Brand NEW set of custom Dana 60 High Pinion Currie RockJock 60's that were on a roller project that was never finished.
(first pic is not these axles, just a jeep pic from Currie website)
NO TEXTING!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! too many bots
Specs:
-Complete Currie 60 High-Pinion RockJock Front and Rear Axles with Disc Brakes, line fittings and Internal Parking Brake
-Passenger side Drop/front pumpkin -1350 Pinion Yolks
-60.
25 in.
Width WMS to WMS and 5 x 5.
5 bolt pattern
-High-Pinion Design Raises the Driveshaft by 2-Inches to Reduce Driveline Angle and Improve Clearance
-ARB air lockers, 4:33 gears
-Crane interlocking Flat top knuckle and kingpin inner C's kit (front axle)
-GM 1-Ton ball joints on Tie Rod with Y-Link steering, and steering link (also GM 1-ton joints)
-Rock Slider Low-Friction Skid Plate Sides Over Trail Obstacles with Ease
-Currie 35-spline Semi-Float Axles
3 in.
Diameter x .
5 in.
Wall DOM Axle Tubes
I WILL NOT SEPERATE these, please do not ask.
I have over $10K just in the front axle, not to mention another $5K for the matching rear.
There's more than enough $$ savings for you to change both ring/pinion gearsets/gear ratios for your large tire build and still come out thousands $$ ahead! These currently have leaf spring perches on them, so they're essentially a blank canvas for whatever linked or sprung setup you're building.
Barnes 4x4 has all the ready to weld on mounts if you have Jeep suspension.
I might be able to deliver them, depends on timing and location.
Please call me, no low balls, and yes, they're available so I will only respond to specific questions.
Knuckles on front axle are painted Chevy Orange, I will paint these satin black to match the housing before I ship them.
Axle set is located in North/east F 32136
Whatsapp
