter to 14.1 Nm (125 in. lbs.)
Use the procedures outlined in TechCONNECT ( Service Information Tab / 21 Transmission Transaxle / Automatic - 45RFE 545RFE / Fluid / Standard Procedure / Fluid
and Filter Replacement) to replace the cooler return filter.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
Labor Operation
No:

Description

Amount

21-55-02-90

Filter, Cooler Return - Replace

0.6 Hrs.

21-55-02-60

Optional Equipment: Skid Plate Equipped


(2005-2006 KJ / 2005 ND / 2005-2006 WK WH)

0.2 Hrs.

FAILURE CODE:
P8

New Part

You might also like