Mona Molaasgari’s Post

Featured in everything RF.... Quantic PMI (Planar Monolithics) Model PEAFS3-14-0R2535R0-6R5-23-12-292MF is a 8 to 18 GHz low noise amplifier that provides over 13 dB gain with a gain flatness of ±1 dB maximum; noise figure of <5 dB; OP1dB of 24 dB minimum; VSWR IN/OUT of 2.0:1; and removable SMA connectors. This amplifier is supplied in housing that is 0.53" x 0.70" x 0.26" and can be used as a connectorized or a surface mount component. https://lnkd.in/eknyRzew #rf #rfengineering #microwave

Highlighted in Microwave Product Digest's On-The-Market...The GMDA-D1004 Extended Dynamic Range DLVA from Quantic PMI (Planar Monolithics) operates from 2 to 18 GHz and employs planar diode detectors and integrated video circuitry. Offers -60 to +7 dBm dynamic range, TSS of -65 dBm, log linearity of ±1.5 dB & log slope of +25±1 mV/dB. The housing measures 3.5 x 3.2 x 0.5 in. and has female SMA connectors. https://lnkd.in/eDM7fU_f #RF #RFengineering #microwave #technology

Featured on the front cover of the February issue of Microwave Product Digest ... Quantic PMI (Planar Monolithics) Model PEC-30-0R5G50G-22-12-24FF is an Ultra-Broadband Low Noise Amplifier that operates over the 0.5 to 50.0 GHz, which provides a typical gain of 30 dB while maintaining a ±2.5 dB flatness with a noise figure of 9 dB maximum. This model offers a small 1.37" x 1.00" x 0.60" package with removable 2.4mm female connectors. https://lnkd.in/ey5eWFPV #rf #rfengineering #microwave #quantic

#LTC5549IUDB#TRMPBF The LTC®5549 is a general purpose passive double- balanced mixer that can be used for upconversion or downconversion. The RF port is designed for the 2GHz to 14GHz band and the IF port is optimized for 500MHz to 6GHz operation. An integrated LO buffer amplifier supports LO frequencies from 1GHz to 12GHz, requiring only 0dBm LO power. The LTC5549 delivers high IIP3 and input P1dB with low power consumption. An internal LO frequency doubler can be enabled by a CMOS-compatible digital control pin, allowing operation with a lower, one-half LO input frequency. This allows the mixer’s LO port to be used with existing synthesizers, such as the LTC6946 and LTC6948 family. The LTC5549’s high level of integration minimizes the total solution cost, board space and system level variation with its 2mm × 3mm package size. Microwave Transceivers n Wireless Backhaul Point-to-Point Microwave n Phased-Array Antennas C, X and Ku Band RADAR n Test Equipment Satellite MODEMs

The LNA11202131SS is a multi-stage, modular low-noise amplifier designed to operate across frequencies ranging from 21 GHz to 31 GHz. It delivers a gain of up to 34 dB with a noise figure of 2.5 dB, powered by a single supply voltage between 7 V and 40 V. This LNA features an enable/disable function, along with integrated current and temperature sensors for remote fault diagnostics. The unit is housed in a fully enclosed casing, equipped with 2.92 mm RF connectors and a D-Sub interface for DC power, enable control, and sensor connections for current and temperature monitoring. Download the datasheet here https://lnkd.in/esBy_ynU #LNA #ReliaSat #LowNoiseAmplifier

**NR evolution and the path to 6G** Summary of General Enhancements to NR (Release 19) Release 19 continues the trend of building upon features from previous releases with incremental but significant improvements. Key enhancements include: Multi-antenna Transmission: Ongoing evolution with larger array sizes to improve coverage, particularly in higher frequency ranges (FR2 and upper FR1). Hybrid beamforming is commonly used to manage the complexity of numerous radio chains and AD/DA converters. CSI Reporting: Enhancements to handle the challenge of obtaining Channel State Information with a large number of antenna elements. Beam Management: Increased antenna elements in FR2 lead to more beams. Improved beam management helps in quickly establishing connections on higher frequency bands, thus offloading traffic from lower-frequency bands. Dynamic handling of SRS and mechanisms to manage a higher number of beams using DCI are also important. Multi-TRP Enhancements: Including antenna calibration and coherent joint transmission. Mobility Improvements: Building on L1/L2-triggered mobility introduced in Release 18, with a focus on inter-gNB L1/L2-triggered mobility in Release 19. Uplink Performance: Targeting enhancements such as PRACH beam sweeping with beam indication for msg3, which was identified as important but not specified in Release 18 due to time constraints.

Wednesday, October 23, 2024, from 2:00 PM – 2:30 PM ET features the #EDICONOnline webinar, “Critical #Radar Transmitter Measurements Ensure Range Maximization." High-power transmitters in radar and EW systems often use solid state power #amplifiers (SSPA) for improved reliability, efficiency, reduced size, and lower cost of ownership. However, GaN SSPAs can exhibit characteristics in long-pulse radar that, if uncorrected, can impact radar target range performance. Presented by Bob Buxton, Product Manager at Maury Microwave, this webinar will review radar transmitter technology, critical pulse characterization measurements, the impact of performance-limiting pulse fidelity degradations on radar range, and important pulse profile corrections to meet design objectives. Register now to learn how to maximize the range of your radar transmitter: https://hubs.la/Q02T7lTj0 #TestAndMeasurement #PowerAmplifiers #PeakPowerSensors

Featured in Microwave Product Digest's On-The-Market... Quantic PMI (Planar Monolithics) Model PS-500M2G-10B-SFF-MIL-SM is a 0.5 to 2 GHz digitally controlled phase shifter with capability for phase shifting from 0º to 360º with an insertion loss of 8 dB; amplitude error of ±0.06 dB; phase shift error 0.3°; switching speed of 500 ns and spurious of -60 dBc. https://lnkd.in/erXcu2U2 #RF #rfengineering #microwave

Highlighted on everything RF... The P1T-DC40G-65-T-292FF-1NS-OPT18G from Quantic PMI (Planar Monolithics) is an Absorptive SPST PIN Diode Switch that operates from DC to 18 GHz. It has a switching time of <6 ns and provides >55 dB of isolation. This switch can handle an input power of up to 17 dBm, has an insertion loss of <5 dB and a VSWR of 2.0:1. It requires a DC supply from -8 to -15 V and +8 to +15 V and consumes less than 40 mA of current. The switch is available in a module that measures 1.2" x 1.3" x 0.5" with field-replaceable SMA-female connectors and has a TTL-compatible driver for easy system integration. It meets the MIL-STD-202F standard for humidity, shock, vibration, altitude, and temperature cycle. https://lnkd.in/e_NExDJB #RF #rfengineering #microwave

Look what's new at Quantic PMI (Planar Monolithics)... Model P2T-3040-60-R-292FF-RC is a single pole, two throw pin diode switch that operates over the 30 to 40 GHz frequency range. Specifications include isolation 60 dB minimum; insertion loss 3.5 dB maximum @ 25 ºC, 4 dB maximum over temperature; VSWR 2.0:1; switching speed 100 ns; and RF power handling +20 dBm. This model incorporates a TTL compatible driver for easy system integration. Housing size is 1.20" x 0.95" x 0.46" with 2.92mm female connectors. https://lnkd.in/eX7sG67B #RF #RFengineering #microwave