… a potential amplitude of ±10 mV in the frequency interval from 0.1 to 10 5 Hz. The potentiodynamic
polarisation test was implemented at a potential scan rate of 1 mV s −1 in the anodic …

… potential amplitude of ±10 mV in the frequency interval from 0.1 to 10 5 Hz. Polarization tests
were started immediately after receiving the EIS data at a potential scan rate of 1 mV s −1 in …

… mV, SCE), while repassivation is hampered (Erp52330 mV, … value is still relatively low (Epit5220
mV, SCE). Repassivation in … is only ,35 mV compared with ,250 mV in chloride solution. …

The present work is focused on the cobalt electrodeposition in anodic aluminium oxide and
the application of the obtained nanocomposite layer as a monolithic catalyst for complete …

… EIS tests were performed at an open-circuit potential with an amplitude of 10 mV in a …
Ag/AgCl at a scan rate of 1 mV s−1. CV with scan rates from 0.01 to 1.0 V was employed to …

… EIS tests were conducted at an open circuit potential with an amplitude of 10 mV in a
frequency range from 10 5 to 10 −2 Hz. Cyclic voltammetry (CV) was employed to determine the …

… Cyclic potentiodynamic polarisation measurements were performed with a potential scan
rate 1 mV s − 1 , starting from the potential − 0·7 V(SCE) followed by anodic polarisation. After …

… The scan rate of the potential was 60 mV min - 1. Prior to the beginning of the polarisation
the samples were kept in the solution for 15 min in order to establish the free corrosion …

… in a relatively narrow range that does not exceed 15-20 mV. The corrosion potentials of
nickel steel are about 250 mV more positive than those of the other two chromium–manganese …

… For chromium-nitrogen steel a sharp initial increase about 400 mV of the potential is typical.
This … Thus determined values of the slope in mV per second for two stainless steels are …