1 3 1 A Vex Solarhydrogensystem Plain

Activity 1.3.
1 Solar Hydrogen System VEX

This activity was written to be used with the Heliocentris
fuel cell. If you are using the fuel cells from a different
manufacturer, refer to that manufacturers instructions to
be sure that the equipment is used as designed.
1. Read the Fuel Cell User Guide.

2. Follow the directions in the Fuel Cell User Guide
under the section Preparing the Fuel Cell for Use.
Circuit Schematics
3. Shine a bright light source on the solar panel, always

keeping at least 8 inches of separation between the
two to avoid melting the solar module plastic.
Set your multimeter to measure voltage and connect
the multimeter test leads to the solar panel
terminals. Move the solar panel or light source to
determine the location that produces the highest
voltage value. You may want to mark the positions
with some tape. Record the open-circuit voltage.
Note the current is zero, since a voltmeter has nearly
infinite resistance.
VOC = Open-Circuit Voltage ____1.54______
Power = VOC x 0 A = 0 W
2012 Project Lead The Way, Inc.

POE Activity 1.3.1 Solar Hydrogen System VEX Page 1
4. With the test leads disconnected, set your

multimeter to measure current. Return the solar
module to the same exact position that produced the
highest voltage value and measure the current.
Record this short-circuit current. Note that the
voltage is zero, since an ammeter has nearly zero
resistance.
ISC = Short-Circuit Current ___111mA_______
Power = 0 V x ISC = 0 W
5. Calculate the amount of power that would be produced by the solar module if it could simultaneously produce the voltage and
current you measured in the previous two steps.
For this illumination level, the solar module will deliver, at most, about 70% of this theoretical maximum, and will do so at a
resistance between zero and infinite resistance.
Maximum Theoretical Power = VOC x ISC = __.17094_____
6. Attach the solar panel to the solar hydrogen
automobile. Using a standoff or another suitable
method, prop up one end of the chassis so that the
motor-driven wheel is not in contact with the ground.
Connect the motor leads to the solar module using
the breadboard to make the connections. Position
the light source to produce maximum voltage leaving
a minimum distance of 8 inches between solar
module and the lamp. Is there enough power to turn
the motor? If so, is there enough power to turn the
motor with the wheels on the ground?
__yes_______
7. Set your multimeter to measure voltage. Connect the
multimeter test leads to the solar module terminals.
Record the load voltage value.(Drive gear should be
engaged)
V = Load Voltage ____1.51______
8. Disconnect the test leads and set your multimeter to
measure current. Connect the multimeter in series
with the solar module. Record the load current.
I = Load Current = ___1_______
9. Calculate the power delivered by the solar module when it is loaded by the motor with the wheels off the ground.
P = Load Power = I V = ____.01w______ for solar module.
10. Energize the fuel cell by using one of the power sources according to the directions in the Fuel Cell User Guide under the
section Powering the Fuel Cell (Electrolysis).
Fuel cells can be damaged by high current. If using a DC power supply with the Heliocentris fuel cell, do not use more than 500 mA.
Do not use a battery to energize the fuel cell.
11. After the fuel cell is energized, attach the fuel cell to the motor using the breadboard to make the connections. Is there enough
power to turn the motor? If so, is there enough power to turn the motor with the wheels on the ground? __yes____
12. With the test leads disconnected, set the multimeter
to measure voltage. Connect the multimeter test
leads to the fuel cell terminals. Record the voltage
value.
V = Load Voltage ____1.49______
to measure 10 A current, using the 10 A meter
receptacle. Connect the test leads in series with the
fuel cell.
Caution! Never measure current from the fuel cell
without a resistor, motor, or other load in series with
the ammeter. Doing so can permanently damage

the fuel cell.
Record the current value.
Load Current = _____114_____
14. Calculate the power delivered by the fuel cell.
P = Load Power = I V = ____.00736______ for fuel cell.
15. Remove the fuel cell and solar module and attach the two AAA battery holders to your vehicle using zip ties. Using the
breadboard, connect the batteries in series with each other and with the motor. (See next step for wiring hints.) Is there enough
power to turn the motor? If so, is there enough power to turn the motor with the wheels on the ground? __yes____

leads to the motor terminals. Record the voltage
value.
V = Load Voltage ____4.9v______
motor terminals. Record the current value.
Load Current = ___96.7mA_______
18. Calculate the power delivered by the batteries in

series.
P = Load Power = I V = ___596w_______ for
batteries in series
19. Using the breadboard, connect the batteries in parallel with each other and with the motor. Is there enough power to turn the
motor? If so, is there enough power to turn the motor with the wheels on the ground? __yes____
leads to the motor terminals. Record the voltage
value.
V = Load Voltage ___5.6v_______
motor terminals. Record the current value.
Load Current = ___120.2mA_______
22. Calculate the power delivered by the batteries in

parallel.
P = Load Power = I V = ___.598w_______ for batteries
in parallel
Conclusion
1 Using the measurements you made, compare and relate the four options you explored. Was the car best powered by a single
fuel cell, a single solar module, two AAA batteries in series, or two AAA batteries in parallel?
AAA batteries
2 Did voltage, current, or power best describe the suitability of a power source?
Power
23. If you had many solar modules, how many of them would be needed to get the same performance from the car as the
performance observed with two AAA batteries? Describe or sketch how would you connect the solar modules in terms of parallel
and series circuits.
5 solar modules
24. If you had many fuel cells, how many of them would be needed to get the same performance from the car as the performance
observed with two AAA batteries? Describe or sketch how would you connect the fuel cells in terms of parallel and series circuits.
6 fuel cells
25. Describe and defend a system that you believe would best utilize a solar hydrogen system to meet the needs for an average
driver.
A solar panel because you can save money and keep the earth cleaner.
26. How does a photovoltaic cell work? Record the source of your information.
When exposed to the sunlight many of the photons are reflected or absorbed by the solar cell. When enough photons are
absorbed electrons are freed from the negative semiconductor material. Solarenergy.net

27. Detail how electrolysis separates hydrogen and oxygen. How is electricity produced as the fuel cell allows the hydrogen to
reunite in a bond with oxygen? Record the source of your information.
Electrolysis is where an electrical current can be used to separate water into componets of oxygen and hydrogen.Hydrogen is
broken down into protons and elctrons and makes a chemical reaction with oxygen producing electricity.


1 3 1 A Vex Solarhydrogensystem Plain

Uploaded by

Copyright:

Available Formats

1 3 1 A Vex Solarhydrogensystem Plain

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

1 3 1 A Vex Solarhydrogensystem Plain

Uploaded by

Copyright:

Available Formats

What are the steps to set up a solar hydrogen system?

What factors determine the power output of a solar panel?

Activity 1.3.

1 Solar Hydrogen System VEX

1. Read the Fuel Cell User Guide.

3. Shine a bright light source on the solar panel, always

2012 Project Lead The Way, Inc.

4. With the test leads disconnected, set your

the ammeter. Doing so can permanently damage

16. With the test leads disconnected, set the multimeter

18. Calculate the power delivered by the batteries in

22. Calculate the power delivered by the batteries in

2012 Project Lead The Way, Inc.

2012 Project Lead The Way, Inc.

You might also like